Is it useful to cook headphones? What are the pros and cons of cooking headphones?

It works, and I recommend listening normally, just don't make it too loud. The dynamic headphones are fully turned on in about 300 hours. Cooking headphones is to accelerate the aging of the diaphragm to enter a stable working state in advance.

It is very dangerous to use software to cook, because it is used for cookers, and white and pink noises are not used. There are also different sizes of variation for different headphones. Some headphones are completely different from new headphones when they are turned on, and some have little change.

Not to mention the 200 yuan headphones, there are also changes in the stall headphone boiling.

You don't need to listen to the headphones, you can just throw it away, there is still a use, for example, just like if you buy a new car, the driving method before the first insurance is the same, you should pay attention to it, so that you can control it handily after that. Now there are three ways to cook headphones, one is to turn on the volume to the maximum and put it for dozens of hours. One is to play a song, try to choose a high, medium and low frequency are richer.

The other is to just leave it on as usual. Which is right, the benevolent and the wise ......Anyway, I choose the second one and the first one. When the earbuds were first bought, there was still a difference between them and after they were cooked, and the machine that came with my Sony A815 did work a lot better after the pot was opened.

It is recommended that the landlord try it

The main purpose of cooking headphones is to make a rapid run-in process of the mechanical system of the headphones, and the sound system of the dynamic headphones is driven by the voice coil, and the diaphragm is fixed on the frame of the headphones. Theoretically, the diaphragm movement should be a piston (vertical) movement, which requires the edge of the diaphragm to have greater compliance, the pot is the pot here, the diaphragm edge of the new earphone is relatively tight, the elasticity is large and the compliance is small, the earphone is to make the edge of the earphone move, and the sound is not so tight.

Here's how to burn the machine:

1.Use a softer ** (white noise, red noise is recommended), let the headphones soothe for 10-30 hours at a lower volume, take a group of four hours, and stop for about ten minutes before cooking.

2.Use ordinary ** (except rock and dance music) to boil for 100-200 hours at medium volume, four hours as a group, and stop for about ten minutes before boiling.

3.It should be noted that it cannot be boiled continuously for a long time, and the burn-in machine pays attention to "asymptosis".

4.In fact, it's just like when you usually listen to **. Although it will be slower, the sound quality will gradually improve.

Useful, especially for good quality headphones.

Cooking headphones is like running in a new car, and the new ones sound a lot of stiff and unnatural, and there are more headphones to pay attention to....

Advantages: The edge of the diaphragm of the new earphone is relatively simple and tight, with large elasticity and small compliance.

Shortcoming. 1. Cook headphones, you can't use electronic ** pot, the bass component in electronic ** is too strong, and there may be overload for high-sensitivity headphones, causing irreparable physical damage.

2. You can't use a single frequency sound signal to test the headphones, especially don't use the low-frequency signal to measure, the human ear is very insensitive to the response of the low-frequency signal, such as the 20Hz signal If you can hear it, then the power of the headset must have been overloaded, and some low-power headphones are likely to have been burned out or the voice coil is deformed.