How to drive a car Steps to drive are introduced

Updated on Car 2024-08-15
8 answers
  1. Anonymous users2024-02-16

    The basic steps to drive a car are as follows:

    First, before driving, walk around the car to see if there are any special circumstances. Once in the car, adjust the seat position and the angle of the left and right mirrors according to your physical comfort.

    Second, fasten your seatbelt after adjustment.

    Third, step on the clutch brake and hit the left turn signal.

    Fourth, hang up and start slowly, observe that there are no vehicles and pedestrians within a certain distance behind, and drive into the lane.

    Extended information: Start taboo.

    1) A bogey has an unsteady start. Start-up is the first step in driving the vehicle. In the normal start, it is required to start smoothly and safely, drive in a correct position, and do not look down at the machine parts, and look ahead and on both sides of the road. When starting, it is required that there is no forward rush, shaking, flameout and intermittent arching.

    2) Second, avoid choosing an inappropriate gear for the start. The selection of car gears depends on the specific conditions of the car, road and slope. Generally, on a flat and solid road or field, you should choose 1st or 2nd gear to start; If you're in cold climates, soft soil, or uphill roads, you'll have to use first gear to start; On snowy and muddy roads, you have to start in first gear.

    At the same time, remove snow and mud from under the wheels or sprinkle sand under the wheels.

    3) Three taboos: improper coordination of the clutch pedal, accelerator pedal, and brake pedal when starting. This fit must be skillful.

    4) Four taboos: Put your left foot on the clutch pedal after starting or forget to release the parking brake lever when starting. These are often mistakes that newbies tend to make.

    5) Five taboos. I started without seeing my surroundings clearly. Make sure there are no people or other obstacles around the vehicle, and there are no cars coming from the front, rear, left, right, and left, and then honk the horn to start.

    6) Six taboos: car failure to start or insufficient engine oil and coolant to start, not all license plates on the road. Parking:

    Release the throttle, slowly apply the brakes, shift the gear lever to neutral, and pay attention to the brakes in advance. For example, when you see a red light ahead, you should be prepared to stop in advance and minimize sudden braking.

  2. Anonymous users2024-02-15

    1. After getting on the bus, the first step is to adjust the seat. Move one of the handles under the seat and pull it up to move the driver's seat back and forth. There is a round lid at the angle between the backrest and the cushion, which can be twisted to adjust the angle of the backrest.

    2. After adjusting the seat, fasten the seat belt. Press the clutch (i.e. the leftmost pedal on the sole of your foot) all the way down, hang the gear lever in neutral, and twist the key to the left and then to the right to set the car on fire. When the engine starts, hold the steering wheel with both hands at 3 o'clock and 9 o'clock.

    3. Before the vehicle starts, press the horn to remind passers-by, and see if there is anyone left and right. When it is safe to do so, turn on the left turn signal and put up first gear (i.e. push the gear lever to the left front. There are position indications for each gear on the gear lever), slowly loosen the clutch to let the car start slowly, and cross your hands on the steering wheel to drive the car from the curb to the driveway.

    4. Pay attention to the clutch can not be loosened too quickly, otherwise it will cause the vehicle to stall. Once the vehicle is fully seated in the lane, turn off the turn signal, straighten the steering wheel, and slowly press the accelerator. The throttle is "gently pedaled and lifted". As you step on the accelerator, the speed of the car starts to increase.

    5. When the speed reaches 20 km/h, release the throttle, press the clutch to the end, hang the gear lever to 2nd gear, then release the clutch and step on the throttle lightly; When the speed reaches 30 km/h, release the throttle and press the clutch all the way down, hook the gear lever to 3rd gear, then release the clutch and press the throttle lightly. And so on.

    6. When you need to pull over, hit the right turn signal to see if there are vehicles and pedestrians in the rearview mirror. Once you're sure it's safe to do so, slowly apply the brakes to slow down the car and press the clutch with your left foot. Cross your hands and hit the steering wheel to the right, then hit the steering wheel to the left to straighten the direction.

    Once the car is fully parked, put the gear lever in neutral, release the clutch and brakes, turn off the turn signal, and pull the handbrake up.

  3. Anonymous users2024-02-14

    1、Take manual transmission as an example, first press the brake and press the clutch at the same time. The specific method is shown in the following figure:

    2. Then lift the handbrake and hang neutral, at this time lift the brake and clutch, and the vehicle stops. The specific method is shown in the following figure:

    3. Step on the brake and clutch first when you want to start; Finish. The specific method is shown in the following figure:

  4. Anonymous users2024-02-13

    Lift the clutch first to semi-linkage.

    Then give the source of the oil while slowly lifting the clutch. This is the most common and versatile starting method, which can be used for flat and ramp starts. The key is to master the semi-linkage position of the clutch, and it is very easy to find the semi-linkage position to start.

    As long as the current model lifts the clutch semi-linkage position, the flat road car can also start, even if it is not fueled, so you can use this to practice more when you are on the flat road to find the combination point.

    First lightly oiled, then lift the clutch. In fact, this starting method is almost the same, that is, first lightly step on the throttle, maintain the speed at about 800 to 1000 rpm, and then slowly lift the clutch to start, this method can effectively avoid the ignition due to insufficient starting power, but if the throttle is not well mastered, it will be channeled and then turned off. And when it comes to ramps, this starting method is also not suitable.

  5. Anonymous users2024-02-12

    Take manual transmission as an example, first press the brake and press the clutch at the same time. The specific method is shown in the following figure:

    2. Then lift the handbrake and hang neutral, at this time lift the brake and clutch, and the vehicle stops. The specific method is shown in the following figure:

    3. Step on the brake and clutch first when you want to start; Finish. The specific method is shown in the following figure:

  6. Anonymous users2024-02-11

    Driving steps: 1. Get on the bus and adjust the seat and reflector;

    2. Make sure that the gear is placed in neutral gear and the handbrake is pulled to the highest;

    3. Insert the key and turn it to the end, start the engine, and let go;

    4. Step on the clutch with your left foot, press the brake with your right foot, and then push the gear into 1st gear and flatten the handbrake;

    6. After the car starts, completely release the clutch of the left foot, and step on the light accelerator of the right foot to travel smoothly;

    7. After starting, the front is flat and there is no car to shift to 2nd gear to accelerate, release the throttle with the right foot when shifting, step the clutch to the end with the left foot, hang the right hand to the 2nd gear, quickly release the clutch with the left foot, and increase the throttle with the right foot at the same time.

  7. Anonymous users2024-02-10

    1. Get on the bus and prepare

    Be prepared before getting into the car, carefully inspect the surroundings of the vehicle, and pay attention to whether there are any obstacles under the car and around the body. Because there are many blind spots in the car after getting into the car and observing through the rearview mirror, there will be scratches if you don't pay attention to it.

    2. Adjust the seat.

    After getting into the car, the basic requirement for adjusting the seat back is that when the hands are naturally on the steering wheel, the back can be lightly pressed against the back of the seat, the eyes are level ahead, and the feet can be placed naturally on the pedals. Do not drive the car with your chest hunched over, and leave plenty of room for movement in your elbows and knees. After adjusting the seat, then adjust the rearview mirror and fasten the seat belt.

    3. Observe the surrounding road conditions.

    When you are ready to start, check the traffic conditions around you again, and since you are already in the driver's seat, it is best to turn your head and look behind you by looking in the rearview mirror, and try to check the safety of the blind spot.

    4. Get started. Turn on the left turn signal, press the clutch and brake all the way down, then put the gear lever in 1st gear with your right hand and release the handbrake. At this time, the brakes are applied to prevent the road surface from slipping backwards.

    Slowly lift the clutch with your left foot to nearly halfway, and when you feel the body start to shake, stop relaxing the clutch and slowly release the brakes. Once the car starts to move forward slowly, release the clutch completely, increasing the throttle a little if appropriate.

    After getting on the road, just take your own lane and operate according to the requirements of signal lights, signs, landmarks, etc. Don't just run around because other vehicles honk, in the event of a traffic accident, that's your responsibility.

    When parking, the coach told another mantra: pull the close, commonly known as "cans". The detailed steps are to first step on the brakes to slow down, if the gear is not in first gear, then press the clutch and hang back into first gear.

    Then step on the clutch, brake until the car comes to a complete stop, then pull the brake, hang back into neutral, finally close the key, release the clutch, and turn your head to observe the situation behind the car before getting out of the car and opening the door.

  8. Anonymous users2024-02-09

    Hello dear, the basic steps of driving: 1. Step on the clutch with your left foot, and pay attention to the clutch step must be stepped on to the end; 2. Two hanging:

    Hang to 1st gear, if the first gear is not successful, you can pull the gear lever back to the neutral position, and then carry out the second gear until it is completed; 3. Turn on the left turn signal to remind the rear vehicle to start; 4. Four honks: honking the horn is also to remind surrounding vehicles or pedestrians; 5. Five put:

    Letting go of the handbrake, forgetting to put the handbrake will cause the flameout; 6. Six stable, seven lift: stabilize the accelerator and lift the clutch pedal, when you find the clutch linkage point, lightly step on the accelerator, then the vehicle will shake slightly, and then the left and right feet move in the opposite direction, the left foot continues to slowly relax the clutch pedal upward, and the right foot slowly steps down the accelerator pedal, and the action should be eased.

Related questions
9 answers2024-08-15

I will come to you to solve this problem for you and help you solve your problems. >>>More

17 answers2024-08-15

The whole exam process is: 1 Theory Exam! 2. Level 2 has a total of 4 items 1: >>>More

14 answers2024-08-15

I also just took the driver's license test last summer, and I can take the C license. As long as you find a driving school to sign up, you can only refer to the driving school for all the processes. I studied for about a month last year. >>>More

7 answers2024-08-15

Retrograde driving is an illegal act and will result in a fine of 20-200 yuan and a deduction of 3 points. >>>More

8 answers2024-08-15

Driving barefoot is punishable by a warning or a fine of not less than 20 yuan but not more than 200 yuan. >>>More