-
There are four key ways to modify car headlights, namely1. Replace high-power halogen lamps; the second is to install headlight brighteners; 3. Replace xenon bulbs; Fourth, replace the headlight assembly.
Car headlights can be modified in the following ways:
1.Replace high-power halogen lamps;
Replace the original 55W halogen bulb with a 100W high-power halogen bulb and do not make any changes elsewhere. This is the easiest and most convenient way to retrofit.
2.installation of headlight brighteners;
If the headlight brightness enhancement line is installed in the headlights and battery of the car, the voltage loss of the line will be reduced. It is expected that the voltage of the headlamp will be basically the same as that of the battery, and the brightness will be obtained, which will meet the objective requirements of the original halogen lamp.
3.Replace xenon bulbs;
Lensless halogen lamp: directly replace with the corresponding model of xenon lamp, but due to the use of the original halogen lamp reflector, the lighting can not be used reasonably, the lighting effect is limited, and other travelers must have.
Halogen lamp or xenon lamp with lens: The effect will be quite clear after replacing the xenon lamp, because the original car already has a lens, and the spotlight will be better. How much the specific effect can be improved depends on the quality of the bulb used and the lens of the original car, which meets the requirements of objective conditions.
The budget is not large, and the requirements for automotive lighting are not very high.
4.Replace the headlamp assembly.
Simply replacing the bulb is not very effective and carries the necessary risks, so the whole retrofit scheme is feasible. Some manufacturers have produced assemblies for some popular models, including xenon headlight assemblies and LE D headlight assemblies, which can directly replace the original car assembly. There are a variety of decorative lights to choose from in the package, which is easy and cool to install, and the lighting effect is greatly improved.
However, the quality of accessories, bulbs, stabilizers, lenses, decorative lights, etc. in the assembly basically accounts for the majority, which is suitable for small partners who do not want to destroy the original car assembly, have a high budget, and are not picky about the effect.
-
Able to modify from a professional point of view, it is recommended to consult
Tianyu car modification.
-
What do you mean? Annual review or how to change?
-
Car headlights can be retrofitted, halogen bulbs can be replaced with xenon bulbs, LED headlights or bifocal lenses.
Whether the car headlight modification can pass the annual inspection, according to whether the modified headlights meet the requirements of the car inspection, the relevant laws and regulations stipulate that the high beam of the headlights can not be less than 1450 lumens, and the low beam can not be less than 1050 lumens, if it does not meet the requirements can not pass the annual inspection.
The law stipulates that xenon lamp modifications must meet four basic conditions:
1. Equipped with lens system, headlight cleaning system, headlight automatic leveling system, and ensure that the color temperature of the light is within 4300K.
2. The driver abuses the high beams to cause strong light to be dazzling, and the flickering and dimming of the far and low beams will cause temporary blindness, which will bring serious traffic safety hazards.
3. It takes a few seconds for the xenon headlight to be activated, and when it is necessary to see the road surface in time, turn the headlight button to slowly light up, which often leads to traffic accidents.
4. At present, the vast majority of vehicles do not take the xenon high beam system into account in the design, which will lead to such as the confusion of the automobile instrument, the dimming of the light indication, the failure of the transmission control system, the misalignment, and the disorder.
The results of the light change should meet the following requirements:
1. Astigmatism is prohibited. The best solution to change the light is to add a bifocal lens, the modified light will not be dazzling or astigmatism, and will not affect the safe driving of others;
2. The height of each car is different, so adjust the lighting angle to avoid affecting the safe driving of others;
3. The low beam is not less than 1050 lumens, and the high beam is not less than 1450 lumens;
4. The light intensity of the driving vehicle is not less than 15000cd and not higher than 120000cd;
5. The color temperature is required to be no higher than 6000K, otherwise the annual inspection equipment will not be able to detect the light.
The above content refers to Encyclopedia - Road Traffic Safety Law of the People's Republic of China.
-
If your headlight is not an LED bulb, but an iodine-tungsten bulb, just buy an integrated LED bulb and replace it without destroying the wiring.
-
Press the fog light switch before the fog light switch comes out.
1. Turn the knob to the third gear (low beam) on the right side of "0", and raise the knob up one gear--- that is, the front fog light is on.
2. Lift two gears--- that is, the rear fog lamp is turned on, and then lift the two gears, press down one gear--- that is, the rear fog lamp is off, and press two gears - that is, the front fog lamp is turned off.
Install fog lamp line positive and negative pole connection:
This model can be equipped with fog lamp negative pole nearby, and the positive pole needs to be connected to the corresponding switch.
-
Whether the headlights of the car can be modified, in addition to the configuration of the model, it also depends on how you change it. For example, the most mainstream lens modification scheme cannot be modified for some matrix LED models, however, generally speaking, most halogen lamp models are suitable for modifying lenses, and the effect of modification is huge.
There are many reasons why car headlights do not light up, including: burned-out bulbs, heated wires, damaged relays or combination switches, open wires, short circuits, open circuits, damaged fuses and poor line contact. First of all, you should check whether the fuse is good, because the headlight suddenly does not come on, and most of the cases it is caused by the blown out of the bulb fuse. >>>More
The back cover is opened with low beam and high beam, and then pointed, when the fog inside is almost dissolved, close the back cover, and then there will be no fog the next day, if the fog is in the middle of the headlights, it is estimated that it is water, and it is normal to have fog on the side.
The adjustment of automobile headlights is usually the left and right and height of the high and low beams, which can be adjusted by the knob behind the headlight assembly with tools. So what are the standards for the left and right adjustment of car headlights? Let's take a look. >>>More
Replacing headlight bulbs does not necessarily require the purchase of so-called original parts, as long as the bulbs meet the relevant annual inspection regulations, we can choose some products produced by large manufacturers that can improve the night lighting effect. The key is to confirm what kind of plug your car bulb is, for example, the Chevrolet Cruze we used this time is an H4 socket, then you must buy a bulb with the corresponding socket. After completing the replacement of the bulb, we also need to adjust the light height by ourselves to ensure that it meets the qualification standards of the annual inspection. >>>More
Change LED headlights are good, now the basic change of the lights are changed LED headlights, the same group of car friends 10 modifications have 8 are changed LED headlights, except for the words of Apa now there is nothing better, for economic car owners, this is a better choice.