What should I do if the headlights of my car get into the dust?

Failure and how to deal with it:

1. Line fault, due to poor lap or loose line connection, plug-in parts are not in place, etc., such faults may be caused;

2. Due to the inconsistent size and power of the replaced bulb, it may lead to such failures;

3. Due to the use time of some models, the mirror (headlights) are aging and cracked, which leads to the failure of the lights or insufficient brightness, and the headlights need to be replaced.

4. Due to the deformation or loosening of the reflection net in the headlamp, poor aggregation or divergence due to quality reasons, etc., it may lead to insufficient brightness or unfocus.

6. When the headlamp is affected by water, foreign matter and dust when the headlamp is poorly sealed due to the use time (or quality reasons), the light can be weakened or the brightness is insufficient.

7. The abnormal light line control relay can lead to the possibility that the light intensity is weak or not bright.

8. The lamp is weak due to the use of wire (maintenance) is not up to standard or the use of inferior bulbs.

9. Hernia of some ** models.

The light of the cannon is weak or not lit due to the sealing, cracking, burning, failure and other reasons of the package.

10. The line voltage is abnormal, the power generation is different, and the fluctuation is large, which can lead to weak lights or bright and dim, or even no light.

Car headlights get into the dust. This is a normal phenomenon. Headlights will get into dust after a long time.

No matter how good the headlights are, they are not well sealed, and they will get into the dust. Dust inside the headlights. To clean up.

You can only decompose the headlights with the headlights. There are places where the headlights are professionally refurbished. Remove the headlights from the Mengzi.

Clean it up after removing it. Dust inside. Renovation.

After it is cleaned. Put the headlights of the moe. Glue well.

This is the only way to do this. There is no other good way. Hope mine can help you. I hope you do.

Method 1: Remove the two rubber covers, remove the bulbs, and unscrew the two small lamp holders.

Keep both bulbs and be careful not to touch the glass and not to break them, especially not to break them.

Cleaning tools required: 1 small bottle cap of dish soap.

Water, a rag, twenty or thirty grains of rice (not to fill the hunger, pour it into the lamp to increase friction.

Mix well and pour in. Shake vigorously dozens of times to clean thoroughly.

If you shoot from the bottom to the top, if you can see that there is a lot of dirt and dirt hidden in the lamp shell, shake it to a certain extent, it will be about the same.

Pour out the dish soap and rice water, and you can clearly see how much dirt there is. Rinse the inside with plenty of water, wash it five or six times until it is clear, and notice that a row of rice grains under the lamp shell is stuck underneath, but there is a solution.

Wrap some cotton in the wire and stick it out. Be very careful when wiping, the reflective material on the lamp bowl is more fragile than we imagine, and a little force will cause scars.

end method 2:

Go to the tire repair area and remove the light bulb and blow it with an air pump to see if you can blow the dust off.

Use a straw to suck off the dust after removing the bulb. Hope, thank you!!

What kind of car are you talking about? If the light is sealed more tightly and enters the dust, you can only get from. The inlet of the lamp is cleaned, and then it is put in the sun and exposed to the sun until all the water vapor leaks out before loading it on the car.