-
Cangzhou Jinglong shares with you how to clean up the fly killer.
Take the sticky trap infestation as an example:
1. Replacement of sticky insect board: Please check the sticky insect board of the infestation lamp frequently (it is recommended to check it at least once a week), and replace the sticky insect board in time when the insects stuck to the sticky insect board reach the point where you think it needs to be replaced. You don't need to remove the lamp when replacing the sticky insect board, just flip the panel up, remove the sticky insect board, and replace it with a new board.
2. Replacement of the lamp: When the lamp cannot be lit normally after testing, please replace the lamp in time. When replacing the lamp, gently turn and remove the lamp, and follow the steps to install a new lamp.
After replacement, please check whether the new lamp is normal immediately; Always unplug the lamp before replacing it.
3. Ballast replacement: We do not recommend non-professionals to replace the ballast by themselves (please let a professional electrician replace it).
-
The cleaning and maintenance of the infestation lamp are as follows:The insect carcasses in the collection tray of the electric shock insecticide lamp are cleaned at least once a week. The area of flying insects captured by the sticky trapping insect lamp exceeds 70% of the area of the viscose board paper should be replaced.
2.When cleaning, disconnect the power supply of the infestation, clean the dust on the chassis and lamp tube with a brush, and scrub the lamp.
3.The irradiation intensity and band of the infestation should be checked regularly, and the lamp should be replaced regularly according to the service life of the infestation manual.
-
There are many kinds, if it is a light to kill flies, just change the bulb directly, if the lampshade is a fly killer, remove the lampshade and wash it, or turn off the power to wash and dry it.
-
It depends on what you need to use it for.
However, as the weather gets hotter and hotter, whether it is for home or commercial use, fly killers are becoming more and more popular. Generally, infestation lamps are divided into electric shock type and sticky trapping type. The sticky capture type is more recommended, which is safer, more beautiful, and more practical than the electric shock type.
However, we should also pay attention to the quality when purchasing fly killers, some poor fly killer lights are not of good quality, not only the effect is not achieved, but also a waste of money.
-
It depends on the main use of your fly killer.
If it is for household use, buy a small fly killer, see that there are many styles of household ones on the market to choose from, it is best to choose a non-electric one, which is safe and environmentally friendly;
If it is used in companies, hotels, factories and other places, the effect of using sticky trap fly killer lamp is very good, using the UVA light emitted by the lamp to attract flies, attracting indoor flies to the fly killer lamp, and then the flies stick to the sticky fly board, the whole process has no harm to the human body, and will not cause pollution to the environment, the effect is very good!
Cangzhou Jinglong Environmental Protection recommends that you use sticky trap fly killer lamp, whether it is used at home or in large places, it is a good choice!
-
It is recommended to conduct a lamp assessment in April every year, and if there is not much insect infestation before May, the failed lamps should be found in advance and replaced immediately in order to cope with the upcoming "man-insect war".
The quality of the lamp root reform bureau of the fly killer lamp is different, and the cycle that needs to be replaced is also different. Domestic lamps generally need to be replaced once every two months at most, imported ones with better quality can be used for one year, and imported long-lasting lamps can be used for two years.
Infecidal lamp.
For more than one year of continuous use of the infestation lamp (domestic lamp less than one year), it is recommended to replace it even if it is on, because the UVA coating on the surface of the lamp has been consumed, and there is no function of attracting phototaxis insects, and the most safe ultraviolet rays are used.
The measuring instrument detects the effectiveness of the lamp.
The electric shock type fly killer power grid can be used to use an electric pen to dim it.
Or a screwdriver.
Regularly check if there is any spark coming out to confirm the effectiveness of the grid.
Lamps can be used with a UV measuring instrument and is suitable for UV lamps from 10 to 160 watts. It can check the UV output of the UV lamp inside the IED and the condition of the lamp to determine whether the lamp needs to be replaced.
-
1. The lower end of the fly killer should be more than 50 cm from the ground, the top should be more than 50 cm from the ceiling, and the height of the middle end should be about one meter above the ground.
2. Install a fly killer lamp every 20 square meters.
3. The fly killer lamp should avoid directly facing doors and windows to prevent attracting external insects and flies.
4. Do not install fly killers in places that are prone to occur.
-
The bait flytrap has a better effect, clean and hygienic. **Yes, you can buy it for more than a hundred. You can manage 50 square meters, and you can buy one or two in a small restaurant.
-
Destroy its breeding grounds.
In addition to doing a good job in household hygiene, it is very important to maintain and manage the overall outdoor environmental hygiene. Through publicity, all residents are required to practice good hygiene habits: do not litter and defecate outdoors; The restaurants and vegetable markets in and around the place of residence should maintain a clean life, and control domestic garbage.
1. Control the source.
Be diligent in cleaning up garbage, such as keeping areas with water hygienic and clean, because flies like to breed in dirty still water, so it is necessary to eliminate the environment where flies breed.
2. Door curtain. If you are opening a restaurant, you can use a curtain to prevent flies, so that it is not easy for flies to enter the room. Secondly, the windows should also be screened to prevent flies from entering the room.
3. Edible vinegar.
4. Insecticides.
Insecticides can kill flies, mosquitoes and cockroaches, but insecticides are poisonous, so you can close the doors and windows tightly, and then spray a few times with insecticides, after which people have to leave the room, wait until half an hour later, and then open the windows to ventilate, and you will find a lot of fly carcasses on the floor.
5. Fly swatter.
If there are only a few flies at home, you can buy a fly swatter, once you see the flies landing, then quickly swatt over, pay attention to the fly swatter should also be cleaned from time to time.
6. Sticky fly board.
If there are too many flies in the room, you can put a few sticky fly boards in every corner of the room, so that once the flies land on the sticky fly board, they will be stuck and there will be no escape.
-
Remove stagnant water: All kinds of stagnant water containers in front of the house, behind the house, yard, platform and balcony will breed mosquitoes, and the stagnant water in the above places should be removed in time. Spraying medications:
Spraying mosquito repellent drugs on Styrofoam, and then placing these Styrofoam at the door, on the windowsill, and around the bed, can effectively repel flies, and can also use fly stickers. Vinegar fly repellent: Spray a little pure vinegar indoors.
1. Remove stagnant water: all kinds of stagnant water containers in front of the house, behind the house, yard, platform and balcony, and even shallow stagnant water caused by refrigerator water tray and canvas plastic cloth cover will breed mosquitoes, and the stagnant water in the above places should be removed in time.
2. Spraying drugs: spraying mosquito control drugs on Styrofoam, and then placing these Styrofoams at the door, on the windowsill, and around the bed, can effectively repel flies.
3. Fly swatter: Fly swatter is a sharp weapon to eliminate flies, basically on the desktop, the fly staying on the wall can be killed, but it is easy to stain the desktop, consider using it.
4. Fly stickiness: Fly stickiness has its own stickiness, which can effectively catch flies and place them in dining tables, bathrooms and other places where flies often hang out.
5. Vinegar to repel flies: Spray a little pure vinegar indoors, and flies will stay away, so as to achieve the purpose of mosquito repellent.
6. Orange peel flies: Burning dried orange peel indoors can not only expel flies, but also eliminate indoor odor.
7. Environmental management: kitchen garbage is the favorite of flies, to eliminate flies must control the breeding ground, pay attention to the hygiene inside and outside the family, clean up the rotten food in time, and wrap the food in plastic bags when the food is not finished.
Food processing factories are required to install fly killers, and they can only install sticky trap fly killers, not electric shock fly killers, but where is the best place to install the fly killers in food processing plants? >>>More
Not necessarily, death is lighter than a feather, heavier than Mount Tai, like Lei Feng, although death is especially alive, his good qualities will always remain in people's hearts.
1.Suppose you mean the BIOS has been set to automatically start the numeric keypad when powered on. However, every time you boot into the system, the keypad still does not turn on automatically, and needs to be turned on manually, and it is normal to use after manual opening. >>>More
It's not a special and obvious quality problem, and the hard drive is not so easy to replace. If you want to change it, teach you a way, wrap the hard drive in a towel, knock on the table, and then return to the manufacturer.
Regarding the question you asked, the ABS alarm light is lit and many factors are related, the ABS speed sensor sensing part is covered by other pollution sources such as mud and mud, which affects the sensor to sense the corresponding speed signal, so that the ABS computer can not judge the vehicle speed, and then can not issue the corresponding action command to control the braking, at this time, as long as the dirt on the speed sensor is cleaned, the gap between the vehicle speed sensor and the signal gear ring is adjusted, it can be restored to normal; Secondly, the ABS light will also be lit after the speed sensor is damaged, and the ABS sensor must be replaced; In addition, due to the loose connection between the ABS lines, the internal failure of the ABS pump, etc., the ABS lamp will also be lit, and this fault needs to be fully checked.