-
Ice cubes move from solid to liquid and liquefaction to absorb heat, causing the ambient temperature to decrease, causing the air to liquefy and form small water droplets.
Water droplets on the outer wall are the result of air liquefaction.
In summer, the refrigerator 1-6 is the gear of the thermostat, the temperature of the 1st gear is the highest, and the temperature of the 6th gear is the lowest. Adjust the gear level according to the ambient temperature of the season, it should be adjusted to a lower gear (1-2 gear) in summer, and it should be adjusted to the middle gear in spring and autumn, (about 3 gears), and it should be adjusted higher (4-5 gears) in winter, keep the freezer room at about minus 18 degrees, the refrigerator room is between 0-10 degrees, and it is best to be between 4-8 degrees, but it can not be adjusted to the highest gear (6 gears) for a long time, the highest gear is usually a forced refrigeration gear, and the compressor will always work without stopping, Generally, it is used for several hours when the food is speeded, but not more than 4 hours, otherwise it will damage the compressor.
The temperature of the refrigerator is higher, so the freshness effect is worse, and the gear should be turned higher.
In addition, it is necessary to check the working condition of the compressor, if it does not stop working for a long time, and the refrigeration effect is not good, it is mostly caused by the damage and leakage of the pipeline system.
-
This is formed by the liquefaction of hot water vapor in the air when it meets a cold refrigerator into small water droplets.
-
There is water vapor in the air, and the water vapor liquefies when cold....
-
The refrigerator cannot be sealed in all directions, and the heat of the motor is the best explanation, and the cold air is released through the gap (it becomes water vapor when heated), and it will re-condense into water droplets when it encounters the cold air.
-
There is gaseous water in the air, and when the temperature is low, it is exothermic and liquefies.
-
The temperature outside the refrigerator is high, while the temperature inside the refrigerator is low
-
The water vapor in the air liquefies when cold.
-
Hello, the common reasons for water droplets outside the refrigerator: 1. The weather is relatively humid: then the moisture in the air will form water droplets after contact with the refrigerator, which is a normal phenomenon, just adjust the thermostat.
Or keep the refrigerator in a dry, ventilated area. 2. The sealing strip of the refrigerator door seal is aging: it will cause the cold air in the refrigerator to come out, and after it meets the indoor high temperature, it will form water droplets, which will drip on the refrigerator door, and the door seal needs to be replaced with a new one.
3. If the heating wire in the freezer room is damaged, it will also cause water droplets to appear on the refrigerator door, so the heating wire should be replaced in time.
-
When using the refrigerator, there are several common reasons for finding water droplets outside the refrigerator: 1. The air saturation temperature in the room is higher than the surface temperature of the refrigerator, so the indoor air will form water droplets when it comes into contact with the surface of the refrigerator; 2. The refrigerator door is not closed tightly. 3. The refrigerator sealing strip is seriously damaged by aging; 4. The thermal insulation layer is not thick, and the performance is not good.
The solutions are: 1. Relatively humid and hot.
It is normal for water beads to appear on the surface of the refrigerator. It's good to see the water droplets dry with a dry paper towel, and when the weather turns cool and is no longer so hot and humid, the water droplets on the surface of the refrigerator will naturally disappear. There are also rooms with discharged refrigerators, remember to open more windows for ventilation.
2. Check whether there is a gap in the refrigerator door, and adjust it appropriately if there is. 3. Go to the electrical appliance ** to buy a few new sealing strips and replace them. 4. If the poor thermal insulation of the refrigerator causes water droplets, then place the refrigerator in a room with air circulation and use it, and adjust the temperature controller at the same time.
temperature. 5. It is best to take some time out of the refrigerator every day to maintain it. Wipe down the refrigerator case and handle daily with a clean, soft cloth.
Clean the case, unplug the power switch of the refrigerator, and remove everything inside the refrigerator. Scrub the cloth lightly with some detergent and rinse off with clean water.
-
What should I do if there is standing water in the refrigerator? The master tells you that you will see it at a glance.
-
Answer: There is always a lot of water outside the refrigerator, probably because the air temperature in the room is relatively large, and the surface temperature of the refrigerator is lower than the saturation temperature of the indoor air. Especially in summer, the indoor temperature difference is relatively large, the humidity in the hot air is greater, and the condensation on the refrigerator is more serious.
-
Cause analysis.
1. If the air temperature in the room is large, and the surface temperature of the refrigerator is lower than the indoor air, the indoor air will condense into water droplets when it encounters the surface of the refrigerator. In China, the temperature is high in summer, the temperature is large, especially in the middle and lower reaches of the Yangtze River, the humidity in the air is greater every time there is a high temperature, and the phenomenon of condensation droplets on the refrigerator is more serious, especially on the front of the refrigerator door, the phenomenon of condensation dripping is more common.
2. The refrigerator door is not tightly seamed.
3. If the heating wire of the door seal of the freezer of the frost-free refrigerator is damaged, or the sealing strip of the door crack is damaged, the common thing is that the door seal lacks elasticity and does not fit the door frame.
4. The insulation layer of the refrigerator is too thin or the foaming is not good, if there is a top of the refrigerator, half of it has water droplets, and half of it has no water droplets; There are also many local condensation water droplets on the side of the box, and even a small area of frost on the surface of some refrigerators, which is caused by the poor foaming of the thermal insulation material polyurethane in the box.
-
There are several common reasons why you notice water droplets outside the refrigerator when using the refrigerator:1. The saturation temperature of indoor air is higher than the surface temperature of the refrigerator, so water droplets will form when the indoor air touches the surface of the refrigerator; 2.
The refrigerator door is not closed. 3.The refrigerator seal is aged and seriously damaged; 4.
The insulation layer is not thick, and the performance is not good. The solution is:1
In hot and humid weather, it is normal for water droplets to appear on the surface of the refrigerator. It's good to see water droplets dry with a dry paper towel. When the weather turns cooler and not so hot and humid, the water droplets on the surface of the refrigerator will naturally disappear.
In rooms with exhaust refrigerators, remember to open windows for ventilation. 2.Check the refrigerator door for gaps, and if so, adjust them appropriately.
3.Go to the electronics store and buy a few new seals to put on. 4.
If the insulation of the refrigerator is poor and there are water droplets, then put the refrigerator in a ventilated room and turn up the temperature of the thermostat. It's best to take some time out every day to take care of your refrigerator. Wipe down the refrigerator case and handle daily with a clean, soft rag.
Clean the case, unplug the power switch of the refrigerator, and take out everything in the refrigerator. Gently wipe the rag with some detergent and rinse off the detergent with clean water.
It's not a quality issue. The temperature of the water in the tank is low, which forms a temperature difference with the indoor temperature, which makes the moist air around the toilet liquefy and form water droplets. It's just a physical liquefaction phenomenon. >>>More
There are several reasons for this:
1. The high-pressure pipes on both sides of the refrigerator cause the outside of the refrigerator to heat. >>>More
BTL power amplifier, a channel to use 4 high-power transistors, because the even harmonic distortion of BTL power amplifier cancels, the sound is not good, so it is rarely used in the family. (In car audio, due to the low working voltage, all this). >>>More
In summer, eggs are easy to disperse when they are placed outside for a period of time, because the temperature is high in summer, and the diffusion of egg whites and egg yolks is intensified, so that the gas in the egg yolk continues to diffuse to both sides, resulting in the separation of egg yolks and egg whites, and the phenomenon of egg yolks scattering. At the same time, the higher temperature in summer will also make the mucin in the egg white thin under the action of protease, losing the role of fixing the egg yolk, causing the egg yolk to fall apart. In order to prevent this from happening, you can put the egg with the big head down, so that the air chamber inside supports the yolk and prevents it from being close to the eggshell, so as to avoid the egg being left outside for too long in summer and causing the yolk to fall apart.
Because flies can see a lot of images every second, it's like slow motion, so they can naturally dodge.