Where is the vertical air conditioner drain pipe

The lower right of the air inlet frame of the indoor unit. The drain is usually installed at the bottom right of the indoor unit's air inlet frame, together with the copper pipe.

Vertical air conditioners generally have two drainage pipes, which are pasted together with tape, which is connected with the water tray of the unit, and the nozzle should be firmly connected and wrapped with cable ties.

The drain pipe needs to be connected to the outdoors, and when it is exposed to the outdoors, the surface should be wrapped with a layer of insulation material to avoid cracking on the surface of the pipe.

1.The drain pipe of a suspended air conditioner is one of the pipes that leads to the outside. There are generally two, glued together with tape.

Wall-mounted air conditioners generally do not need to install drain pipes. When installing, set the back of the air conditioner slightly lower than the front panel, so that the condensate can flow smoothly from the drainage hole under the back. However, the general manufacturer usually provides an elbow of the drainage pipe randomly, installs the elbow on the drainage hole below, and then connects the drainage pipe.

In order to improve the heat dissipation effect, some brands of window air conditioners are specially designed to use the fan blades to pump the accumulated condensate to the heat sink for cooling, so that there is no need to connect the drain pipe. 2. **The air conditioning outlet is usually installed in the corridor, dressing room or kitchen and bathroom room. Because the drain pipe of the air conditioner is connected to the outside through the indoor unit, and when the air conditioner is working, whether it is cooling or heating, it will be exposed to cold and warm air, and condensation will also occur.

Generally speaking, the drainage pipe of the hanging air conditioner should be next to the wall, that is to say, the place where the machine goes out along his pipe, you can go to observe it, you must be saying that the air conditioner is installed in the building, why can't you see the drainage pipe? In fact, most of this situation is along the pipe, and then to the outside unit, and then the water will be discharged, you can go to the outside of the building to see the dripping water when the air conditioner is turned on, that is, the drain pipe of the air conditioner.

The drain pipe of the hanging air conditioner is on the left or right side of the hang-up machine, and the installation position of the air conditioner should avoid the heat source, and the hot air elimination and noise interference should not affect the neighbors.

Turn off the power of the air conditioner and remove the panel and filter of the indoor unit.

Locate the outlet of the drain and gently unplug the drain with pliers or fingers.

Use a high-pressure water gun or vacuum cleaner to rinse or suck out the dirt in the drain.

Reconnect the drain and check for leaks.

Install the panel and filter, turn on the power of the air conditioner, and check if it is working properly.

The air conditioning drain is mainly divided into two types: the drainage pipe of the hanging air conditioner and the ** air conditioning drain, and the locations are as follows:

1. The drainage pipe of the hanging air conditioner.

A drain pipe is one of the pipes that lead to the outside. There are usually two, glued together with tape.

Hanging air conditioners generally do not need to install drain pipes, and the back of the air conditioner is slightly lower than the front panel when installing, so that condensation can be guaranteed.

It flows out smoothly from the drainage hole under the back, but the general manufacturer usually randomly equips a drain pipe elbow joint, install the elbow joint on the drain hole below, and then connect the drain pipe.

Some brands of window air conditioners are specially designed to pump the accumulated condensate into the heat sink through the fan blades in order to improve the heat dissipation effect.

so that there is no need for a drain pipe.

2. **Air conditioning drain.

It is usually installed in the hallway, dressing room or kitchen bathroom. Since the drainage pipes of the air conditioner are connected to the outdoor by the indoor unit, and the air conditioner will be in contact with cold and warm air during the working process, whether it is cooling or heating, and there will be condensation.

Schematic diagram of the location of the drain outlet of the air conditioner:The air conditioner drain pipe is in the hole in the wall where the inner unit is connected to the copper pipe. The air conditioner drain pipe is usually at the hole in the wall where the internal unit is connected to the copper pipe, and can be connected to the internal unit from the right or from the left.

It is mainly used to remove the water generated by the operation of the air conditioner. Moreover, the drainage pipe will be wrapped with waterproof tape when installed, and the above characteristics indicate that it is a drainage pipe.

Air conditioner drain pipe installation1. The slope should be mastered: when installing the air conditioning drainage pipe, it is necessary to pay attention to a slope, that is, the drainage pipe is higher than the main pipe, otherwise it will cause indoor shutdown, and the condensate will flow backwards into the inner machine, resulting in water soaking in the ceiling.

2. Do a good job of moisturizing treatment: when the drainage pipe is installed, it is necessary to do a good job of thermal insulation, and the drainage pipe can be wrapped with thermal insulation cotton, because the drainage pipe discharges cold water generated by air conditioning and refrigeration, and if it is not kept, it will cause condensation on the surface of the drainage pipe, thereby damaging the ceiling and causing serious losses.

The above content reference: Encyclopedia - Drainage Pipe.

1. The cabinet air conditioning drain pipe is at the bottom right of the air inlet frame of the indoor unit, and the copper pipe is out of the wall hole. Air conditioners generally have two drain pipes, which are glued together with tape. The drainage pipe in the cabinet air-conditioning room is generally made of plastic, and when we connect it with the water connection nozzle of the unit, we must paste the nozzle firmly and wrap it with a cable tie.

Therefore, the exposed drainage pipes in the house are wrapped with insulation materials on the outside, so as to prevent the outside air from entering the inside to condense into dew and produce dripping. Because the indoor unit is a long cabinet-shaped machine, it is very easy to fall forward when installing, so we should do some protective measures when installing, and install right-angle iron anchors on the upper part of the body, and the anchors are fixed on the top of the casing at one end and the other end on the wall.

The air conditioning drain is mainly divided into two types: the drainage pipe of the hanging air conditioner and the ** air conditioning drain, and the locations are as follows:

1. The drainage pipe of the hanging air conditioner.

A drain pipe is one of the pipes that lead to the outside. There are usually two, glued together with tape.

Hanging air conditioners generally do not need to install drain pipes, and the back of the air conditioner is slightly lower than the front panel when installing, so as to ensure that the condensate flows smoothly from the drainage hole under the back, but the general slag experts usually randomly match the elbow joint with a wide and blind drain pipe, install the elbow joint on the drainage hole below, and then connect the drain pipe.

In order to improve the heat dissipation effect, some brands of window air conditioners are specially designed to pump the accumulated condensate to the heat sink through the fan blades to cool down, so that there is no need to connect to the drain pipe.

2. **Air conditioning drain.

It is usually installed in the hallway, dressing room or kitchen bathroom. Because the drainage pipes of the air conditioner are connected to the outdoor by the indoor unit, and the air conditioner will produce cold and warm air contact during the working process, whether it is refrigeration or heating, and there will be condensation.