The hardening method of American soil, the preservation method of American soil

American soil can be hardened in the following two ways:

1.Oven drying: American soil is placed in an oven preheated to about 110 125 degrees, usually baked for 10 15 minutes, depending on the size of the object, until it is completely dry and firm.

2.Boiling and hardening: First bring the water to a boil, then put the American soil in a pot and let it boil until the American soil is completely dry and hardened.

For large objects, it may be necessary to cover the skeleton, and pay attention to the thickness should not exceed 2 cm. The skeleton is best made of aluminum wire, iron wire, aluminum foil, heat-resistant soil or materials that are not afraid of water or baking.

It should be noted that American soil cannot be exposed to the air for a long time, and the grease in the soil will volatilize in about half a year, so it is usually sealed and stored in a zipper bag. If it has dried out, it is recommended to rub it in with an oil-based solvent from Tamiya or Gunshi (which can also be used as a clay agent), or use a commercially available sewing oil to infiltrate and mix to soften it. In addition, not all materials can be oven or boiled and hardened, so you can consult the manufacturer of the U.S. soil for the best solution.

1.It should be roasted at about 110 125 degrees (not exceeded) for a different time, usually 10 to 15 minutes, depending on the size.

Preferably a cool-up oven that can be set at a constant temperature.

2.Boiled water should be boiled before putting it in, and a support frame should be placed in the pot.

The time is also determined by the thickness and size (do not leave it in the water for too long) <>

This American soil can not be exposed to the air for a long time, about half a year the soil grease will volatilize, so it usually needs to be sealed and stored in a zipper bag. The solvent is kneaded (it can also be used as a clay agent), followed by the general sewing oil on the market (the effect is not very good), and the mixture is infiltrated to soften it. You can continue to use it.

The thickness should not exceed 2 cm, and large objects should be made by wrapping the skeleton.

It has to go into the oven or boiled to harden.

Therefore, there must be no plastic or prolicolon or cardboard in your skeleton. However, it depends on the situation.

Those who need to be hollow can use styrofoam to make it synergistically (styling will shrink after heating), and it is best to use aluminum wire, iron wire, aluminum foil, and heat-resistant patching soil. Or ingredients that are not afraid of water or baking.

It can be made as a skeleton.

Upstairs misunderstanding Ladoll is resin clay, right?

Ladoll is stone powder clay, which feels like a very delicate paper clay, but because it is much more delicate than paper clay, it is also more beautiful to polish than paper clay.

Ladoll is water-based, hardens when dried, and melts off with water when it is hard.

Ladoll was originally made to save the hassle of making human-shaped firing ceramics by hand. So it's very suitable for being humanoid.

American soil is mainly used in model making, and it can be grilled and hardened at low temperature, hawkers, I haven't used American soil to make a baby, so the specific feel is not very clear.

There are entries for American soil that you can check out.

In fact, resin clay is not easy to use, no matter how clean your hands are, the resin clay will turn yellow when pinched out. The biggest trouble with resin clay is that it is not easy to polish, it is very difficult to grind and smooth, which is compared with oil clay. It is recommended that the American soil does not need to be turned over

Homemade bjd words. The oil sludge is also good. But. Let's play it by yourself or ladoll. Stone powder. Better than clay or something.