What are the skills for applying glue nail pieces?

Nail art is a very challenging fingertip art, and it is skillfully used by the nail technician to go from "no makeup" to "makeup after". Not only can it dress up your fingertips, but it is also very helpful to enhance the charm of women. Many nail art students have just joined.

Gamei. During the training, I didn't know the essentials of sticking nails, and it was very difficult to learn. Next, Shenzhen Red Makeup Chain Training School will accept the skills of how to apply glue nail pieces in nail art training.

1. Soak a cotton ball in nail polish remover and wipe off the nail polish that has been applied before. If you haven't wiped nail polish before, friends whose nails are in a "no-makeup" state can skip this step. Here nail art training should be reminded not to use makeup remover, as the residue will dissolve the glue.

2. Use nail tools to trim and polish the length of your nails. Grind until the nails are slightly rough so that the nail glue can be better bonded. Be careful not to sanded the nails too thin to avoid causing damage to the nails.

3. Select the nail piece that conforms to the length and curvature of your nails, and then polish and trim the nail piece to be used. 4. Apply the glue to the groove on the lower side of the nail piece. 5. Leave it on for a few seconds and insert the upper end of the nail into the middle of the nail.

Position the tip of the nail, apply slight pressure, and then adjust the position of the entire nail piece until it is in the right position, then press the tip and hold for at least 10 seconds. First, cover the selected nail piece over the nail cover, press the front end of the nail piece with your thumb to compare the curvature of the nail piece with the back edge of the nail, and then choose a patch that is slightly larger than the width of the nail. Sharpen the posterior edge and sides of the nail piece with a sand strip until it is the same curvature as the nail edge.

Gently grind the entire nail surface vertically with the thin surface of the sand strip, so that the nail piece does not leave a smooth surface. There is also a need to gently grind in one direction and clean the nail surface with a dust brush.

Many MMs like to buy their own transparent nails, paint them on the nails, and then stick them to their nails to look more beautiful, and they can also avoid the trouble caused by the bad shape of their nails. However, how to fix the nail piece and then draw a pattern on it. I have had several failed experiences of holding nail polish in one hand and applying nail polish to nail polish with the other, and the final result is that the nail polish is either not applied to the nail polish, or it is painted all over the hands, but I am reluctant to buy a professional nail polish holder with silver.

Step 1: Roll a piece of toilet paper into a roll, Step 2: Wrap double-sided tape around the paper rollStep 3:

Step 4 of the isolation paper to remove the double-sided tape: Stick the paper roll with double-sided tape on the foam board, or stick it on the cardboard, paper, table, etc., just don't get dirty Then stick the nail piece on the double-sided tape, and you can start to create on the nail piece, which will not rub on your hand, and will not be unevenly coated because it cannot be fixed.

Apply glue to the back of the nail surface, pay attention to the glue area similar to the nail surface, and the back edge of the nail piece should be coated with glue, otherwise it will be easy to warp. The next step is to press the posterior edge of the nail against the posterior edge of the nail to make it fit. Then gently press the nail plate against the nail surface and press firmly for 10 seconds, pressing the nail plate slightly with your thumb on both sides.

Therefore, Guangzhou Nail Art reminds everyone to pay attention when applying nail films. Clean the glue from the bottom of the nail, press the nail piece with your thumb, and then use U-shaped scissors to cut off the excess nail piece. After cutting, use the rough surface of the sand strip to grind the nail shape, and pay attention to the front end of the nail with the sand strip to grind the nail horizontally in a straight line.

Gently polish the nail surface with a sea file. The next step is to clean the nail surface with a dust brush. Then the nail surface is the bottom glue and dried with a phototherapy machine.

Add two layers of color glue, and after drying, apply a thin sealing layer to the nail surface.

Nail glue.

There is a special glue for nail art, which can be very strong to glue the nail piece, and sometimes it will also be used to stick the drill piece or other things, there are many different types on the market, but in fact, they are all very similar, the main thing is to see the brand clearly, choose a suitable brand.

When sticking nail pieces with nail glue, you must pay attention to the amount of glue not too much, don't worry about sticking it firmly and use a lot of stirring, and after applying, you must let it dry completely to avoid the nail piece and the nail between the nail piece and the nail is not compliant, otherwise it will be easy to fall off when doing other things.

Precautions for doing full nail patching:

1. After making a perfect nail, if the nail has the problem of warping, it needs to be repaired in time, if it cannot be repaired in time, you can apply a layer of bright oil on the warping place to avoid water infiltration and cause nail mildew.

2. Change those bad stress habits in life. Do not apply direct force with the tips of your fingers, otherwise the nails will break easily.

3. If you usually need to do housework, then in housework, it is best to wear gloves, avoid using alkaline detergent to make your nails yellow, and pay attention to cleaning your hands after doing housework, and keep your hands dry.

4. For those who travel frequently, it is recommended to be equipped with a sand strip at any time, when the front edge of the nail is scraped, the burr needs to be sanded with a sand strip to deal with it cleanly.

Step 1: Select the nail piece:

Select different models of nail pieces to put on the customer's nail cover, according to the size of the customer's nail cover to select the nail model that is close to the size of the customer's nails, the larger the nail piece, the smaller the model, generally choose the nail piece slightly larger than the customer's nail cover, which is convenient for later grinding.

After determining the size of the nail piece, use a sand strip to grind the back edge and both sides of the nail piece into a shape that fits the curvature of the nail edge.

2. After grinding the trailing edge of the nail piece, the entire nail surface of the nail piece is repaired, and the nail surface needs to be ground with a thin sand strip, so that the nail surface is rough and smooth, so that the nail polish glue is more obedient and durable, and it is not easy to fall off.

After grinding, you can first clean it with a dust brush, and then wipe it with a cotton pad.

3. Nail sticker:

After coating the back of the nail surface with nail glue, slowly push the nail piece from the front end of the nail to the back edge of the nail, pay attention to the speed of pressing must be fast, do not let the glue bubble, push to the back edge to make them fit and fit, press hard for 10 seconds without moving, and then press both sides of the nail cover with your thumb to make the nail piece completely fit the real nail.

4. After gluing the nail piece, according to the length desired by the customer, pinch the nail piece with the left hand and cut off the excess nail piece with U-shaped scissors, and then grind the nail shape suitable for the customer according to the customer's hand shape.

5. Use the thick side of the sand bar to grind the nail shape first, and you can polish the front end first and then polish the two sides.

6. Color:

First use the thick side of the sea file to gently polish the nail surface, then gently polish it with the thin side, and then wipe the nail surface with a dust brush, apply the bottom glue, shine the lamp, put on the nail polish glue, and make the style.

How to apply nail art films:1. Choose a nail piece with the same size as the nail, if there is a difference in size, choose the most similar one;

2. Soak your hands in warm water, apply the softening solution on the edge of your fingers, push up the dead skin with a dead skin pusher, and cut off the dead skin with special dead skin scissors; 3. Use a file to sharpen the nails and beat the surface of the nails.

4. Coat the trimmed nail piece with glue, press and push it from the fingertips and stick it to the nail;

5. Trim to the length you think is appropriate, polish the half-pasted place, mainly trim the thickness, feel flat, that is, trim it, and then trim the shape of the nail piece.

OK. The glue used to stick the drill can be applied to the nail piece.

The glue of the nail piece will not be completely solidified and hardened after the nail piece is pasted, and it is generally soft, and this degree of stickiness is very easy to remove. The adhesive will be completely hardened, and after hardening, it will be harder and more sticky. It does not come off easily for a long time, and its disadvantage is that it is not easy to remove.

The adhesive is to stick a small area of ornaments firmly on the nails, so the use area of this glue is not large, but if it is used on the nail patch, it will reflect its strong adhesion, for example, the nails and nail patches may be firmly glued together.

Even if it is difficult to remove it for a month or two, you can only wait for the nail to grow out slowly, and cut the nail art from the edge of the nail little by little, otherwise its stickiness is basically impossible to remove, because it is very firm and strong after sticking.

How to use the nail tablet

Ordinary nails are made of artificial nails and patches, and the specific treatment methods are divided into full stickers and half-stickers, and half-stickers are slightly more complicated than full-stickers. Generally, ordinary nail stickers can easily cause loss because of the mismatch between their own nails and nail pieces.

Nail extension is the use of nail extension paper tray and extension glue, only the nail extension part is made, and then plasticized with a phototherapy machine to achieve the visual effect of nail extension. The extension nail can be used for a longer time without being acted on by external forces.

It is possible to attach nail plates。Adhesive is a very sticky product, which can firmly stick nail nails to the nails, so for nail patches that have a large area of contact with the nails, they can be firmly glued to the nails.

For sticky drill glue, it does:Far more than just sticking nail nails, it can stick the nail patch firmly to the nail and will not fall off easily for a long time, but at the same time, it is also very difficult to remove. However, it is easy to remove for professional nail glue, because it does not completely solidify and harden after applying the nail piece, and it will retain some softness when used on the nail surface, and this degree of stickiness is very easy to remove.

In addition, if you choose to apply nail patches, you must use primer or sealing glue and reinforcing glue instead, these products are easier to remove for sticky drill nails, and you can directly use nail remover or nail polish remover to remove them, and they will not hurt your nails.

Nail film is very popular with many girls, and there are many ingenious girls who will choose to stick their own nail piece. Glue is usually used when applying nail pieces. So, how to dissolve this glue for nail stickers? Let's find out today.

You can wipe off the glue with an alcohol swab if it doesn't work. The second method is to prepare a basin of water, dissolve a little soap, and then put your glued hands in the basin and soak it for a while.

How to remove nail tablets without antidote for nail art.

Start by applying a thin layer of cleansing oil to the nail piece; Wait for about 3-5 minutes, and then use a hard object to directly frustrate, or directly use a fingernail to frustrate, and the nail piece can be removed. Nail polish has a corrosive effect on nail pieces and can break down the tightness of nail pieces, so there is no antidote and nail pieces can be removed with cleansing oil.

How long should the nail patch be removed.

It is best to remove the nail patch after a week, and if the nail patch is not removed for a long time, it may cause the nail piece to warp, the nail is too long and easy to break, and there will be a gap between the nail piece and the nail, which is easy to cause bacterial and fungal infection.

What is a nail art.

Nail art is a fake nail, which is generally made of plastic, and it is necessary to thin the nail and paste it with a fake nail made of plastic, and then apply nail polish on the fake nail for decoration and beautification. It should be noted that nail art pieces are not breathable, and it is very inconvenient to assemble and disassemble, and the nails will be seriously damaged when removing the nails, so they should be used with caution.

Nail film is very popular with many girls, and there are many ingenious girls who will choose to stick their own nail piece. Glue is usually used when applying nail pieces. So, how to dissolve this glue for nail stickers? Let's find out today.

How to dissolve the glue of the nail sticker.

You can wipe off the glue with an alcohol swab if it doesn't work. The second method is to prepare a basin of water, dissolve a little soap, and then put your glued hands in the basin and soak it for a while.

How to remove nail tablets without antidote for nail art.

Start by applying a thin layer of cleansing oil to the nail piece; Wait for about 3-5 minutes, and then use a hard object to directly frustrate, or directly use a fingernail to frustrate, and the nail piece can be removed. Nail polish has a corrosive effect on nail pieces and can break down the tightness of nail pieces, so there is no antidote and nail pieces can be removed with cleansing oil.

How long should the nail patch be removed.

It is best to remove the nail patch after a week, and if the nail patch is not removed for a long time, it may cause the nail piece to warp, the nail is too long and easy to break, and there will be a gap between the nail piece and the nail, which is easy to cause bacterial and fungal infection.

What is a nail art.

Nail art is a fake nail, which is generally made of plastic, and it is necessary to thin the nail and paste it with a fake nail made of plastic, and then apply nail polish on the fake nail for decoration and beautification. It should be noted that nail art pieces are not breathable, and it is very inconvenient to assemble and disassemble, and the nails will be seriously damaged when removing the nails, so they should be used with caution.