The living room is tiled, the bedroom is covered with laminate flooring, and there is a height diffe

Here the thickness of the floor in your living room is actually in your bathroom, there are regulations in the brick-laying process, that is to say, the floor drain in your bathroom is the lowest point of your home, where the thickness of the cement mortar layer must be kept above the centimeter, which is the foundation. The renovation process of your bathroom must have a slope. In this way, the door of your bathroom is also high, and your hall is positioned on this basis with the amount of cement and sand, which is flat or slightly higher than the door of the bathroom.

After this happens, the laminate flooring you lay will inevitably have a height difference with your tile level. For this reason, relying on doorstones is not the fundamental solution to the problem, and there will be steps when used, even if they are fastened with floor buckles. The height difference is still in (.

Then remind you to do the leveling treatment.

1. Cement mortar leveling treatment, advantages: low, disadvantages: it takes time to dry, wait for the water to evaporate. 2. Special floor mat treatment, advantages: no time difference, disadvantages: high.

There is a seamless under the bedroom door depending on the height of the doorstone. If you don't want the door gap to be too large, you can adjust the size of the door, generally the door will be too large and you need to saw a little lower, at this time, you can consider no sawing or less sawing. If the passage stone is the same height as the tile, and the laminate flooring is used in the inner room, there must be a height difference.

One way is to switch to solid wood flooring, but **high. One method is to polish the side of the door stone so that it is in line with the door and does not affect the opening of the door, and then lay a carpet at the low part of the door of the inner room to find it. FYI.

Normal, the remedy is:

Lay tiled floors, planing off a height of about 3 to 4 cm.

Although this method is not expensive and does not increase the height of the floor, there is a premise that the construction must be carried out without damaging the floor slab. Otherwise, the floor slab will be leaked, or the planing will be thick, and the downstairs neighbor's house will crack, which is more dangerous!

Level the floor with wooden floors.

At present, there are three main methods of ground leveling: gypsum leveling, cement mortar leveling, and self-leveling leveling. Gypsum is suitable for local leveling, cement mortar and self-leveling are suitable for large-area leveling.

If the mortar is leveled, it will increase the thickness of the ground, and I recommend using self-leveling leveling, which has the best effect.

When laying the floor, add a keel or a special foam cushion to raise it.

The disadvantage of cement leveling is not only high cost, but also increases the bearing weight of the floor slab.

Since there is an error, it is better to make the error bigger.

1. In the decoration process, if the floor and tile are used two kinds of ground materials, then the joint between the floor and the tile is a problem that is not easy to deal with. Ceramic tiles must be higher than the floor, the general treatment method is to pave the floor of the room with cement height, this treatment is very simple, is also a relatively simple way, but more expensive and time-consuming, but also increased the height of the ground, so that the indoor height is reduced, change to other ground decoration materials, it is difficult to reduce the height.

2. There is also a way to use a kind of foam board to raise the floor, this product should pay attention to quality, do not buy recycled materials, the taste is very big, not environmentally friendly, on the other hand, it also has an impact on the life of the floor, because the laminate floor is a lock connection, if the floor is soft, long-term stepping will wear the floor lock and reduce the service life of the floor. There is also a simple way to connect with high and low buckles, but this method is not beautiful and stiff, and it is easy to be damaged by long-term pedaling.

With the development of the times, everyone will choose according to their own conditions when decorating, most young people prefer to lay tiles in the living room, and composite wood flooring in the bedroom.

In this case, do I need to fill in cement for leveling? Generally, there will be related problems in decoration, and the room is shorter than the living room to 5 cm. Laying the floor directly will affect the effect, if you feel that it is not good looking or there is a safety hazard.

After all, there are elderly people or children at home, and it is still very inconvenient to walk. <>

Generally, when cement is used to find the floor, the drop will basically be in centimeters. Lay on it to be able to and floor tiles.

Just equal, of course, there are advantages and disadvantages. The disadvantage is that the foot feeling looks harder, and it does feel very bad if the solid wood floor is covered with cement, so when you choose to decorate the floor, you still have to take it according to your actual situation. But if you don't fill the cement, you will still feel suspended when you step on it, and there will be a knocking sound.

In fact, there are many people who prefer wooden flooring, according to the people who have come to say that wooden flooring is not practical at all, or it is not as good as ceramic tiles. It is not easy to buy a house, and I hope you can not be careless about the decoration. In particular, hardware products like this can make a difference in poor operation and can also be harmful.

After all, decorating is not like buying clothes, if you don't like it, you can change it at any time. The decoration is basically to be maintained for decades, and it must be done in one step. When buying materials, you can't be soft-hearted, you must know that you get what you pay for, and if you replace it later, it is more troublesome.

However, according to the decoration experience, cement is the best way to level, and the others cannot be trusted, otherwise it will definitely affect the problem of foot feeling. Of course, in the process of leveling, it is necessary to do a good job of protective film measures, to protect the wall, and only after drying can it be removed, so that it will not hurt the wall. Generally, the master of tiling or the master of wooden flooring should choose a professional and experienced.

They all know what kind of way to ensure that the wood floor will not be hollow, of course, the choice of wood floor should also choose the brand to ensure quality.

Cement leveling is the best method, and nothing else is advisable, otherwise it will affect the foot feeling. At the same time, you can use a protective film to stick it on the wall to protect the wall, and then take it off when it is dry, which will not hurt the wall.

The living room is tiled, and the bedroom is covered with laminate flooring, because there is a height difference, do you need to fill in cement leveling? Of course, you need to find the screen, and if you don't find the screen, it is easy to cause problems in the later stage.

Need. If there is a height difference, it is easy to trip if you don't pay attention, and if there are children or the elderly at home, it is necessary to level it to avoid accidents.

You can start by laying floor tiles in the living room.

The floor level is then leveled with cement and sand.

Before the actual paving, the floor tiles should be tested and paved, and the floor tiles should be directly placed on the adhesive layer according to the requirements of the actual paving, and the rubber hammer should be vibrate. On the one hand, to ensure that the floor tiles are smooth and the gaps are straight, on the other hand, the bonding lamination disaster, if it is not true, it is necessary to fill the mortar, and if it is too much, the excess mortar will be shoveled.

In the actual paving, the rubber hammer should be used to vibrate, the force is even, in order to prevent damage to the floor tiles, check the flatness with a level, and check the smoothness of the brick joints by checking the smoothness of the brick joints, requiring the surface to be smooth, the color is consistent, the brick joints and cross joints are smooth, the joint height is consistent and smooth, and the bonding is dense and firm without hollowing.

Achieve the elevation and design requirements of the finished surface.

If it is a wooden floor, it depends on whether you add a keel The ground is flat enough if the floor tiles are pasted You can not use the keel If the ground is not very flat, you have to add the keel is 2 to 4 cm thick You also need to calculate the thickness of the wooden floor If you paste tiles, you need to lay 3 cm thick cement mortar Calculate the same.

If the floor is flat, wooden floors 1-2 cm, tiles 3-5 cm (including mortar),

If the ground is flat, the floor has 8mm, 12mm, 15mm and other specifications, and the laminate floor is generally 12mm, and the floor tiles are also the height of sand and cement.

Living room 4 meters open, about 25 square meters, if you want to lay floor tiles or choose 800 * 800 porcelain floor tiles better, it looks more coordinated, the height difference is not a matter for professional decoration, you can first lay the living room floor tiles, and then use cement and sand to level the floor height, don't worry about moisture, there is a layer of moisture-proof film under the floor, speaking of these things are not a thing, simple.

1. Now it is more popular to have 800*800 specifications, which are more atmospheric.

2, must be leveled, cement sand can be dried and then paved, if you are not good first, you can first brush a layer of ground paint.

3. There will be a height difference, it is best to make a threshold stone, the height of the high floor tiles, the color of the dark color, which can not only play a role in space segmentation, but also solve the height difference.

I think 600 is good, so it looks like more space! And your home improvement is not tooling, 600 is very suitable! If you are worried about dampness, you can add a moisture-proof mat under the keel when laying the floor! That height difference of yours, it seems that it is difficult to solve!

Summary. Dear, unless it is a special request from the owner, it is abnormal for the bedroom floor to have a height difference with the living room floor, if the gap is not big, you can use the planing method to flatten, the gap is too large to resurface the floor of the bedroom or hall.

Is it normal to have a height difference between the wooden floor in the bedroom and the floor tiles in the living room after the floor is laid? How to remedy it???

Pro, unless it is a special request from the owner, it is abnormal for the floor of the cave to have a height difference between the floor of the cave and the floor of the living room, if the gap is not known as empty, you can use the method of planing to flatten, the gap is too big to be able to resurface the floor of the bedroom or hall.

Is it normal to have a height difference between the wooden floor in the bedroom and the floor tiles in the living room after the floor is laid? How to remedy it??? Can you flatten it with a planer?

Dear, the following provides you with a few ways you can refer to.

Second, the second method is to knock off the screed layer of the ground between the living room and dining room, generally speaking, the screed should also have 2-3 cm, so that there will be no height difference when it is paved and closed. Third, the third method can be pasted the living room tiles first, and then the bedroom with Jinkai cement leveling, deduct the height of the composite floor, after the installation of the height is more consistent, and the cost is relatively provincial, because the floor of the general cracked building will not be very flat, so it can also be leveled by the way of the composite floor. Fourth, the fourth method is that when laying composite flooring in the bedroom, you can use a special foam cushion for cushioning treatment, or use the corresponding material of the wooden keel for leveling, because the quality of the wooden keel is lighter and the construction is simple.

Leveling with cement mortar in the bedroom is not only costly, but also increases the bearing weight of the floor slab, so the height difference can be solved by using wooden keels.