I want to make the stick long, it s a round stick, how do I splice the round stick?

To splice a round wooden stick, you can do it by following these steps:

1.Place two sticks on a flat surface, such as a tabletop or workbench.

2.Apply glue or woodworking glue to the ends of both sticks to enhance the adhesive force.

3.Align and press the ends of the two sticks together, making sure they fit snugly.

4.Use clamps or clamps to secure the ends of the two sticks to ensure that they do not move during the drying process.

5.Allow the glue or woodworking glue to dry until it becomes firm.

6.Check that the splice is flat, and if needed, you can use sandpaper or a grinding wheel to sand to ensure that the splice is smooth.

7.Finally, place the spliced round wooden sticks in a ventilated and dry place and let the glue or woodworking glue dry completely.

Please note that you should pay attention to safety when splicing to avoid injury. At the same time, appropriate tools and materials are used to ensure the quality and effectiveness of the splicing.

It depends on what your round stick is used for and what the requirements are for the reliability of the splicing

1. If it is a simple connection, flatten the plane of the two sticks and glue them;

2. The outer ends of the two round sticks are linked with curiums;

3. Use a plastic sleeve to cover the broken part (the two ends are appropriately extended and sleeved together);

4. Wrap it with a cloth strap and so on.

Long before bai, there was a kind of carpenter called "spin craftsman du", who specialized in making "rolling pin" dao

Round utensils such as "mallets" and "table legs". A "bed" is made of wooden squares, with a "tip" at each end, to hold a wooden square of appropriate length and thickness. Wrap the string of a "bow" around a few times, pull the bow back and forth, and the wooden square will rotate back and forth.

There is also a "knife holder" used to stabilize a "rotary knife", the right hand of the spinners pulls the bow, and the left hand moves the rotary knife, and the wooden square will be "rotated" into a circle.

There are several kinds of rotary cutters, wide, narrow, oblique, and semicircular, which are used for different processing methods.

The spinners can also make chess pieces and engrave letters, and their skills are superb.

Later, electric machines appeared, and the "lathe" was withdrawn from the stage of history.

In the absence of a lathe, milling square wood with a milling cutter to make a round log stick is a very efficient method, and here I offer a corrective approach.

1 It is better to install a protective device on the top of the milling cutter, the plexiglass part in the figure.

2 When preparing the square strips, leave a rich length of about 4 inches (100 mm) more than the required length for each one.

3. Stick a piece of adhesive tape on the left part of the hill 2 inches away from the edge of the cutter as the starting position of the square wood strip through the milling cutter.

4. On the right part of the hill 2 inches away from the edge of the cutter, also paste a piece of adhesive tape as the stop position of the square wooden strip milling cutter.

5 When the four sides of the square wooden strip have been knifed, the square part on both sides of the knife can be sawed off, so that the danger is reduced.

To make round sticks, to use.

The tool is a lathe.

The lathe is a woodworking tool, and its function is:

The plate is used to process round weight things. With a rotary lathe, round wooden tables, wooden legs, wooden spinners, rolling pins, and other round wooden pieces can be made.

The picture below shows the lathe**:

Woodworking lathes can be turned out.