Bought a Rapoo H3010 wireless headphones! There s always a buzzing sound

I tried it well in the store, but when I got home, there was a problem, buzzing, it could be white noise, which means that there are many similar frequencies near the operating frequency range of wireless headphones, and the continuity of the signal within a certain amplitude is presented on the pop There are the following suggestions.

1. First of all, you can borrow your friend's computer to use it, use your friend's computer to try to see if there is any buzz, if there is, it means that there is a problem with your headphones. If not, there is a problem with the connector of your computer's plugged receiver.

2. See if you have a wireless mouse or wireless keyboard on your computer, if so, it can be a problem of frequency interference.

3. If your friend also has wireless headphones, try it with his adapter to see if there is a problem with your headphones, which is very small.

4. The frequency band used for wireless Internet access is also left and right, which may also affect the earphones. Cause a buzzing sound, try to switch to wired Internet access.

5. Change your friend's wireless headset to your computer to see if there is any buzzing sound, if so, in addition to the problem explained in point 1, there may be a strong magnetic substance next to your computer, such as influence. Horns, magnetic substances can also affect the wireless headphones, causing noise.

Finally, it is recommended not to use wireless earphones, at present, there is no relevant safety certification wireless earphones The frequency operating range of wireless earphones is harmless to the human body, so use with caution.

It may be that the line is not very good Profiteers!

Almost all wireless headphones have this common problem, people.

I used it, and there was indeed such a situation, and later I bought Bingo's B-610 which was much better than him, and the sound quality was okay in terms of acceptance distance.

Rapoo wireless is of this quality, normal phenomenon, my 8500 keyboard often fails.

This could be an issue with your headphones!

Several possibilities, for your reference:

1. The wheat is completely good (it can be used on other machines).

2. The jack is not plugged incorrectly.

3. The microphone in the volume control is not muted.

4. The sound card driver has been reinstalled n times, and the new and old ones have been tried5. Volume control Attribute Recording Microphone The following tick has been marked 6. The volume can be adjusted, but the flat tone cannot be adjusted, because this column is gray, which is the key to the problem. In addition, the bass and pitch in the advanced properties of the microphone are gray and cannot be adjusted, and the pointer points to the lowest volume, which is also a problem.

7. The main engine lacks the noisy jack in front of the host (the installation personnel have been installed when the machine is installed, so it is feasible before) and the jack behind the host have been tried, the same phenomenon.

I don't know if it's a conflict with any software, or there is a problem with the system, or it's a hardware problem, I can't find any reason for it. Some friends said that they had encountered such a situation, and they succeeded after reinstalling the system, and some friends said that it was still the same after reinstallation, I really don't want to reinstall the system, and I hope that friends who have had similar experiences will leave some of your experience, of course, if I find the answer to the problem, I will also send it for your reference.