How do you remove the ironing line from your pants?

1. You can wipe the iron mark with water or gently apply it to the iron mark with organic solvent, so that the mark will not be so obvious;

2. Sprinkle some fine salt and rub gently;

3. Use a little baking soda powder, mix it with water to make a thin paste, and apply it to the iron mark to disappear;

4. Spray some vinegar on your clothes, after ten minutes, then cover with a damp cloth and iron it with a steam iron.

You can use a little baking soda.

Mix with water to make a thin paste and apply it to the iron print. You can also spray some vinegar on your clothes, after ten minutes, then cover with a damp cloth and iron it with a steam iron. Or spread out the shiny areas on your clothes and spray them wet with a watering can.

After soaking the cotton cloth in water and wring it out, change it to a shiny part, press it lightly with an iron and lift it immediately, and repeat several times until it is ironed.

If the condition is more severe, use a small amount of talcum powder on the surface of the garment, and after 5 minutes, turn the iron to steam temperature and smooth it with a cloth through the garment, and the garment will return to its original appearance. When using steam, the iron should not be in direct contact with the clothes, but should be a little away from the clothes, and spray the steam to the place where the mirror is raised, and directly restore it to normal.

If you want to remove the ironing line from your pants, you can take your pants to water and soak them again and wash them again. Just iron it out with an iron.

It can be re-ironed to remove, some water can be applied to the original creases, and some temperature can be raised according to the condition of the fabric. After doing this, repeat the process by flipping the garment over the front and the excess lines will be removed.

Remove the ironing line on the pants, then you can also wash the pants first, and then use the iron to iron the ironing line, and after a few times, you can remove the ironing first. Only the ironing line is still better-looking, at least it can make the pants look particularly upright.

When wet, start ironing slowly.

Preparation: scissors, small late tweezers.

Step 1: Use scissors to cut a hole on the periphery of the elastic band, preferably in the center, so that we can easily remove the elastic line.

Note: Pay attention to the size of the opening when opening with scissors, just the size of the elastic wire can be taken out.

Step 2: Hold one end of the elastic line with small tweezers and hold the end of the silver pants with one hand to prevent the end of the pants from sliding along with the elastic line.

Step 3: Gently pull the elastic cord out. (When you pull out a certain length, you can continue to pull out the elastic line directly by hand).

Step 4: Pull out the entire elastic thread. (Be careful not to forget to sew the initial opening together).

How to remove the thread of the pants:

1. Put the pants flat, hold the thread in one hand and cut the thread with the other, or cut the fastest directly against the pants.

2. Pick up the first few lines with scissors and then use them to pull, and you will be proficient in doing it a few more times, and you will find out the skills.

3. In the case of a lot of pants, there is a quick way to cut the thread, which is to fold the pants layer by layer, and the thread generally appears in the same place, and then this can be quickly cut one after another.