How to clean a range hood without dismantling?

Soap application method: add water to the broken soap block to make a paste, and then apply it to the surface of the fan blades and other parts, after the range hood has been used for a period of time, remove the fan blades and other parts, wipe it with a wet rag, and the oil stain will be off. Detergent, vinegar soaking method:

Remove the fan blades of the range hood, soak in a basin of warm water mixed with 3-5 drops of dish soap and 50ml of vinegar, soak for 10-20 minutes, and then scrub with a clean cloth. Enclosures and other parts can also be cleaned with this solution. This method has no damage to people and no corrosion to devices.

Pressure cooker steam flushing method: boil the cold water in the pressure cooker, remove the pressure limiting valve when the steam is continuously discharged, open the range hood, and align the steam water column with the rotating fan blade. As the hot water vapor is constantly rushing into the fan blades and other components, the oily water will gradually flow into the oil storage tank until there is no oil in the oil tank.

Place the jelly box: put an empty jelly box in the oil storage box of the range hood, after the range hood is used for a period of time, the oil in the jelly box is almost full, and a new jelly box is replaced. In this way, the oil storage box of the range hood will always be as clean as new.

No need to disassemble the machine: first take a plastic bottle (all kinds of beverage bottles that can be pinched flat by hand), poke more than 10 small holes in the lid with a sewing needle, and then fill it with an appropriate amount of cleaning detergent, and then fill it with warm water and shake it evenly. Then start the range hood and spray the cleaning liquid with a plastic bottle full of cleaning essence to the part to be washed, at this time, the oil and dirty water can be seen flowing into the oil storage hopper together, and it will be poured with the full.

After the cleaning solution in the bottle is used up, continue to prepare and repeat the cleaning. Until the dirty water flowing out becomes clear, depending on the degree of fouling, it can be rinsed after 3 times. If the fan blade is equipped with a grille, it is advisable to remove the grille first to enhance the washing effect.

Finally, use a rag to wipe the area around the suction port, the surface of the casing and the lampshade.

Clean the range hood without dismantling: use the cleaning box of the range hood to fill most of the box with warm water, and add an appropriate amount of detergent or special cleaning agent for the range hood. Note that the middle of the cleaning box is separated, and the clean water is installed on the side of the range hood with a cleaning head, and the other side is used to hold the dirty water after cleaning, don't install it in reverse.

Remove the oil tank, press the cleaning head, the cleaning head will stretch out, install the cleaning box, start the cleaning switch, as long as dozens of seconds, the cleaned sewage will flow to the container at the other end of the cleaning box, repeat the cleaning, and then clean it with clean water, after cleaning, wipe the surface with a towel, install the oil box, and the automatic cleaning will be over.

The method of disassembling and cleaning the Midea range hood is as follows:

1. Remember to unplug the power supply before disassembling the machine.

2. After unplugging the power supply, officially enter the disassembly process, first remove the "oil collection cup" at the bottom of the range hood, and the oil collection cup is more convenient to disassemble due to the use of buckle and thread.

3. Use a screwdriver to unscrew the funnel-shaped filter screws and remove them.

4. After disassembling the filter, the next step is to disassemble the coarse filter inside, also use a screwdriver to unscrew the screws at the three corners, and then remove the coarse filter.

5. The next thing to be dismantled is the fan inside, because the fan is embedded in the inside, so it is not very convenient to disassemble, the fan is tied with a large nut in the middle, and it needs to be removed by using a wrench or hexagon.

After disassembling the fan, there is only one driving shell left in the whole range hood, the filter screen and fan are the core parts of the range hood, and the filter screen can be cleaned with a special range hood cleaning liquid after removing the filter and fan. After the cleaning is completed, follow the reverse steps of disassembly and installation.

Maintenance of range hood air inlet hood:

1. You can first cover the stove with newspaper, turn on the range hood switch, spray neutral detergent on the range hood fan and let it stand for 3 minutes, then spray warm water into the range hood fan, let the dissolved oil flow into the oil storage box, and then clean the oil storage tank, and clean the fan about once a week.

2. Boil the water in the pressure cooker, remove the pressure limiting valve when there is continuous discharge of steam, open the range hood, and align the steam water column with the rotating fan blades.

3. Traditional detergent and vinegar soaking method. Remove the parts of the range hood that need to be cleaned, put them in a basin of warm water mixed with 3 5 drops of dish soap and 50 ml of vinegar, soak for 10 20 minutes, and then scrub with a clean rag.

1) Some range hoods are locked with screws! So use a screwdriver to pull the screws off;

2) Then shake it from side to side and pull the oil net down until it is removed;

3) The dismantled oil network and the oil collection basin below should be removed;

4) Remember to take the oil cup down as well. If there is oil in the oil collection cup, pour it out first, if it is already old and very thick oil, please wipe off the oil with a kitchen napkin first;

5) Spray the degreasing detergent on it (you can wrap the oil net with plastic wrap, so that the degreasing detergent can also be completely attached to the oil mesh, and you can decompose the grease) After waiting for 20 minutes, pick it up and brush it slightly, if the grease is a little heavier, wait for another 15 minutes, you can open it and spray the detergent to strengthen it and wait for another 15 minutes!

6) After soaking for 20 minutes, pick it up and gently rub it with a vegetable melon cloth, and the grease will easily fall off;

7) At the end of the day, don't forget that the switch will be oily too! Also remember to remove the oil;

8) Install the cleaned oil net and oil cup.

1. The main thing is to clean the filter screen, remove the fan blades when cleaning, put it in warm water with detergent, soak it for a few minutes, and then gently wipe off the oil stains on it with a clean cotton cloth.

2. The range hood needs to be deeply cleaned after 6 months of use, and this cleaning can be cleaned by professional personnel, and the masters have professional skills and professional tools. Usually, they will first use a high-temperature and high-pressure cleaner with a high-efficiency and environmentally friendly cleaning agent to clean the grille, wind wheel, shell, etc. of the range hood in an all-round way to completely remove the internal and external oil. Then remove the turbine, soak it in a professional cleaning agent, and then spray the high-temperature vapor into the oil tank with a high-temperature and high-pressure sprayer for 3 minutes, and use a special shovel to shovel out the thicker grease.

It is safer to ask a professional to clean this.

<> solution to the range hood without removing it for washing: 1. Pressure cooker.

Steam method. Boil a basin of hot water in a pressure cooker, open the valve, let the steam align with the oil mesh in the filter of the range hood, dissolve the oil mist on the surface with the hot gas, prepare a bowl to catch the leaking dirty water, and finally wash it with clean water.

2. Clean frequently. After each cooking, carefully clean it with a rag with detergent so that the hood will not have a thick grease stain.

3. Special kitchen grease cleaner. Spray the oil mist on the range hood, and the oil will dissolve after a few minutes of morning bell, and wipe it with a rag, and it will be very clean.

4. Dish soap.

Vinegar soaking method. Remove the leaf surface of the range hood, soak it in warm water mixed with 3-5 drops of dish soap and 50ml of vinegar, soak for 10-20 minutes, scrub with a rag, and other parts can also be used in the same way.

Mother's Day cleaning home this range hood with automatic cleaning function, there is still a lot of sludge on the impeller, and it is still very necessary to disassemble and clean it regularly.

No. Because without disassembling the range hood, there are some places inside the range hood that cannot be cleaned.

Yes, there is an oil groove under the current range hood, and you can take the oil groove down and clean it.

If you don't disassemble the hood, it's just the surface that washes, and the grease inside can't be washed off, so it's best to remove it and wash it cleanly.

Range hood is an important piece of equipment in the kitchen, which is used to maintain good indoor air quality and ensure the hygiene of the kitchen environment and the quality of food prepared. However, after the range hood is used for a period of time, the oil smoke and dust will be deposited on the fuselage and oil mesh, and it needs to be cleaned. Below the sail book, a cleaning method for the range hood is introduced.

1.Prepare cleaning tools.

To clean the range hood, you need to prepare the following tools: orange peel, vinegar, small brush, clean rag, water, alcohol.

2.Remove the oil net.

First of all, the oil mesh on the range hood needs to be removed for cleaning. Generally speaking, the oil mesh can be rotated clockwise or counterclockwise to untie, and some need to be taken out from the middle, depending on the design of the range hood and the manufacturer's instructions.

3.Clean up oil and dust.

After cleaning the oil net, you can use orange peel and vinegar to clean the oil and dust from the range hood body. Tangerine peel has a deodorizing and sterilizing effect, and vinegar has a cleansing, decontamination and deodorizing effect. Soak the orange peel in vinegar for a few minutes, then place the soaked orange peel on a range hood and wipe it.

You can use a small brush to clean the hard-to-clean areas.

4.Soak the oil mesh in the cleaning solution.

Soak the oil mesh in a cleaning solution and let it soak thoroughly, so that the oil and dust will be easier to clean. In general, cleaning solutions can be made by mixing alcohol and water.

5.Use a high-pressure water gun to clean the oil net.

After soaking the oil mesh for a period of time, rinse it off with a high-pressure water gun. The high-pressure water gun can thoroughly clean oil and dust. Remember not to directly rinse the body of the sedan with water, otherwise it will affect the service life of the machine.

6.Soak and wash the oil mesh repeatedly.

If the oil and dust are more severe, you can soak and clean the oil mesh several times until it is clean.

7.Wipe clean.

Wipe the cleaned oil mesh with a cleaning cloth, wait for it to dry completely, and then put it back into the range hood.

In short, cleaning the range hood is an important part of maintaining the kitchen environment and the service life of the kitchen equipment. By cleaning the range hood through the above methods, you can keep the range hood in good performance and ensure the cleanliness and comfort of the kitchen.

Range hood is one of the important appliances commonly used in our family kitchen, but in the process of long-term use, it accumulates fumes in the kitchen on the surface, and simple wiping and cleaning cannot solve the problem. Therefore, we need a more in-depth cleaning method to remove the smoke mass from the range hood.

The following is the cleaning method without disassembling the range hood:

1.Wipe the surface with a clean, damp cloth.

First, take a clean, damp rag, wring it out and wipe the surface of the range hood vigorously. This removes some of the fume dirt and gives the hood a new look.

2.Soak with degreaser or cleaning powder.

Then, use a degreaser or cleaning powder to soak the desired wipe area. Let it soak for a few moments, usually in a few minutes to break down the grease that has accumulated over the years.

3.Wipe the range hood cleaning brush.

Next, use a range hood cleaning brush to wipe the surface of the range hood, taking care that the brush head is not too hard or too sharp to avoid scratching the surface. Care should also be taken to avoid excessive wiping, which can wear and build up dirt on the fumes that adhere to the surface.

4.Rinse the surface with wash water.

Finally, rinse the surface of the range hood with clean water and wipe it dry with a rag.

In general, these cleaning methods can help us clean the surface of the range hood without disassembling it, which can also work more efficiently. Be sure to pay attention to safety and hygiene, so as not to cause harm to the human body caused by the accumulation of smoke and dirt.

Good afternoon! Take a plastic bottle for you (all kinds of beverage bottles that can be pinched flat by hand), poke more than 10 small holes in the lid with a sewing needle, and then fill it with an appropriate amount of detergent, and then fill it with warm water and shake it evenly. 2.

Start the range hood and spray the cleaning liquid with a plastic bottle full of cleaning essence to the part to be washed, at this time, you can see that the oil and dirty water flow into the oil storage hopper together, and pour it when it is full. 3.After the cleaning solution in the bottle is used up, continue to prepare, repeat the cleaning, until the dirty water flowing out becomes clear, and then judge the degree according to the fouling process, generally clean 3 times can be rinsed.

4.If the fan blade is equipped with a grille, the grille should be removed first to enhance the washing effect. 5.

Use a rag to wipe around the intake port, the surface of the casing, and the lampshade.

Range hood is one of the must-have small appliances in our kitchen, which can effectively absorb and filter the oil smoke and odor generated during cooking, and keep the air in the kitchen room fresh. However, long-term exposure to fumes and steam inside the range hood will cause a large amount of oil to accumulate inside, affect the suction effect, and increase the risk of kitchen fire. So, how to clean the inside of the range hood without disassembly?

1.Use a range hood cleaner.

There are some cleaning agents on the market that are specifically used to clean range hoods, which can effectively remove oil stains that accumulate on the inner wall of the range hood. The method of use is to spray the cleaning agent on the inner wall in the state of shutdown, and let it stand for a period of time, and then rinse it with clean water to search for light. It should be noted that after using the cleaning agent, it should be cleaned in time to avoid damage to health caused by residues.

2.Use acidic liquids.

Acidic liquids such as vinegar or citric acid are effective in softening the oil, dissolving it and removing it quickly. To use it, add vinegar or citric acid to clean water, apply the mixture to the inside of the range hood, and let it stand for a period of time before rinsing it off.

3.Routine cleaning.

Frequent daily cleaning is also an effective way to keep the inside of your range hood clean. After each cooking, wipe down the hood housing and hood, as well as the removable filter, with a damp cloth. To clean the filter, you can soak it in warm water with dish soap and brush it, but avoid damaging the mesh with too much force.

Huyan. It should be noted that the range hood must be turned off when cleaning, and it must not be operated in the turned on state to avoid causing dangers such as electric shock. In order to ensure the cleaning effect and health and safety, it is recommended to carry out deep cleaning of the inside of the range hood every 6 months or so, or disassemble and clean it by professionals.