How to clean the battery of an electric vehicle? How to clean an electric car when it is dirty?

Electric vehicle batteries cannot be washed with water, so you can wipe off dirt from the battery case with a damp rag that wrung out the water with a little hand sanitizer or dishwashing detergent.

You should use a dry rag to wipe the dust on the surface of the electric car battery, and wipe it off with a damp rag.

If it's dirty, wipe it with a damp cloth, and you can clean it.

Tools Required Materials:

1. Brush. 2. Dry rags.

3. Basins. 4. Water and hot water.

5. Sandpaper. Cleaning Steps:

1. First of all, remove the battery, dry it completely with water, and then install the battery, because although the battery has a waterproof function, it will also reduce the life if it is often blistered.

2. To clean the electric vehicle battery, before cleaning, we must first check whether the battery shell has leakage of electrolyte, there is no leakage, we can use hot water to scrub the rust oxide on the surface of the battery and the battery pole.

3. After the battery is dry, it is best to use sandpaper to polish the rust on the pole and the joint, and tighten the fixing screws on the joint to ensure that the circuit is in good contact.

4. After cleaning the battery, use a transparent beverage bottle of water, and fill it with a small amount of dish soap, and shake it evenly into a homemade cleaning agent. Prick a few holes in the lid of the beverage bottle and squeeze the detergent to the point where it needs to be cleaned with focus.

5. Prepare a brush (it is best to choose a harder one) and prepare a dry cloth.

6. Wash from top to bottom, first squeeze the water in the mineral water bottle to the part to be washed by hand, and then brush with a brush, repeat this, even if the dead corner brush is put in to brush, wipe it with a dry cloth after washing.

7. When scrubbing the electric vehicle, remember not to splash water on the electric vehicle wherever there is an electric vehicle circuit. If the circuit interface in the electric vehicle is wet, it may cause a short circuit and damage the electric vehicle.

8. The place that can't be wiped off can be washed with the long-bristled brush of the wine bottle, don't wash it with water, the controller and electrical appliances are afraid of water, although they have waterproof functions, but they are afraid that they can't withstand the strong impact of water.

In daily life, electric vehicles are our main means of transportation, we often use electric vehicles, electric vehicles will be stained with a lot of dust and mud, if you want to clean and maintain, we have a few steps to clean electric vehicles, and it is very convenient and effective.

How it works: 01 When our electric car falls dusty, we have to scrub frequently, when we scrub the electric car, do not splash water on the electric vehicle, because there are many circuits in the electric car, if the circuit is wet, it will affect the use of the electric vehicle. There is a possibility of damage to the electric car.

02 If the water source at our home is not convenient, we can push the electric car to the nearby river or pond, it is best to bring a basin and rag when we go, park the car on the path by the river, and then use the basin to scrub the electric car.

03 When we clean the electric car, we should use a rag to wring it out and slowly scrub the electric car, we can first use a wet rag to wring it out and scrub the whole body of the electric car on one side, change a few more basins of water in the dirty places, and be patient to scrub slowly, 04 When we clean the electric car, we should pay special attention not to wet the circuit of the electric car, as long as there is a circuit where we had better not get wet, we also have to clean the wheels, because the metal ring of the tire is easy to rust after a long time of dust, Especially after rain, the metal is covered with a thick layer of soil, which is not conducive to the evaporation of water. It's best to clean the dirt on it to avoid rust.

05 Especially in the lower part of the electric vehicle, there is a lot of dust and mud, we have to use a rag to slowly soften the lumpy mud and dust, and then remove the mud and dust, be careful not to damage the parts of the electric vehicle, do not use a sharp weapon to poke and scrape the dust on the electric vehicle, and use a rag with water to slowly scrub.

06 Our electric car should be regularly pushed to the department responsible for the warranty of the electric vehicle for warranty, it is best not to go when it rains, because in rainy days, it is easy for our electric vehicles to enter the mud and sand, if our electric vehicles are oiled and then walk in the rain, the sand is easy to enter our cars, and it is easy to damage the bearings of our electric vehicles. Therefore, we should be careful when riding electric vehicles, but we should also pay attention to maintenance.

How to clean an electric vehicle.

When our electric car has dust, we have to scrub frequently, when we scrub the electric car, do not splash water on the electric car, because there are many circuits in the electric car, if the circuit is wet, it will affect the use of the electric car. There is a possibility of damage to the electric car.

If we don't have a convenient water source at home, we can push the electric car to a nearby river or pond, and it is best to bring a basin and rag when we go, park the car on the path by the river, and then use the basin to scrub the electric car.

When we clean the electric car, we should use a rag to wring out the electric car half dry and slowly scrub the electric car, we can first use a wet rag to wring out the whole body of the electric car on the side, change a few more basins of water in the dirty places, and be patient to scrub slowly, we should pay special attention not to wet the circuit of the electric car when cleaning the electric car, as long as there is a circuit where we had better not get wet, we also have to clean the wheels, because the metal ring of the tire is easy to rust if it is stained with dust for a long time, especially after rainThe metal is coated with a thick layer of soil, which is not conducive to the evaporation of water. It is best to clean the dirt on it to avoid rust.

Especially in the lower part of the electric vehicle, there is a lot of dust and mud, we have to use a rag to slowly soften the lumpy mud and dust, and then remove the mud and dust, pay attention not to damage the parts of the electric vehicle, do not use a sharp weapon to poke, scrape the dust on the electric vehicle, and use a rag with water to slowly scrub.

Our electric car should be regularly pushed to the department responsible for the warranty of the electric vehicle for warranty, it is best not to go when it rains, because in rainy days, it is easy for our electric car to enter the mud and sand, if our electric car is after oiling, and then walking in the rain, the sand is easy to enter our car and easily damage the bearings of our electric car.

1. Before using the electric vehicle, attention should be paid to check whether the vehicle condition is good, such as whether the tire pressure is sufficient, whether the front and rear brakes are sensitive, whether the vehicle has abnormal noise, whether the screws are loose, and whether the battery is sufficient.

2. When the vehicle is just started, it should be accelerated slowly to avoid instantaneous rapid acceleration and damage to components. In order to prolong the life of the battery and motor, foot pedal assistance is applied when the vehicle is starting and climbing.

3. On the premise of ensuring safety, frequent braking and starting should be minimized during driving to save electric energy. When braking during driving, the speed regulating lever should be released to avoid damage to the motor and other parts. When getting off the car to push, the power should be turned off to prevent an accident when the car starts suddenly due to the unintentional rotation of the speed control handle.

Method steps.

1 6 Step by Step Reading.

1. Do not splash water on the electric vehicle when scrubbing. When the electric vehicle falls dusty, we must scrub frequently, when we scrub the electric vehicle, do not splash water on the electric vehicle, because there are many circuits in the electric vehicle, if the circuit is wet, it will affect the use of the electric vehicle, and it may damage the electric vehicle;

2 62. If the water source at home is not convenient, we can push the electric car to the nearby river or pond for cleaning. When you go, it is best to bring a basin and a rag, park the car on the path by the river, and then use the basin to scrub the electric car;

3 63. When cleaning the electric vehicle, it is necessary to use a rag to wring it semi-dry and slowly scrub the electric vehicle. We can first wring out with a damp rag and then scrub the whole body of the electric car aside, change a few more basins of water in the dirty places, and be patient to scrub slowly;

4 64. When cleaning an electric vehicle, special attention should be paid not to wet the circuit of the electric vehicle. As long as there is a circuit, we had better not get wet, and we also have to clean the wheels, because the metal ring of the tire is easy to rust if it is stained with dust for a long time, especially after rain, the metal is wrapped with a thick layer of soil, which is not conducive to the evaporation of water. It's best to clean the dirt on it to avoid rust.

5 65. When cleaning the electric vehicle, do not poke or scrape the dust on the electric vehicle with a sharp weapon. Especially in the lower part of the electric vehicle, there is a lot of dust and mud, we have to use a rag to slowly soften the lumpy mud and dust, and then remove the mud and dust, pay attention not to damage the parts of the electric vehicle, do not use a sharp weapon to poke, scrape the dust on the electric vehicle, and use a rag with water to slowly scrub.

6 66. Electric vehicles should be regularly pushed to the department responsible for the warranty of electric vehicles for warranty. It's best not to go when it's rainy, because in rainy days, it's easy to get into the mud and sand in our electric car, and if our electric car is after oiling, and then walking in the rain, the sand is easy to get into our car and easily damage the bearings of our electric car.

Precautions. 1. Riding a smart electric vehicle should pay attention to the road conditions and exercise safely in accordance with traffic rules.

2. When riding a smart electric vehicle, you must check the car when you go out.

1. Remove dust: first use a duster to remove the dust on the surface of the car. Because after long-term use, there will be particles on the surface of the vehicle, and wiping it directly with a rag will damage the paint surface and affect the appearance.

If possible, you can also rinse with a water gun at low pressure, but when flushing, you should flush from top to bottom, and avoid important electrical parts such as battery compartment, motor shaft, controller, etc., to avoid unnecessary trouble.

2. Use neutral detergent to clean: drop the detergent into the basin filled with clean water, stir and foam, and then throw the rag or car wash sponge into it to wet it, and wipe the whole vehicle, especially the lower part of the electric vehicle. If you encounter dirt that is difficult to clean, you should use a rag to soften it and then remove it, and pay attention not to scrape stubborn stains with sharp objects during the process, so as not to damage the parts of the electric vehicle.

It should be noted that when choosing a detergent, it is necessary to choose a professional vehicle cleaner. If a special vehicle cleaner is not available, it is recommended to clean with a neutral detergent, i.e. a detergent with a pH of 7, such as dish soap. The non-neutral cleaning agent COBIWANG can cause irreversible damage to the surface of the vehicle.

3. Rinse with water: After foaming, we need to rinse the remaining foam on the body with clean water again. It should be noted that the water column of the water gun should be at a certain angle to the body, so that the sewage can flow downward, and the parts that are easy to accumulate dust and dirt should be washed many times.

If the dirt has not been sufficiently removed by this time, use a small amount of water to dilute the neutral detergent, wipe it off, and then use a large amount of water to completely rinse off the detergent.

4. After cleaning, you need to wipe the car dry with a dry rag prepared in advance, and be sure to ensure that there is no residual moisture in key parts such as motor cracks, batteries, and circuits. Before using a dry rag, make sure that the rag is clean and tidy, and there are no stones, wires and other debris, otherwise it will cause serious scratches on the car paint. It should also be noted that several dry rags should be prepared before wiping, and different parts should be wiped with different rags, and "one cloth should wipe the whole car".

In general, prepare 2 rags, 1 for the body and 1 for the wheels, and prevent cross-mixing.