What s the deal with water droplets outside the freezer door of your refrigerator?

Reason 1: Usually when placing food, if you don't put it in the refrigerator when the food cools, then the steam emitted by the food will condense into a large number of water droplets in the refrigerator after it is cold, and then too much condensation, the condensate formation rate is greater than the drainage rate, which will cause water accumulation inside the refrigerator. Workaround:

If the water in the refrigerator is accumulated due to this reason, the water in the refrigerator needs to be cleaned with a rag first, and then when the food is refrigerated and preserved, it is necessary to wait until the food has cooled before putting it in the refrigerator, so as to avoid the occurrence of water accumulation in the refrigerator.

Reason 2: The condensate in the refrigerator is generally discharged through the drainage hole, but once the drainage hole of the refrigerator is blocked, then the condensate can not be discharged out of the refrigerator in time, and the refrigerator refrigerator will have water accumulation. Workaround:

When using the refrigerator, you need to clean the refrigerator compartment frequently, so as to ensure that the refrigerator drain hole will not be blocked by debris. When the refrigerator drain hole is blocked, it can be directly used to dredge it when cleaning it, if the use of thin wire does not work, then open the back cover of the refrigerator, take out the drain pipe of the refrigerator, clean up the debris in the pipe, rinse it with clean water several times and then install it. Of course, you need to clean the stagnant water in the refrigerator before cleaning the drain.

Reason 3: In summer, if the refrigerator is frequently opened and closed, it will cause the hot air in the surrounding environment to enter the refrigerator, and the moisture in the air will also produce water droplets after being cold, and eventually form condensate. Workaround:

When using the refrigerator in summer, it is necessary to minimize the number of times the refrigerator opens and closes the door, and at the same time, the drain pipe and leakage pipe of the refrigerator are often dredged to ensure that the condensate of the refrigerator can flow out of the refrigerator room, so as not to cause water in the refrigerator refrigerator.

There is a problem with the insulation of the refrigerator door, or the refrigerator door door seal is not tightly sealed. Under normal circumstances, the refrigerator will not appear in this situation during use, and it is best to find the refrigerator manufacturer's after-sales service warranty.

Hello dear, what is the matter with water droplets outside the refrigerator freezer door (1) Cause analysis 1, the air temperature in the room is large, the surface temperature of the refrigerator is lower than the saturation temperature of the indoor air, and the indoor air will condense into water droplets when it meets the surface of the refrigerator. Similarly, the higher the humidity of the indoor air, the lower the surface temperature of the refrigerator, and the moisture in the air is more likely to condense into dew or water droplets on the refrigerator. In the southern region of our country, the temperature is high in summer, the temperature is large, especially in the middle and lower reaches of the Yangtze River, every rainy season, the humidity in the high temperature air is greater, and the condensation droplets on the refrigerator are more serious, especially on the front of the refrigerator door, the phenomenon of condensation dripping is more common.

2. The door of the refrigerator is not tightly cracked. 3. If the heating wire of the door seal of the freezer of the frost-free refrigerator is damaged, or the sealing strip of the door crack is damaged, the common thing is that the door seal lacks elasticity and does not fit the door frame. 4. The insulation layer of the refrigerator is too thin or the foaming is not good, if there are water droplets on the top of the refrigerator, half of it has water droplets, and half of it has no water droplets.

There are also many local condensation water droplets on the side of the box, some less, and even a small area of frost on the surface of some refrigerators, which is caused by the poor foaming of the thermal insulation material polyurethane in the box. (2) Exclusion method 1, in the rainy season, many refrigerators will have condensation, which is a normal phenomenon, for this reason, dry it frequently with a soft towel, and after the rainy season, the condensation phenomenon will disappear naturally. Refrigerators with dew removal devices will not condense and drip water.

To reduce condensation and dripping from the refrigerator, use the refrigerator in a ventilated room. 2. Check the original ruler hall where the door gap is not tight, and adjust and repair it. 3. Pass the inspection and replace the heating wire or sealing strip.

4. The refrigerator with poor thermal insulation should be used in a room with low ambient temperature and air circulation, and the temperature control gear of the thermostat should be adjusted a little higher. Hope it helps.

Gas compression refrigerators rely on low-boiling liquid refrigerants, such as Freon R12, to absorb heat to achieve the purpose of refrigeration during vaporization, and then evaporate and compress them with a compressor, and then release them to liquefy them, and then complete the refrigeration cycle. Because the theory, production technology and process of gas compression refrigerators are relatively mature and have a long service life, more than 90% of the refrigerators produced in China are such refrigerators.

There is a problem with the insulation of the refrigerator door or the door seal on the refrigerator door is poorly sealed.

Under normal conditions, the outer surface of the refrigerator will not produce water droplets during use, which is equivalent to touching the outer surface of the refrigerator frozen door at work with your hands, and the temperature will not be very low.

If some parts of the refrigerator door body are poorly sealed or damaged, it will cause excessive water vapor during prolonged use.

Water enters into the door body insulation layer, causes the heat preservation effect of the door body to deteriorate, and the cold amount inside the refrigerator freezer chamber is transmitted to the outside side of the door body along the water ice metal shell of the refrigerator door body, and the water vapor in the air around the door body condenses into water droplets on the outer surface of the door body. If the door seal of the refrigerator freezer door body is deformed and poorly sealed, the cold air in the freezer room leaks out, and the cold energy is transferred to the metal shell of the refrigerator door body, which will also cause condensation to appear on the outer surface of the refrigerator door.

When the condensation on the outer surface of the refrigerator door is more serious, it is recommended to report to the refrigerator manufacturer for after-sales repair, and ask the maintenance personnel to repair the cause of condensation on site, replace the door body or repair the door seal.

This is normal, because the air temperature inside the freezer is low and the outside temperature is high, and the air condenses on the door outside the refrigerator, so water droplets will form.

Because the refrigerator door is affected by the cold air inside, the temperature will be the first point, and when the water vapor in the air meets a cold object, it will condense into small water droplets.