How to remove garbage about the shower?

1. Soak white vinegar in water.

When carbonates accumulate too much in the water, they become limescale and clog the shower holes, and the best way to deal with carbonates is to neutralize them with acid. White vinegar and water in a 1:1 ratio, soak for 3-4 hours to see results. Be careful not to use strong acids, which will corrode the metal material of the nozzle.

2. Dismantle the nozzle for cleaning.

Some stubborn stains are not easy to get stuck in the nozzle hole, but in a deeper place. Then you need to remove the shower head for cleaning, gently shake the nozzle downward, pour out the debris, and pay attention to the removal and installation.

3. Use small objects around you to clean up.

The above method requires the use of a disassembly nozzle, which is more troublesome. We can make use of small objects around us, such as embroidery needles when sewing. Pierce the pillow into each outlet one by one to make the scale fall off the inner wall of the outlet hole, and then pour water from the inlet into the sprinkler.

In addition, you can clean the surface of the shower with a toothbrush that you don't use.

In addition to cleaning the shower when it is blocked, you should also pay attention to the daily maintenance of the shower, otherwise no matter how good the method is, it will not be able to "make up for the loss".

1. The ambient temperature should not exceed 70 degrees Celsius. Try to stay away from heat source appliances such as bath bombs, otherwise it will accelerate the aging of the shower and shorten the service life of the shower.

2. When opening and closing the shower faucet and adjusting the water outlet mode of the shower, do not use too much force, just turn it gently. Even a traditional faucet doesn't require a lot of effort. Special care should be taken not to use faucet handles and shower brackets as handrails to support or use.

3. The shower should be cleaned at least once every six months. On weekdays, often wipe the surface of the shower with a soft cloth dipped in a little flour, and then rinse it with water to make the surface of the shower as bright as new.

Four Seasons Muge after-sales service can help you clean up, and how long the shower lasts.

We didn't usually clean it because the shower was good every day, so it didn't occur to clean up. I think it's probably just a few turns and boiling water.

The exterior is wiped with a soft cloth, and the inside is best removed and cleaned at intervals.

Take off the nozzle and soak it in vinegar for half an hour, use the water pressure impact of the water pipe, basically it can be cleaned up, when the water is impacted, the function key on the nozzle should be changed, otherwise the cleaning effect is not good enough. The shower needs to be cleaned when it is blocked, and the refined shower has a small metal filter, remove the sprinkler to remove the mud and sand, and the scale that has been stuck on the shower for a long time is rinsed with vinegar soaked in water. If the problem is serious, you should ask the maintenance personnel to do it.

1 Automatic cleaning. In order to avoid clogging the outlet due to poor water quality, many showers are equipped with an automatic limescale removal function. For example, some showers are equipped with cleaning needles inside, and when the water discharge method is changed, the cleaning needle will automatically pop out and bring out the scale.

2 Hand wipe cleaning. The spout of this type of shower is made of rubber granules, which is soft and comfortable to the touch, and is not easy to scale and easy to clean. You only need to rub the rubber particles with your fingers, and the scale can be easily crushed and popped.

This cleaning method makes good use of the characteristics of the material and is a popular cleaning method for showers in the market.

3 Manual cleaning. Remove the grille or other limescale absorbing parts from the shower head, clean it with a brush and then put it back in place. Some brands of showers are specially equipped with professional shower head opening tools when the first time is convenient for consumers to use.

In addition, the shower can be removed by immersing the shower in a solution of white vinegar and water for an hour.

1. Dismantle according to the structure of the shower.

There are too many types and styles of showers, generally speaking, as long as it is not a disposable shower, it can be disassembled, mainly according to the specific structure of the shower head, most of them only need to be removed by hand in the counterclockwise direction, without the need for tools.

2. The shower can adjust the size of the water outlet.

The structure of the rain shower head is composed of a water outlet cover and a handle, if it is a shower head that can adjust the size of the water, there is a software circle in the middle, hold it firmly, and then rotate it counterclockwise (or clockwise) to disassemble.

3. The shower with the size of the water output cannot be adjusted.

If it is a shower head with a non-adjustable water size, most of them are welded with plastic and basically cannot be disassembled. However, if there is a small round cover in the middle of the shower head, pry open this small cover with a flathead screwdriver, you can see the screws, and you can remove the shower head with the corresponding screwdriver.

Cleaning method: 1. Manual cleaning:

Remove the grille part from the shower head, clean it with a brush and put it back in place. Some brands of showers are equipped with special shower head opening tools when the first time, which is convenient for consumers to clean and use.

2.Hand wipe cleaning:

The spout holes of these showers are made of rubber granules, which are very soft and comfortable. Simply rub the rubber particles with your fingers to easily crush and pop the limescale. It is a more popular cleaning method on the market now.

The most likely problem of the shower is the blockage of the outlet hole, the general cause of the blockage of the outlet is due to the use of the shower for too long, so talk about the scale removal of the water outlet hole blockage, there are also because the water contains impurities will block the outlet, but generally this situation does not occur. In order to avoid clogging the shower during bathing, it is necessary to clean it up after a period of use (usually three months or half a year). When disassembling, you need to understand its internal structure, if you don't understand, you can check the instructions or ask the party.

After disassembly, take out the screen cover in the shower, clean up the impurities, and then prepare a pot of diluted white vinegar, put the shower into it to soak for a period of time, and then clean it with a toothbrush or a soft brush, and do not use hard objects such as steel wool balls to forcibly wipe it. If you encounter stains that are difficult to take out, you can cut a piece of fresh lemon slices to wipe the stains, and do not soak and clean with strong acid liquids, so as not to corrode the shower containing plum dates.

When using a shower, you should also pay attention not to bend or even damage the hose connected to the shower, and you should not use too much force when using the switch. Do not use strong acid to remove limescale to avoid corrosion on the surface of the shower. Do not wipe the surface of the shower with hard objects such as steel wool balls to avoid scratching the surface of the faucet.

Do not forcibly disassemble the shower for maintenance, improper disassembly will cause damage to the appearance and internal structure of the product. The shower is a small part of the bathroom utensils, but if there are problems such as blockage, it is still a tricky problem, especially in the middle of the bath, so it is necessary to clean and maintain it in a timely manner, so that you can enjoy the bath with peace of mind.

It is natural for the shower head to be clogged after a period of use, which does not mean that the shower head is broken, which is mainly due to the fact that the scale has blocked the spray hole of the shower after long-term water discharge, and the shower head needs to be disassembled and cleaned. Disassembling and cleaning is actually very simple, it does not require you to completely disassemble the shower head into pieces, the most important thing is for you to clean the shower head. The best ingredient for cleaning shower heads is edible white vinegar, which is a cooking ingredient that has been kept by families for generations.

After we remove the shower head, put the lead celery hall into a small basin filled with white vinegar and soak it for about two hours, brush it with a toothbrush after soaking, and then wash it with water; If there is hard water sediment, you can scrub it with lemon slices. To clean the shower head, special attention should be paid not to use strong acids (preferably white vinegar) to avoid corrosion on the surface of the shower. In order to ensure that the shower head is not blocked, we can clean the shower head every six months or a shorter time, so as not to suddenly block the shower head when bathing, which will affect the mood of bathing.