-
The wire can be attached to the ring beam, of course, the wire is installed in the place where the line of sight can not be directly seen, so that the purpose of the open line is achieved, and the aesthetics are not affected.
-
Heavy flame retardant PVC line pipe can be used to fix the open pipe with clips, which is both stable and beautiful. Or make a groove where it is needed, then thread the tube, thread it after fixing, and finally cover the groove cover.
-
I think it's possible to groove in the ceiling so that it doesn't affect the aesthetics or the wiring.
-
There are two main ways to install open wires: one is the first step in the wiring of the wooden trough board, and the other is the direct wiring of the plastic sheathed wire (fixed with aluminum plates). The first step is to draw the wiring diagram with a pencil according to your own design requirements for room lights, switches, and sockets.
The second step is to drill holes every 30 cm or so in the wiring location and install a wooden pillow. The third step is a wooden trough bottom plate with 3 4 cm long iron nails on the wooden sleepers. The nails will be hammered into a wooden ridge in the middle of the grooved slab.
At both ends of each section of the wooden trough board, a nail should be driven at the distance from the port (wooden pillows should be embedded in the wall); At the junction of the two grooved plates, the ends should be sawn flat, and the wide and narrow grooves should be aligned. The fourth step is to nail the cover plate when wiring. The fourth step is to nail the cover plate with small nails long to align with the wooden ridge nails on the bottom plate.
A nail should be hammered at each end of the cover plate at 2 cm. The joints of the two covers should be sawn into an inclined plane. When it comes to the principle of home wiring, the main thing is to pay attention to safety, so we must choose wires that meet the requirements, try to avoid joints in the wiring, and the wiring should be firm and beautiful, etc., see the following introduction
There is a certain margin, the wire should have sufficient voltage resistance and insulation performance, and at the same time have sufficient mechanical strength, and the general indoor wiring often uses plastic sheathed wires. If you want the home decoration line to look good, you must use more baseboards. The bright wire is actually installed on the bright side, so after installation, it will always affect the overall decoration effect of the house, so this time you might as well suggest that you can hide the wire under the baseboard, and then use the decorative box to block the wire outside, not only will it not look messy, but also very beautiful.
-
You need to make the corresponding trenches first, then install wires in these trenches, and then backfill them.
-
Be sure to dress along your wall, set the socket in a reasonable position, and you can use the filter box appropriately.
-
You can choose a wooden trough board for wiring, which can protect the line, and it will look very beautiful, so that the line can be found well.
Decorating houses will be designed and installed wires, but there are many types of wires, so it is best to see what methods are available when installing, and it is best to understand when wiring, and the selection of some evil wires also needs to be mastered, thenHome improvement wire connectorsWhat are the methods? What are the methods of selecting and dismantling home improvement wires? Let's introduce it to you. >>>More
If you simply use electricity, you can use this tube. The usage is as follows: pull the wire, and then let a person look at the other side, if the wire moves, it means that this one is through, you can tie the wire and the wire and then pull the wire at the other end to lead the wire out. >>>More
CCC certification mark.
There must be CCC certification mark on the wire, wire and cable products are national compulsory safety certification products, all manufacturers must obtain the "CCC" certification certified by the China Electrical Products Certification Committee, obtain the "CCC" certification mark, and have the "CCC" certification mark on the certificate or product. The wire is related to the safety of electricity, and the bad wire will affect the safety of our life and property, so we must choose the wire product with the CCC certification mark. >>>More
First of all, the purchase of materials is a big financial payment, you can go to your community's BBS to convene some of the same to decorate the householders, materials, save some batches of zero price difference, wall paint do not need to buy a lot, general decoration will be used, together with the participation of ** householders can also form a mutual aid alliance (a screwdriver can be used by a family can also be used by 10 families, and the other nine families will save money to buy a screwdriver, Because of the usual things that are not used when decorating, there is no need to buy, because the decoration needs will waste a lot of money) so that you can save a lot of money, electrical appliances, engineering teams can go to the **, the floor try not to choose solid wood Now solid wood flooring has to pay a certain tax to protect the trees So solid wood flooring is a lot more expensive, composite flooring is a good choice, and the strength is not bad, not easy to deform. The fluorescent lamp is the most affordable, and the Philips with a lamp is only 16 yuan a piece. It's also a lot of power, bargaining. >>>More
Maintenance method, disconnect the back wiring of 6 sockets in turn, and test them separately >>>More