-
If there is water in the engine, it is recommended that you do not start it again, generally remove the spark plug to drain the water inside, and then replace the spark plug oil.
Thanks for using, I hope mine can help you, it would be great if I could help you!
If you don't understand something, feel free to ask, and I will give you a satisfactory answer!
-
How to solve the water ingress of Wuling light engine steps:
1. Remove the negative wire of the battery as soon as possible to avoid short circuits caused by water ingress in various electrical appliances on the car.
2. Check the engine immediately, first check whether there is water in the engine cylinder, which will cause the connecting rod to be bent and damage the engine.
3. Check whether there is water in the oil, which will cause the oil to deteriorate, lose its lubrication effect, and make the engine wear excessively.
4. Check whether the gearbox is flooded, and the gearbox water will cause the gear oil in the gearbox to deteriorate, resulting in gear wear.
5. Check the brake oil, the water in the brake oil will deteriorate the brake oil, resulting in brake failure.
6. If water enters the exhaust pipe, the stagnant water should be removed as soon as possible to avoid impurities in the water blocking the three-way catalytic converter or damaging the oxygen sensor.
7. Check whether the battery is full of water, and replace the electrolyte if necessary.
8. The automatic transmission car should check whether the automatic transmission and the transmission control computer are flooded.
9. Dry the soaked items in the car as soon as possible to avoid mold.
-
The water drain hole of Wuling Light is located at the bottom of the car water tank, and the engine does not have a water drain hole.
With the car engine cooling, unscrew the tank cover, open the tank drain valve (at the bottom of the tank), and release the antifreeze. A rubber hose connected to the water pipe is inserted into the tank filler and the tap is turned on so that the tap water flows continuously through the engine cooling system.
If the car water tank is filled with water, you can clean the water tank once after running tens of thousands of kilometers, and then you can replace the cooling water by the way. If you add coolant, you need to change it every two years. Now there are a lot of high-quality long-lasting antifreeze, usually pay attention to adding it, and you can replace it once when you run tens of thousands of kilometers to clean the water tank.
-
Hello dear dear, Wuling Light's new engine piston is flooded. First, if this kind of fault occurs in this new engine assembly, it is obvious that there is a problem with the quality of the engine. Second, this directly asks Minyu Zhengqiu manufacturers to replace the new engine.
Thirdly, it is obvious that the cylinder head is deformed or the rigid body is faulty. Kiss Blessings to you, good health and family, and if my answer is helpful to you, please give it a thumbs up. Thank you very much for your support!
Finally, I wish you good health and <> again
Good luck! Good luck!
-
Hello, 1. Check the air filter, if you find that there will be obvious water marks at the air filter, the engine is more likely to enter the water.
2. Check the spark plug. Remove each cylinder spark plug and check it for moisture, if the number of moisture indicates signs of water ingress into the engine.
3. Even if the car is soaked in water and it has been turned off, do not try to start it again, so that the engine will enter the water.
4. As long as the engine is just mixed with water vapor to enter the water from the air filter, it is not a big problem to tease the queue at a certain time, you only need to simply deal with it in my opinion, and make the air filter, throttle valve, and cylinder clean up the water vapor in my opinion.
5. As long as the engine is disproportionately watered, it may not affect all normal driving, it seems to be very loud, it may be a small part of the water in the engine oil and gasoline, and you need to change the oil to clean up the engine related and accessories.
If there is more or less water or water intake, the engine is only water, but you don't care about mixing or saying that the water is more or less, but the car is not started, the engine is not damaged, you need to drain the water immediately, clean it up, you need to reinstall it and change the oil, so the electronic system is not so safe.
The next is because the engine has a considerable degree of water ingress, so that the engine cylinders, connecting rods, pistons and have long been deformed, it can be determined that the engine has been scrapped, and everyone can only replace the new engine, or scrap the car directly.
It is recommended to do further treatment after the examination.
-
The Wuling Light gearbox will get water. The extended information is as follows: 1. Water ingress:
If there is standing water on the road while driving the vehicle, the splash may cause water to enter the transmission. The water ingress into the gearbox is mainly through the core hole of the ventilation pants. Because the gearbox is not completely enclosed, it is possible for water itself to enter directly through the vents.
When the water is submerged over the wheel 2 3 or more, then the probability of water entering the gearbox of the vehicle is about 80 to 90; If the water has already submerged through the instrument panel, the gearbox is 100 water inlet. 2. Car wading practice: it is best to turn off the air conditioner, after the vehicle turns on the air conditioner, the electronic fan located in the front of the car will rotate, and the fan blades that rotate when wading will stir up some water splashes, which may cause the gearbox to enter the water, so try to turn off the air conditioner when wading, and then enter the wading section after the electronic fan is closed; If there is a car on the opposite side when wading, you must pay attention to the height of the wave in front of the front of the car, if the wave is too high, you need to accelerate appropriately, the reason is that you can use the water wave generated by your own side to alleviate the water wave caused by the opposite vehicle, you must pay attention to not panic when encountering this situation, let alone step on the brakes; All on-board electrical devices should be turned off before wading into the water, such as:
The purpose of air conditioning, driving recorder, etc., is to prevent water ingress into electrical equipment and cause power failure and short circuit.
There are two basic scenarios for the causes of oil leakage in a car engine: >>>More
There are two basic scenarios for the causes of oil leakage in a car engine: >>>More
1. If the engine is just mixed with water vapor and enters the air filter, we only need to deal with it simply, and clean the water vapor from the air filter, throttle valve and cylinder. >>>More
Engine Cylinder ShortageRegarding the problem you inquired, the cause should be the flooded spark plug caused by the engine burning oil. You can check whether the engine burns oil by yourself in the following ways: First, if the exhaust pipe only emits blue smoke when the car starts, the biggest possibility is that the valve guide and the duct bearing hole are not tightly sealed, causing oil leakage, and then seeping into the combustion chamber; Second, if the exhaust pipe emits blue smoke during normal operation, it may be caused by excessive wear of the valve stem or the failure of the valve stem oil seal, which causes the oil in the valve chamber to be sucked into the combustion chamber, so that the oil enters the combustion chamber through the intake pipe with the combustible mixture; Third, if in addition to the blue smoke from the exhaust pipe, you can also see the pulsating blue smoke from the oil port of the processor, it can be preliminarily determined that the sealing effect of the piston connecting rod group is not good, and the piston connecting rod group such as the gap between the piston and the cylinder wall is too large, the piston ring elasticity is small, locked or counterpartial, and the piston ring wear makes the end clearance and side clearance too large, so that the piston ring produces pump oil phenomenon. >>>More
Adjust according to the double-row non-entry method, in the ignition order of 1342! Turn the crankshaft to a cylinder top dead center! >>>More