May I ask if the iPhone4s got into the water, but after repairing it, what happened to the flickerin

Updated on number 2024-08-06
28 answers
  1. Anonymous users2024-02-15

    This splash screen has nothing to do with your phone's water repair. It's just that there is a problem with the software, or the signal is not good, you reinstall it, and find a place with a good signal.

  2. Anonymous users2024-02-14

    Water leaked into the LCD screen.

  3. Anonymous users2024-02-13

    It should be the hardware is broken.,I'm all of the system.,I can't turn on the machine recently.,When it's open, it's been flashing.,Spend some money to change the hardware.。

  4. Anonymous users2024-02-12

    iphone4 is in the water, the screen keeps flashing, you should immediately turn off the phone and then deal with it:

    1. Apple has a water ingress protection mechanism, and it can't be turned on if it doesn't dry out, so it is recommended not to turn it on immediately, put the phone in a rice bag to continue to absorb water, and wait for it to dry completely before turning it on.

    2. Too much water may cause the motherboard to burn out, for this case, it is recommended to send it to the mobile phone store to replace the motherboard.

  5. Anonymous users2024-02-11

    Problem type: battery, the screen is blown by a blow blower, it can't be turned off, the screen keeps flashing!! Press the force to turn off as much as possible, don't move it, wait for it to dry, the iPhone can't pick the battery and it's dangerous to remove the back cover to remove.

  6. Anonymous users2024-02-10

    Turn off the phone first, go to a professional repair point to clean the phone, pay attention, the professional is cleaned with dehydrated substances! The sooner the better, and the longer it drags on, the less likely it is to be fixed.

  7. Anonymous users2024-02-09

    Take it apart and dry it first, but don't put it in the sun, and then try again, if it doesn't work, you'll have to fix it!

  8. Anonymous users2024-02-08

    Unplug the battery first, then disassemble the phone, and dry the water on the motherboard.

  9. Anonymous users2024-02-07

    Landlord, did your phone get better?

  10. Anonymous users2024-02-06

    After the phone accidentally gets water, it is recommended to do the following:

    1. First of all, the mobile phone should be salvaged as soon as possible, and if the battery can be removed, the battery should be removed immediately to prevent short circuit; At the same time, it is better to remove the SIM card so as not to lose the contact information. The longer it stays in liquids, the more damage your phone will suffer for life.

    2. If the phone falls into salt water, not fresh water. Salt water forms a "salt crust" in the phone's internals. If your phone has fallen into seawater or other salty water, you need to rinse it gently with fresh water – after removing the battery and SIM card, and before the drying process begins.

    4. Wipe every part of the phone with a cloth or paper towel, and don't move or shake the phone too much to avoid water swimming everywhere inside the phone.

    5. Try wrapping your phone in a cloth or paper towel for a few minutes to absorb excess moisture. Turn on the cool air setting of the hair dryer and blow at the hole of the mobile phone about 30cm away from the mobile phone for at least one hour.

    6. Finally, wrap the phone in a paper towel and put it in a jar or bag full of rice for at least 24 hours, during which time it cannot be turned on. Rice absorbs water very well and can save a damp phone.

    7. The above is only a salvage measure, if there is still a failure, please go to the after-sales maintenance.

  11. Anonymous users2024-02-05

    In this case, it is recommended not to send it for repair, after the mobile phone is turned off, seal it with a plastic bag and put it in the rice cylinder, put it for 2 days and take it out to see if it is normal or not, if it is not normal, then consider sending it for repair, according to the hardware that has the problem** is not the same, but you can get this problem by visually up to 500.

  12. Anonymous users2024-02-04

    Have experience in dismantling the machine, first of all, disassemble the machine, and then remove the LCD, clean the LCD cable seat with Tianna water or more than 95% alcohol After cleaning, check whether there is a blackened breakdown of the resistance capacitor, if not, then after the cleaning is completed, the installation test, whether it is normal, if it is normal, if it is normal, it is generally the LCD because of the backlight illuminated by the water has a problem

    Hope it helps.

  13. Anonymous users2024-02-03

    Check whether there is a short circuit in the cable of the inner screen, if there is no short circuit in the motherboard, replace the inner screen.

  14. Anonymous users2024-02-02

    Anyway, you finally fixed it, and I'm in the same situation as you. It's also yesterday when the water went into the water and then it was super dark.,There's a reaction to turn on or something.,I don't know what to do.。

  15. Anonymous users2024-02-01

    Change the screen, and the original ones are more than 300.

  16. Anonymous users2024-01-31

    Put it in a rice bucket. It's no joke.

  17. Anonymous users2024-01-30

    I'm just like you, I'm struggling, you said if it's all water stains, can you keep using it forever?

  18. Anonymous users2024-01-29

    Don't try to boot up, you can follow the steps below.

    Step Method.

    1. Don't try to turn on or charge the computer if it gets into the water, because the iphone has a built-in battery that can't be removed, and the motherboard will be short-circuited if the water is ingress, and if you turn on or charge it, the motherboard will be burned, causing irreparable consequences.

    2. First wipe the water outside the phone with toilet paper, don't shake it hard (the water is flowing and will get the water on the water), and then put the phone screen down.

    3. Place it horizontally (to prevent water from flowing to the motherboard), and then blow dry the water with a blower. The wind is open to the maximum temperature and the temperature is medium. (Blow for about 20 minutes).

    4. Find a repair center that specializes in iPhone repair as soon as possible. iPhone4s is turned on in the water, it is best to go to the iPhone repair shop to see, or something will go wrong in the future. It shouldn't be much to repair the boot.

  19. Anonymous users2024-01-28

    Turn off the device and make sure it is dry before turning it on.

  20. Anonymous users2024-01-27

    Mine too, the third time it won't flash, I just bought it, it should be fine.

  21. Anonymous users2024-01-26

    My phone has the problem of receiving ** screen flash, how to solve the problem of prawn door? Is the phone broken?

    Yesterday I fell into the water, and there was no response when I turned it on, so I used the sun and a hair dryer to blow wildly, and it turned on after 12 hours. Everything is normal to surf the Internet, play games, take pictures is no problem, the screen flashes differently when you pick up ** in the morning, and the same is true for **, is it broken? Short circuit or what's going on?

  22. Anonymous users2024-01-25

    Don't talk nonsense if you don't know what to say'First of all, don't worry too much'This is a common problem'Mine is the same'I also called ** to ask the customer service'It may be that I have a problem upgrading the system'I'm literate'The building is mainly upgraded if it is over'You can go and restore it again'This does not affect the use'The watchtower lord adopted.

  23. Anonymous users2024-01-24

    There is a problem with the system, that is, the software. It is recommended that the manufacturer flash the machine there.

  24. Anonymous users2024-01-23

    It's either a system issue or a hardware issue. Check the phone again, if it's still flashing, flash the phone. If you can't flash the machine... I can only go to repair...

  25. Anonymous users2024-01-22

    How to dodge? Is it on all the time?

  26. Anonymous users2024-01-21

    Just throw a few times to the ground and you'll be fine. Mine used to be like that.

  27. Anonymous users2024-01-20

    Apple4S screen flickering screen This situation is generally caused by plug-in conflicts,You should uninstall the software installed before the splash screen one by one,See if you can solve it。 It shouldn't be a hardware issue.

  28. Anonymous users2024-01-19

    If you don't know how to connect your phone to a computer, you can go to the place that sells Apple phones outside and let them help you get it. If it is still like this after recovery, it means that it is a hardware problem that needs to be repaired. As explained in advance, after the restoration, the phone will be automatically updated to the latest version, that is, it cannot be jailbroken.

Related questions
24 answers2024-08-06

The iPhone 5 is still a floating cloud at the moment, so you don't need to pay attention to it. >>>More

18 answers2024-08-06

My phone is iphone4s Hong Kong line I ordered the automatic upgrade myself this morning, now let's talk about the feeling: >>>More

3 answers2024-08-06

One: The easiest way to identify whether it is a real Apple is to: press and hold the home button (the one in the middle garden below), and then click the power switch (upper right corner), you will hear a "click" camera shutter sound, this is the iPhone screenshot function, you can see the screenshot there in the film (cameraroll) in the photos (photos). >>>More

30 answers2024-08-06

Access to the network to send phone bills must be bought on the spot Unicom machine, before you can make a contract, if you directly apply for a 3G number to use, there is no phone bill! Unicom iphone4s contract plan is like this, for example, you choose a three-year Unicom 4S contract machine 16GB 286**, the contract price is 5880 yuan, in these three years36 months, Unicom will return you 163 yuan every month, in order to make up for the 286 minimum monthly consumption, you also need to pay 123 yuan per month, three years you need to pay a total of 36 times 123 4428 yuan, so your total consumption for three years is the contract price of 5880 yuan 4428 yuan 10308 yuan, In the past three years, you can enjoy 850M traffic usage and 700 minutes of national call time every month, in fact, Unicom contract machine is quite cost-effective. Details: Hangzhou Xiasha Duolan Waterfront No. 108 Unicom 3G store.

32 answers2024-08-06

The reasons for iPhone4S automatic restart are as follows: >>>More