What s going on with the blue sky fire host reporting the blue smoke sensor

Fire-fighting equipment increases the alarm point, from the nearest loop alarm connection line to connect the new equipment, the equipment adopts encoder coding, the host needs professional and technical personnel programming to meet the use of the function, only the code is not programmed can not participate in the system linkage.

It should be a virus in the fire host system.

The customer service didn't talk nonsense and asked for my name and ID number directly, and told me in less than 5 seconds that my account has been locked now, so don't worry, and the relevant details will be called to tell me. At the time I thought they were playing on me, and I was angry.

Is it a fault or a fire alarm, the fault may be broken, the fire alarm jiushi false report, install an isolation module will not be falsely reported.

It shows that the smoke signal that has been detected by the smoke detector is an alarm to the host.

Most of them are false alarms, check the faulty probe and clean it. If you report it again, you will get a new one.

This is caused by the disconnection of the main circuit, or the operation of the isolator.

Loop information is lost (mostly due to line short-circuit isolation module operation).

Loop information failure (part of the detector itself is faulty or all faulty, and all open lines are offline).

Fluctuation of loop information (detection itself fault, low line resistance to ground or grounding, etc.).

Hello! The smoke sensitivity has been set at the factory, and the user cannot adjust it by himself.

The reason is generally the aging of the equipment and the failure of the equipment. It's normal, and then change it after the encoding is consistent.

When there is no fire alarm, the detector also has an alarm, and the so-called false alarm rate is normal.

Smoke is being copied.

Often, smoke will be reported.

When the air flow of other zhi passes through the smoke detector, the smoke detector will be mistaken for smoke, which will cause an alarm, because this sensor is sensitive to very small smoke particles, even if it is a particle that cannot be seen by the human eye. There are also gases such as water vapor that can also cause smoke alarms.

You can take off the smoke sense of the false alarm, use a slotted screwdriver to warp it open, clean up the inside of the black cover, blow it clean with a dry cloth or hair dryer, and then press it, it should be able to solve, if it doesn't work, change the smoke sense, pay attention to the code must be adjusted correctly with a coder when changing, if it is the kind of manual code pulling, the number is directly pulled out and the one that is taken off is the same!

Someone upstairs said that they would first block if they found a false positive, and I would like to say my personal opinion.

False alarm: false alarm fire alarm signal, false alarm fault signal, whether it is a fire alarm or a fault, the cause should be identified, and it should not be easily blocked.

If it is a fault, it is necessary to find out the cause and repair it in time, and it really cannot be repaired immediately, such as the "smoke detector" is broken, and there is no spare one, and it will not be found for a while, at this time, you may first "shield" it, make a record (even if the fire department suddenly comes to check, we can also say one, two, three), run it in the background, and the display screen shows the status of "system running", and then replace it with "unshielding" in time after buying it back

Smoke, fog, and dust can cause smoke detector alarms, and when there is a failure, the host will also alarm.

The smoke detector generally does not alarm, its function is only to detect, and then feedback the signal to the host. If there is a smoke alarm on the host, there are many reasons, too much dust on its own, false alarms, line problems, false alarms, etc. If you determine a false positive after actually viewing it, block it on the host first.

If this automatic fire alarm system needs to increase detectors such as smoke detectors or other alarm equipment, it is necessary to connect the encoded equipment from the spare return line, and then program the connected equipment address in the host, and do a good job of logical relationship diagram, otherwise it can not be used normally.

How to operate Chinese characters when programming.