What should I do if the floor is damp when the carpet is laid in the house?

Updated on home 2024-07-18
7 answers
  1. Anonymous users2024-02-13

    What to do if the carpet floor at home is damp 1. The return of moisture on the floor of the house may be the humid air with a high temperature, and condensation is produced after contact with the ground that is smooth and has a particularly low temperature and does not absorb water. This resurgence is usually more common during the rainy season, when the temperature is high due to excessive rainfall, so the humidity is relatively high.

    2. It may also be that the water in the ground cushion rises from the capillary crevices, gradually turns into gaseous water and penetrates into the ground.

    Treatment of ground moisture return.

    If you want to avoid the return of moisture on the ground, there are several ways to deal with it:

    1. Turn on the heating equipment and heater to gradually increase the indoor temperature, so that the indoor and outdoor temperatures will gradually decrease.

    2. Look at the weather conditions at any time, if there is a southerly wind, close the doors and windows of the house tightly, and close the cabinet door.

    3. Hygroscopic items can be placed in the corners of the room, such as quicklime.

    4. You can also use dehumidifying instruments, such as dehydrating breathers. Or turn the air conditioner to dehumidification mode and then turn it to heating mode later.

    What should I do if the floor is too wet and slippery?

    1. Lay carpets.

    When we encounter a wet floor at home, the first step is of course to mop it clean with a clean mop, we can lay a layer of carpet in a damp place and on the ground where we will often pass, this is the simplest and most convenient way to deal with it, but it also has certain limitations, that is, to change the carpet frequently, so you can only choose a darker carpet, but imagine that it is really unrealistic to lay a carpet in the kitchen.

    2. Use anti-slip agent.

    This is the right way to prescribe the right medicine, since the anti-slip agent is used to solve the problem, the floor should be cleaned before using the anti-slip agent, and then the anti-slip agent should be added to a certain amount of water to clean up, and finally the floor must be guaranteed to dry naturally.

    3. Desiccant.

    This method is relatively slow, it can only be said to be prevention in advance, activated carbon and lime powder have a strong dehumidification effect, usually in all corners of the home can put some activated carbon and lime powder, you can pack them in small cloth bags in advance. Affordable.

    4. Turn on the air conditioner.

    The air conditioner has the function of dehumidification, and its effect may not be immediately apparent, but this is why people want to put a basin of water in the room when blowing the air conditioner, indicating that the dehumidification function of the air conditioner is still very good.

    5. Use non-slip slippers, some plastic slippers are still very good, not expensive and have a safe anti-slip function.

    6. Some owners can polish the floor by machine or carve some patterns if they are not afraid of trouble, but although it is non-slip, it cannot make it beautiful, and it is difficult to clean.

    7. Finally, the most direct thing is to buy the floor, considering the inconvenience caused by the dampness of the floor, then choose the floor with non-slip.

  2. Anonymous users2024-02-12

    If a small amount of mold grows on the surface of the floor, mix it with water in a ratio of 1:3 with warm bleach and wipe it with a rag. The concentration of bleach should not be too high, too high a concentration will destroy the waxing of the floor surface and make the floor be wiped off the color.

    If there is mildew inside the local floor, it is necessary to remove the moldy floor immediately and replace it with a new floor, so as to prevent the mold from infecting other intact floors and causing a large area of mildew.

  3. Anonymous users2024-02-11

    1.Clean up in a timely manner. Vacuum every day, don't wait until a lot of stains and dirt seep into the carpet fibers, only clean frequently, it is easy to clean. When cleaning carpets, take care to sweep the floor under the carpet.

    2.Use evenly. After a few years of carpet paving, it is best to adjust the position so that it wears evenly. If there are bumps in some places, you should gently pat them or gently iron them with a steam iron.

    3.Decontamination method. Ink stains can be wiped with citric acid, and the wiped area should be washed with water, and then wiped off with a dry towel

    Coffee, cocoa, tea stains can be removed with glycerin: fruit juice can be removed with cold water and a small amount of dilute ammonia aqueous solution: paint stains can be mixed with gasoline and washing powder to form a porridge shape, applied to the paint at night, and then washed with warm water the next morning and then used a dry towel to absorb the water.

    4.Removal of foreign bodies. Some light substances such as fluff and paper scraps fall on the carpet, and the vacuum cleaner can solve it.

    If you accidentally break a glass on the carpet, you can use a wider tape to glue the broken glass: if the broken glass is powdery, you can use cotton dipped in water to stick it and vacuum it.

    5.If the carpet has scorch marks, when it is not serious, you can use a stiff brush or nickel to brush off the burned part of the bristles, if it is a serious scorch mark, and then press it on it with a book, wait until it is dry, and then comb it.

    6.Carpet dusting. Sweep the carpet with a broom soaked in soapy water, keep the broom moist, then sprinkle with fine salt, sweep with a broom, and finally wipe it with a dry rag.

    When cleaning the carpet, the chemical fiber carpet can be washed and dried if possible. The pure wool carpet has to be put in the sun for a while after a while, pay attention to turn the carpet over, hang it on a rope and beat it with a thin stick to remove the dust as much as possible. This is also effective in killing mites on carpets.

  4. Anonymous users2024-02-10

    Carpet Damage: Carpet is prone to dirt, and if you look closely, you can see small black hairballs on the surface.

    Prevention and control methods: Many families lay carpets at the bottom of the coffee table, at the foot of the bed and other places, and these carpets are laid on the floor and are most susceptible to the influence of the ground air, absorbing moist water vapor into it. When the wet weather comes, you can first lay a soft, absorbent tissue paper skin in the carpeted area, and then cover the carpet on it.

    However, if you are concerned about heavy moisture on your carpet, the best way is to put it in a humidity box and use it when the weather improves.

  5. Anonymous users2024-02-09

    Hello! If your carpet is an animal hair fabric, animal hair is an animal protein fiber that is easy to shrink, so it is generally advisable to send it to a professional laundry store for dry cleaning.

    If the wool fabric is dirty, it must be cleaned immediately to avoid leaving marks. The longer the stain stays on it, the less likely it is to be washed off; In addition, if the stain penetrates into the fiber over time, it will inevitably rub hard when cleaning, which will more likely cause damage to the clothing.

    For slight stains, you can try to use a towel dipped in neutral laundry detergent or a special detergent solution for silk wool to gently wipe the hair surface, after removing the stains, use a clean towel dipped in water to clear the detergent residue in the same way. Repeat several times. Try not to soak the leather board during the operation, and dry it in a cool place in time.

    If washing, there are the following precautions:

    1. It is not alkali-resistant, if it is washed with neutral enzyme-free detergent, it is best to use a special detergent for wool. If you are using a washing machine, it is advisable to use a front-loading washing machine and choose a gentle program. If you wash by hand, it is best to rub gently, and do not use a washboard to scrub;

    2. Wool fabrics will shrink and deform in an aqueous solution above 30 degrees, soak in cold water for a short time, wash at a temperature of no more than 40 degrees, pinch and wash gently, and do not scrub vigorously. Be sure to use a laundry bag when machine washing, and choose a light setting. Dark colors tend to fade easily.

    3. Squeeze washing, avoid twisting, squeezing and removing water, flattening and drying or folding half hanging drying; Wet plastic surgery or semi-dry plastic surgery, can remove wrinkles, do not expose to the sun;

    4. Use fabric softener to maintain soft hand feel and antistatic.

    5. Do not use chlorine-containing bleaching liquid, and oxygenated bleaching can be used.

    Attention should be paid to when storing:

    1. Avoid contact with sharp, rough objects and strong alkaline objects;

    2. Choose a cool and ventilated place to cool and dry, and collect it only after it is dry;

    3. During the collection period, the cabinet should be opened regularly to ventilate and keep it dry;

    4. In the high temperature and humid season, it should be dried several times to prevent mildew;

  6. Anonymous users2024-02-08

    If it is not easy to dry, you can use a dehumidifier to dehumidify, and the carpet will dry easily.

  7. Anonymous users2024-02-07

    The carpet generally does not cause the wall to be damp, and if the wall is wet, the waterproof bottom is generally not done.

    Another is the return to the south in the southern region, if the humidity is too high, the walls of the home will hang water droplets.

    If you use carpets, if you have a return to the south (extremely humid and sultry) weather in Guangdong, it is not suitable to use hemp material, because hemp material is prone to moisture and mildew.

    Pay attention to the connection between the carpet and the wall to prevent the carpet from being too wet and seeping into the wall.

    For the walls, you can use materials that absorb moisture.

Related questions
10 answers2024-07-18

In rural houses, the damp ground should be ventilated frequently, and the large furniture (such as wooden cabinets, screens, etc.) placed in the windproof place should be appropriately removed, so that the air in the living room can circulate to accelerate the evaporation of water. If the ground moisture return is more serious, it can be remedied by yourself. The ground is first dug out of a pit, then paved with asphalt, and then paved with a layer of cement; Or first lay a layer of linoleum or two layers of waste plastic film, and then lay a layer of cement prefabricated blocks or bricks. >>>More

7 answers2024-07-18

I think it's mainly due to the fact that your home environment is too humid and the hygiene is not very good. Suggestions: 1. Buy more disinfectant to go home and spray it everywhere; 2. Clean the house, leave no dead corners, and spray it with disinfectant or insecticide after sweeping; 3. Keep ventilation, furniture that is not easy to move should also be moved once a week to keep it dry, hygienic and ventilated.

5 answers2024-07-18

1. When decorating, you should pay attention to whether you want to ventilate. This should be taken into account when decorating, some places have to return to the south or the lot itself is more humid, which is easy to cause the wall to be damp, so you can install an exhaust fan in advance, do not let the space be closed. >>>More

8 answers2024-07-18

Reprocess the ground using a screed.

In other words, if we plan to lay a wooden floor and the floor needs to be releveled, then we should not deal with it separately and use a new screed. The conventional method is to smear a layer of cement mortar on the ground, and the strength of the cement mortar is higher, that is to say, the cement content is larger. If the thickness is thicker, you can beat a layer of concrete, and then use a plate vibrator to level the ground. >>>More

5 answers2024-07-18

Reprocess the ground using a screed.

In other words, if we plan to lay a wooden floor and the floor needs to be releveled, then we should not deal with it separately and use a new screed. The conventional method is to smear a layer of cement mortar on the ground, and the strength of the cement mortar is higher, that is to say, the cement content is larger. If the thickness is thicker, you can beat a layer of concrete, and then use a plate vibrator to level the ground. >>>More