-
Anonymous users2024-02-13It seems that there is a bit of a conflict in your question: when you finish verifying your fingerprint or use the door switch to open the door, you can hear the normal unlocking sound, but the door cannot be opened: this situation is caused by the delay time of opening the door is too short.
Your current delay time should be about 1 second, that is, even if the door is opened normally, but because the delay is too short, the door closes again before you can open the door. So, the phenomenon is that the door cannot be opened properly; After the door is closed, the electromagnetic lock cannot be locked in time, and it takes a while to lock: this is indeed a phenomenon caused by too long delay.
Because the delay is too long, it may exceed the setting of more than 10 seconds, so even if the door is closed, the time from opening to closing the door has not yet reached the delay time (such as 10 seconds), so it is necessary to wait for a while before the magnetic lock can be re-engaged.
Isn't it strange that these two problems happen at the same time? Did you delay the adjustment too much after the first problem occurred? If this is not the case, check whether there is a delay adjustment DIP on the magnetic lock, if so, adjust the DIP to 0 digits, and secondly, adjust the system delay to 3-5 seconds through software or all-in-one settings.
-
Anonymous users2024-02-12It should be an issue with the access controller. If you have tried to have this problem, the access control controller is powered off and then re-powered, and it can be opened normally, which proves that the controller has a quality problem.
-
Anonymous users2024-02-11Add a question, after the door is closed, the electromagnetic lock cannot be locked in time, what is the problem that it takes a while to lock?
The problem is that the lock is set to delay the shutdown of the delay, and the delay is relatively long, and the setting can be changed.
-
Anonymous users2024-02-10Hello, the fingerprint lock prompts that the lock has been unlocked but the door cannot be opened, first of all, it may be caused by the insufficient battery of the fingerprint lock, the user can replace the battery and try again.
In addition, it may also be caused by the problem of the fingerprint lock motor, at this time, you can directly contact the manufacturer of the fingerprint lock or after-sales, if the motor is faulty, you can repair or replace.
Fingerprint lock tips: If you can't verify the fingerprint in the process of using the fingerprint lock, it is generally caused by water or stains on your fingers, you can wipe your fingers and then verify.
Data expansion: The functions of fingerprint lock include fingerprint opening, password opening, card opening, emergency key opening, and now it has also added the way to open with WeChat, so that consumers can trust and choose fingerprint locks more. There are many manufacturers who integrate doorbells, voice prompts, networking, alarms and other functions on their products.
Convenience. You don't have to carry a key with you, and it's a key that will never be lost, a person's fingerprint will remain unchanged for life, and once you enter your fingerprint, you can use it for life. And a person can enter the fingerprints of different fingers.
Touch to open, reverse lift to lock.
2. Scalability. The fingerprint lock can accommodate 120 fingerprints, and can be registered at will to enter the fingerprint, delete the fingerprint, the management of the fingerprint is very convenient, compared with the ordinary mechanical lock, save the trouble of preparing the key and recovering the key, especially suitable for office space and rental space.
Disadvantages of fingerprint locks:
1. It is easy to be copied, the scanning surface area is large, and it is made of plastic, which is easy to be malignantly damaged, resulting in improper unlocking.
2. Once the power is off, the No. 9 backup battery is required, and this battery is difficult to buy in some secondary cities. Although fingerprints are used, in case of an emergency, the key must be carried with you, which is easy to lose and be stolen, and there is still a problem of changing the lock.
-
Anonymous users2024-02-091. It may be that the handle is not fully returned, so that the clutch pin cannot return normally, resulting in the clutch not working normally, and the door cannot be opened by pressing down the handle.
2. The square bar is separated from the outer panel of the smart lock, and the lock body cannot be linked, so that the door cannot be opened by pressing down on the handle.
3. The clutch pin cannot be pushed if the motor is damaged, and the clutch cannot work normally. All of the above problems should be found by professional maintenance masters.
-
Anonymous users2024-02-08It may be that the electronic door lock is out of power, which is a very common phenomenon. In this case, you can use the external power supply to see if the door lock responds. If there is a reaction, it means that the electronics of the electronic door lock are out of power, and only the electronics need to be replaced.
But if it's not a problem with electronics, then you can see if the configuration lock loss is broken. If it is because the configuration lock is broken, then you can only contact the maintenance personnel to deal with it.
Other common faults and solutions of electromagnetic access control.
1. The electromagnetic lock cannot be locked for a long time.
It may be because the delay of the electromagnetic access control is set too short and the rental is closed. At this time, you need to check the delay setting of the access control first, under normal circumstances, the delay is set within 6 seconds, if the delay setting time of the electromagnetic access control in your home is greater than 6 seconds, then you can adjust the delay appropriately according to the speed of the door closer, to ensure that the delay is longer than the closing time of the door closer.
2. Access control communication failure.
First of all, check whether the line string is set correctly and whether the access control communication is smooth, and then check whether the network cable crystal head is intact and whether the network cable is connected. If none of the above fails, it may be that the access control communication equipment is damaged, and it is best to contact the maintenance personnel for replacement.
3. The sound of the magnetic lock closing is very loud.
Check whether the rubber gasket is installed first, and if not, reinstall it. Secondly, check whether the screws at the end of the iron plate are too loose, if the screws are loose, then re-tighten them with a screwdriver.
-
Anonymous users2024-02-07The fingerprint lock is unlocked with a fingerprint, what if the fingerprint lock can't open the door? Today, PCHOUSE will answer them for you one by one.
1. The fingerprint lock is out of power, and the person is indoors. The back cover can be opened directly, and the alkaline dry battery can be replaced to resume normal use.
2. If the fingerprint lock is out of power, people are outside. It can be turned on by the temporary power supply emergency power supply, through the 9V battery purchased in the hardware store or some supermarkets, the positive and negative poles can be connected correctly to provide temporary power supply, and the battery can be replaced in time after entering the room.
3. It can be powered by emergency charging, and the new fingerprint lock product supports temporary charging of mobile phone power bank, which can be connected to the emergency charging port through power bank to temporarily charge the fingerprint lock.
4. If you can't buy a 9V battery and don't have a power bank, you can use an emergency mechanical key to unlock the lock.
5. The cause of circuit failure needs to be repaired by professionals, generally caused by circuit board burning, short circuit, solder joint falling off and poor contact, etc., you need to call the corresponding brand after-sales service to solve the problem!
-
Anonymous users2024-02-06The first method is to knock on the door and ask someone in the house to open the door for you, which is the most convenient. If there are people in the house.
2 6 The second method can enter the password to let the door lock open, and the fingerprint failure will also appear that it cannot be opened, but the fingerprint lock has a password function at the same time, and the door lock can be opened using the password function.
3 6 The third way is to use the remote control to open the door lock, this infrared remote control can be against the fingerprint lock, and the door will open immediately.
4 6 The fourth method is to use a small card to open the door lock. Fingerprint locks are also usually equipped with a set of small cards that can be used to open the door lock with the function of swiping the card.
5 6 The fifth method is to use the mobile phone wifi remote control, open the door lock, the fingerprint lock is smart, you can connect to wifi, use the mobile phone for remote control. This allows you to open the door lock without fingerprinting.
6 6 The sixth method is to use the key to open the door lock directly, when the fingerprint lock is out of power or the battery is used up, at this time other functions can not be used, we can use the most primitive method to open the door lock with the key, fingerprint lock. It is also equipped with an original key.
-
Anonymous users2024-02-05Answer: Hello, you can see if the anti-cat's eye unlocking button on the fingerprint lock panel is turned on. If this button is opened, it is not possible to press the handle directly to open the door, and the button must be turned off to open the door, but the user outside the door can enter the door by unlocking it correctly.
Question: The cat's eye unlocking key is not locked.
1. The square rod is too short or there is no spring in the handle, which causes the door to be opened in the house.
Clause. 2. The ground lock of the heaven and earth lock falls off, causing the door to be opened in the house.
Clause. 3. The anti-cat's eye unlocking button is damaged, resulting in the inability to open the door in the house.
Generally, these types of situations can be checked.
-
Anonymous users2024-02-04If you install a fingerprint lock, you can't open the door inside and outside, so you should pay attention to this problem.
-
Anonymous users2024-02-03If the fingerprint lock can't open the door, he can still use the key or password to unlock the lock, so you can use the attached way to unlock or let your family unlock the lock, it's really not good, you can only find a lock company to help you unlock the lock.
Access control card reader.
The beep keeps ringing? >>>More
Access control controller is connected with door magnetic signal magnetic lock wiring method.
Nalgae fingerprint lock and klinda are certainly not the same brand, klinda's head of operation used the nalgae brand in the early stage, but later due to product quality problems, the nalgae brand refused to let it advertise as a nalgae product, so later klinda appeared on the market, many products with nalgae standard with quality problems in the early days, i am one of them, i am a hundred sunshine, last summer, once our family went down to spread, because the child was only a few months, Often a whole family go down together, my husband was not at home at the time, more than half past eight in the evening, when I came back, my door lock could not be opened, the first reaction at that time was broken, the technology is unreliable, the mechanical key did not bring, quickly contact the manufacturer, the result was a situation of pushing back and forth, just started to contact the person who put the lock on me, a person surnamed Su, said let me call the company **, the result of the person asked me who to install, and then hung up **, at that time very detailed things can not be remembered, Probably such a process, to be honest, it was a very hot experience, and then it was estimated that the two of them were pushing each other, I was already very angry, and I couldn't wait to dismantle their company immediately, until more than nine o'clock, a person surnamed Chen said that he was the person in charge of, and later knew that it should be the boss, call me **, simply understand the situation, let me go to the hotel first, and say that I will arrange someone to deal with it immediately, don't let the old people and children suffer. There is a hotel in front of my house, I said that the children's small hotel has no milk powder, nothing, he asked me what brand my child drinks, let me find a comfortable place to stay first, said to come and deal with it immediately, and then the master surnamed Su came first, people may be far away, surnamed Su opened the door for me, chatted for a while, people arrived, their boss can tell the truth I was not so atmospheric, the surname Su is indeed not an employee of, first give me the relationship, the boss surnamed Su has never dared to take ** to solve it, Anyway, I was able to understand the various reasons for this, changed the new lock the next day, has been using, the two locks are indeed very different, at first I didn't pay attention to ***, at that time Nigae sent a fake announcement but didn't pay attention to *** didn't know this information at all, and then's boss had a move that moved me very much, he gave my child a red envelope, apologize! This matter has passed, and this question from the landlord suddenly reminded me of this unpleasant experience last year! >>>More
To reset the fingerprint, you can delete and add the fingerprint through the administrator, but different series of products are different, and the specific operation is subject to the manual. >>>More
Why can't I unlock my iPhone with my fingerprint:
1. First open the "Settings" app on the home screen of Apple 6. >>>More