There is no water at home, and the water meter is re brushed with a water card, why is the water com

Why did the tap water you drink every day suddenly turn blue? "My neighbor also encountered this incident, I don't know what's going on, the tap water in her kitchen suddenly turned blue today, like the water that spared the blue bubble toilet cleaner, and there was no way to drink it normally.

I went to the neighbor's house and found that the water in the neighbor's house was the same as before, and there was nothing abnormal. Is this a problem with the water quality, or is there a problem with the water pipes?

This is a siphon after the water stops.

action caused, so that the water can not be drunk. "After receiving the situation reported by the neighbors, the staff of the water company traced the cause. "When the water stops suddenly, the pressure in the pipe will decrease, and the water will flow back, and some toilet tanks do not have anti-backflow devices, and the water in the water tank will be sucked back into the pipe by pressure.

When the water came, the neighbor opened the pipe, and the tap water and the contaminated water flowed out through the pipe. Even if you don't use the toilet cleaner at home, but there are other residents in the residential building who live in the toilet cleaner, blue water will flow out of the water pipes in the home through the siphoning action.

The staff advised the neighbor to quickly take out the blue bubbles in the toilet, drain the water in the toilet, rinse it and put it back on. If conditions permit, you can install an anti-backflow water stop valve on the toilet to avoid the water in the toilet tank from flowing back into the pipe, or try not to use the toilet cleaner.

Why does tap water appear milky white?

When tap water is transported in a high-pressure closed pipeline, the air in the pipe will dissolve into the water due to high pressure, and when the tap water flows out of the faucet, the air in the water will be released due to the return to normal pressure, thus forming countless tiny bubbles, making the appearance of the water milky white, and after being placed for a while, it will be clarified and will not affect the drinking water hygiene.

Why does drinking water turn yellow?

The yellowing is most likely due to rust on the inner walls of the iron pipes in the water pipeline. You can drain some of the tap water and wait for the water to be clear before using it.

Why does limescale appear in kettles?

Water used in daily life is both.

There is a certain hardness, such as the high hardness of water, and when heated, the insoluble salt components of calcium ions and magnesium ions (such as calcium carbonate.

and magnesium carbonate, etc.) will precipitate from the water and adhere to the inner surface of the kettle to form scale.

By now you should know why your tap water is blue, right?

Go to the property company for consultation, or call the water company directly to ask them to check and test whether there are germs or viruses, and do not drink it before the exact result to prevent poisoning. Remember to keep a sample or take a direct photo**, ** as evidence.

When the purchased water is used, the water will be stopped once, which is intended to remind users to buy water as soon as possible so as not to affect the use.

When the base meter transmits data to the liquid crystal meter (electronic part) through the data cable, the water meter does not transmit signals (does not sample) due to damage to the data cable, resulting in overdraft. For example, the LCD screen of the user meter always displays the number "30", indicating that there are 30 tons of water in the water meter, but this number has not decreased, and the mechanical part of the user meter is still measuring normally, which causes the solenoid valve to not be closed and the water meter to be overdrawn.

IC card water meter is a mechanical and electronic integration of products, the electronic part is susceptible to the external environment interference and the influence of the harder water quality in the north, there is no water stop if the valve is not closed, but the failure of the electronic part will not affect the normal use and measurement of the base meter. Members of the public are advised to take good care of and protect the water meter, install a hot water check valve, and do not allow water to enter the electronic part of the water meter or burn the water meter.

Water meter selection. 1. Select the water meter specification.

When choosing a size, you should first estimate the size and range of flow rates that would normally be used, and then choose the type of meter that most closely matches that value as the preferred size. Because the stability and durability of the water meter under the common flow rate are the best, it is more in line with the design requirements. If there is a margin for the water pipe considering the future water flow capacity, the water meter can be selected one level lower in the diameter specification.

If the diameter of the pipeline is 200mm due to the current flow is insufficient, you can choose to install a water meter with a diameter of 150mm, and then change to the same diameter water meter when the flow rate increases to the normal flow of the pipeline of 200mm in the future. Large-scale water-consuming industrial users can choose a larger-caliber water meter when selecting water meters, or they can use several relatively small-diameter water meters in parallel, so that they can also repair or replace individual faulty water meters without affecting the normal water supply of users.

2. Select the water meter indication type.

Generally, it is in the form of a word wheel, which is clear and easy to read. However, some people think that when it is not possible to read the meter at close range, it is better to install the pointer type, because this type can judge the reading according to the geometric angle of the pointer pointing, and there is no need to see the value on the scale cylinder grid.

In recent years, liquid-sealed counters have become popular because they overcome the shortcomings of conventional counters, which are hindered by rust in the water. The readings of remote water meters and prepaid water meters are displayed by electronic devices or collected and transmitted by centralized readers, but the readings of the base meter are still retained for comparison in the event of problems with the electronic devices read.

Generally, the IC card smart water meter will set an early warning value, when the balance in the water card reaches the early warning value, the IC card water meter will automatically close the valve to remind the user to reach the early warning value, at this time, you can still use water by swiping the card again, but when the balance in the card is used up, the water meter will automatically close the valve, and the valve can not be opened until it is recharged again.

1. Check whether the water meter is normal, and whether there are other error prompts when the water meter is inserted.

Second, see if the water card is broken and whether the amount of water is charged into the IC card. If the card is normal, and the card also shows the amount of water purchased, then the card is normal.

3. If the water meter does not display, it may be that the battery of the water meter is dead. If there is a display, but there is no response when the card is inserted, it means that the lithium battery of the water meter is broken and the solenoid valve cannot be opened, or it may be that the water meter card reading circuit is broken, or the card holder is broken.

This is a valve sign that your meter is turned off the valve. You insert the card first and see if the valve sign disappears or not. No, look at any other signs, it may be that the battery is undervoltaged.

Summary. 3.If there is a partial arrears, you need to confirm the exact amount with the property and pay it within a certain period.

However, until then, the property should not stop the water on the grounds of non-payment, unless the water stop measures are implemented in the event of repeated reminders to no avail, and prior notice is required. This is a normal administrative procedure. 4.

If you are unable to reach an agreement with the property or have other disputes, you can request arbitration, rights protection or change of property management company in accordance with the lease contract or relevant legal provisions. However, this may be a more extreme approach, and it is preferable to strengthen communication with the property to solve the problem. 5.

Before the problem is resolved, if your life is greatly affected, you can also ask the property to provide temporary water supply measures to solve the urgent need. As the basic needs of the residents, this should be met.

Hello, I am a living Lu Shen living master, Qi Ze is very happy to answer this question for you: "I have water on the meter, it can be used for a period of time, and there is no water, and the property card will be out of water as soon as it is swiped, but the property said that it is still in arrears".

Kiss From your description, there are the following situations of Nana stupid hole accompaniment:1Your home's water meter shows the amount of water, but the water supply in your house is intermittent or completely non-existent.

This hail sensitivity indicates a water supply problem or a plumbing problem. 2.You can restore the water supply after swiping your card with the property's key, but the property claims that you still owe the bills.

This seems to indicate that the water bill has been paid but there is a management problem.

Based on the above situation, my analysis and suggestions are as follows:1First of all, report the problem of dismantling the water supply in your home to the property of the gripper, and ask to find out the cause and restore the normal water supply as soon as possible.

This is the primary issue and the task and responsibility of the property. 2.At the same time, the property is required to provide a detailed list of fees and payment records of Duan Yuqiao Water Bill.

If it is proven that you have paid the water bill in full, you will not have to pay any further charges, and the property should not cut off your water and should not ask for any arrears. This is a management oversight.

3.If there is a partial arrears, you will need to confirm the exact amount with the property and pay it within a certain period. However, until then, the property should not stop the water on the grounds of non-payment, unless the water supply is implemented in the event of repeated reminders to no avail, and prior notice is required.

This is a normal administrative procedure. 4.If you are unable to reach an agreement with the property or have other disputes, you can request arbitration, rights protection or change of property management company in accordance with the lease contract or relevant legal provisions.

However, this may be a more extreme approach, and it is preferable to strengthen communication with the property to solve the problem. 5.Before the problem is resolved, if your life is greatly affected by the year's slippage, you can also ask the property to provide temporary water supply measures to solve the urgent need.

As the basic needs of the residents, this should be met.

My suggestion is to strengthen communication with the property to resolve the water supply problem and water bill dispute as soon as possible. Provide objective evidence and reasons to rationalize the settlement of the property's claims, and at the same time insist on its due rights, and require the property to restore the water and electricity as soon as possible.

If the negotiation fails, Lili will consider taking tougher measures to protect its own rights and interests. However, for the sake of mending the relationship, you can try to resolve it amicably first.

Dear, there are several situations:1There may be a malfunction in your water meter, which is preventing your meter from metering the amount of water properly.

It is recommended that you contact the property or the relevant maintenance personnel for access and repairs. 2.Your meter may have a leak or other water loss that is causing your meter to be inaccurately metered.

It is recommended that you check if there is any leakage around the water meter and fix it in time. 3.There may be mismanagement or billing errors in the property, resulting in an abnormal water bill for Hello Foundation.

It is recommended that you communicate with the property to verify your water bill and payment history to determine if there is any non-payment. It is recommended that you contact and communicate with the property or relevant maintenance personnel in order to solve the problem in a timely manner.