How to paste the corner of the anti static rubber and the laying method of the anti static rubber

If you turn the corner, some of them are in the form of "bandaging", and some of them are directly on the table, to be honest, if you buy this thing, you don't have to stick it at all, because a good rubber mat basically does not roll, and how long it takes is very smooth. And it will curl very much, there is no way to use it, if you want to choose, choose the kind of pure natural manufacturing, see if the surface is delicate, and whether the rubber pad is very hard, if it is very hard, don't buy it, in fact, our company also produces this thing, it is also a pure natural material production, Samsung, Nokia, motorcycle or something electronics factory and other research institutes, pharmaceutical factories, are using our things, I am not here to advertise that others are not good, say their own good, but you must not choose recycled materials when you choose, No matter how cheap it is, the health of the work and the service life of the rubber all have an impact!! Leave you a mine**,Just hit me when you need to**,I can help you with some professional things.,Hehe,**It's 186 plus 2269 plus 5584.,Hehe.,I hope it can help you a little bit.。

Tools: table tennis glue, clean base plate as well as rubber, scissors, cylinders.

Method:1Don't tear the film of the table tennis ball rubber first;

2.First brush a layer of glue on the bottom plate, and brush it again after drying, the amount can be not much, but it must be even;

3.The rubber is also brushed on both sides, and the glue will rise up if it is brushed too much;

4.After the glue is dried on both sides, paste it on the right position;

5.Then roll on the rubber with a cylinder, without leaving a gap between the rubber and the bottom plate (rolling with a glue bottle is also fine);

6.After gluing, use scissors to cut along the edge of the bottom plate;

7.If you have a utility knife, you can use a utility knife to cut the sponge first, and then use scissors to cut it, which will be much neater.

Lay anti-static rubber on the desktop, and then buckle one end of the anti-static grounding wire button on the surface, and the other end is connected to the earth conductor, so that the static electricity gathered on the desktop is discharged through the anti-static grounding wire

1. The green side is the storage and absorption of static electricity around the desktop, and its resistance is 10 7---10 9 cm;

2. The black bottom surface is a conductor of 10 6 cm, because the conductor can quickly discharge the absorbed static electricity;

3. One end of the grounding wire is connected to the anti-static mat, and the other end is connected to the earth, so the static electricity is smoothly discharged to the ground through the wire, so that the static electricity around the desktop is discharged through this principle.