The bathroom is not waterproofed and tiled, how to remedy it?

Bathroom decoration, relative to other indoor space, is very complex, although the total area of the bathroom is not very abundant, but the hard and soft decoration design is manyBefore the decoration of the house, the overall water and electricity must be changed, which is the first item of bathroom decoration, for example, and the construction is not in accordance with the order of steps, which is particularly prone to general product quality problems. Bathroom decoration, there are many subtle nodes, and some procedures are very complicated, such as not being delicate, or not buying high-quality raw materials, <>

There is no doubt about the quality of the product, not to mention that there is no waterproof material, immediately paste the floor tiles, such a thing is very rare, even if the simple decoration of the bathroom is not moisture-proof, it is not possible, the well-known decoration company, to design engineering construction for the new house, is not easy to occur this problem. Bathrooms are rooms where water often occurs. For example, if you take a shower in the whole shower room of the bathroom, there will be a lot of water splashing on the walls, and there will also be a lot of water on the ground.

Eventually, the water will flow out slowly according to the deodorized floor drain, but it will remain on the floor or on the walls before it flows out.

That is, the water on the floor or on the wall will leave a gap in the middle of the floor tiles and slowly seep in. Then it went deep to the bottom of the floor tiles, which in turn caused water to enter our walls and wooden floors. With the expansion of the total flow of water, this water will slowly seep into the bottom of the building, resulting in water seepage from the cast-in-place slab downstairs.

In addition, it will seep into the other side of the wall, causing leakage and moisture on the other side of the wall. For things like yours are more cumbersome, if you have a real estate agent there is likely to be a damp-proof, it is likely to be better, but if there is a change in the water or the ground is grooved, it will not work, there is no doubt that the wall is slotted by an electrician and the probability of leakage is large. If you don't want to plane the bricks temporarily, you can use ceramic tile joints to fill in the bottom of the wall, but it is not a long-term plan.

Wait until the bricks are tired of looking and then plan.

That kind of anti-smashing bricks has been used by people around me and is unreliable. Therefore, if you want to be completely safe and not leak, it is best to smash bricks. Check whether the original tile caulking work is guaranteed to be compact, and whether there is an area where there is a leak?

For example, what is the quality of the joint plugging work around the wall foot and the gap between the pavement tiles? Once it is found that the quality is not up to standard, it should be properly disposed of to prevent water from seeping into the toilet caisson from the gap and causing water leakage. Check whether the raw materials of the plugging joints in the bathroom are up to standard, and whether there are product quality problems?

It is because many of the plugging raw materials are "dissolved when they see water", and they do not meet the needs of condensation and do not have the effect of waterproofing, so when encountering such a thing, the original jointing raw materials will be cleaned up and plugged again.

If it is for the waterproofing of the bathroom, then you must remove the tiles and redo them, because if you do not do waterproof coatings, you will not be able to stick the wall tiles, otherwise there will be a lot of potential safety hazards in the future use process, which is very unfavorable for the protection of our property.

To find the leakage point, see if it is a problem with the water pipe, as well as the problem of the waterproof layer, find the leakage to remedy according to local conditions, you need to pry open the tiles in time, replace the pipe or do the waterproof layer.

Be sure to pry all the tiles open, make them waterproof, and then re-apply the tiles.

Be sure to ensure that the room is dry, you can install an air heating system, you can also install an exhaust fan, so that the dry and wet separation of the bathroom can be done the best, so that it can be remedied in time.

You can remove the tiles and redecorate, or buy waterproofing agent, and you can also tidy up the waterproofing of the ground, which can be waterproofed from other aspects.

If the bathroom is not waterproofed, it is tiled, then it is more troublesome to repair at this time, and a professional master should be invited to come to the door and repair it according to the situation.

Be sure to knock off all the tiles, and then re-do the waterproofing, and the bathroom must be waterproofed to avoid unnecessary trouble in the future.

1. Knock on the wall tiles with your hands and find that there are a lot of hollow drums, which proves that the tiles are not pasted well, and they should be chiseled and waterproofed.

2. No hollow drum was found, which proves that the porcelain *** plays a certain waterproof role, and the remedy: use acetic acid (household vinegar can) to penetrate into the tile, and the acid will react into a firm silica gel when it encounters sodium silicate. Silicone can fill the holes that may seep water and play a waterproof role.

The focus is on the caulking around the porcelain piece, and the glaze is also coated with sassafras (glossy) as much as it can seep into, don't worry about acetic acid not seeping into the glaze, because it can't penetrate into the glaze, then there will be no water seepage in the future, and the penetration of acetic acid itself is very strong.

Is the wall not done at all, or the height is not enough, the normal waterproof is the shower to do 2 meters high, other walls to do meter high, if not done at all, it is basically impossible to remedy,

The original building has been waterproofed, as long as you are not damaged, it may not leak, you can close the water for a test.

Where there is a leak, the toilet leaks, there are various cases. leaks around the pipes, as long as the traps downstairs. If the toilet tank, it can only be dug out and redone.

Buy a good water-proof or waterproof grout, and then spray the enamel waterproofing agent after the seam is not at ease.

A good remedy for the wall, there is a kind of transparent waterproofing agent on the market, just use it to brush on the seams between the tiles, and the tiles do not need to be brushed because of the glaze.

As for the floor, it is troublesome, and it is not useful to brush on it, because if you walk often, friction will destroy the waterproof material on it.

The ground area is not large, it is recommended to redo, and now there are many disputes arising from the waterproof leakage of the upstairs, just in case, hello, I'm good, he's good!

Walls don't have to be redone.

You go buy that waterproof interface agent. Brush the seams of the tiles on it. Go to the store where you buy paint and ask about it.

It's very simple, you go to the waterproof shop to buy some ceramic waterproof, squeeze it with a watering can, and spray it on the line, you have to buy the national standard.

It's hard to remedy it seems that there is a product: it can be waterproof without warping tiles, but I forgot the name of this product I will help you check it in the future, and now this waterproof product has a large market demand, but there are few real.

China's waterproof expert group.

Hefei Laoyang waterproof is at your service.

The remedy can be nothing more than a hassle.

What should I do if the bathroom is tiled without waterproofing?

Hello, glad to answer for you. If you dare to use it, you will definitely have to leak water downstairs, and the residents downstairs can tolerate you leaking water every day? The only way is to dismantle it and re-do the waterproofing, and then paste the tiles after the waterproofing.

When the bathroom is decorated, the specific steps must be clear, don't just find a person who doesn't know anything and start to decorate the book, which is not empty and reliable.