How to make the seedlings straighten from bends? Small seedling bending modeling method

You can stick a bamboo next to the seedling, and then tie the seedling to the bamboo with a rope so that the seedling can be straightened.

You can take a stick and tie the seedlings and let the seedlings grow along the stick, so that they can turn from bent to straight.

The curved growth of the seedlings is because of their uneven light receiving, resulting in uneven auxin content in their bodies, auxin is dual, too much will also inhibit, too little will attenuate, so we want the seedlings to receive light evenly, we can remove the higher weeds around the seedlings, and darkened the seedlings in the places where they receive more light, that is, they can be shaded.

At this time, you can find a rope to tie the branches, and the branches will slowly become straight.

The shape of the seedlings can be achieved with the help of wooden sticks, tape, hemp rope, iron wire, copper wire and other tools.

There is a certain difficulty in the bending process of slightly larger branches, we can use iron wire, by using iron wire to wrap the branch to achieve the purpose of bending.

The thickness of the wire needs to be selected according to the diameter of the branch. After wrapping the wire on the branches, the wires are tied together with the branches with tape, and then the bundled branches are bent according to the shape.

After a year and a half, we can remove the wire, and the branches have been shaped to achieve the desired shape.

For branches that are too difficult to bend and shape, we use a knife to cut a small incision where it needs to be bent, so that it can be bent down.

After the bending treatment, we need to use fresh moss or sterile soil to wrap the wound in time, which can speed up the healing of the wound, so that the bend can achieve the desired effect.

If you force bend it without opening, it is likely that the branch will break off, causing unnecessary damage.

Be careful when bending the seedlings, don't break them, and the method of modeling the seedlings is mainly divided into three steps.

The first step, binding, is like a broken bone.

We're going to do bandaging. We need to find a bamboo pole or other support pole first, and slowly straighten and tie up the bent part, so that there will be a tall tree in the later stage, which is a very critical step.

The second step is to hang the branches, so that the branches can grow in the direction we want them to grow.

The third step is to press the branches, which is the opposite of the second step, by pulling down, pressing the branches down and letting them grow in the direction we want.

It's done in three simple steps.