iPhone XR earpiece is hoarse

Hoarseness in the iPhone XR earpiece causes the eardrum to vibrate at a reduced frequency, causing dust stuck to the speaker to stick tightly to the eardrum, resulting in noise. This can be achieved by cleaning and replacing the speakers.

1. First of all, of course, the whole machine should be disassembled, and the corresponding screwdriver should be prepared before that.

2. When removing the screen, pay attention to gently separating the chiplet connected to the motherboard from the motherboard.

3. Before removing the metal shielding isolation layer, tear off the network access card and the card slot sticker under the network access card.

4. The last is to take a hair dryer to dry, but don't blow on the screen for a long time, such a high temperature will destroy the screen, even if the screen has a watermark, you can use the phone normally, the water in the screen will generally dry in two days, and you will see that the watermark inside is getting smaller and smaller.

5. Blow the front and back of the motherboard to ensure that there is no moisture residue, and try to blow out the water at the earpiece and buttons.

6. Finally, put the disassembled mobile phone in a dry and noisy place, preferably about two days, and then install it.

iphonexr, if the earpiece is hoarse, you can first use a hair dryer to blow the water out, and wait a few days to turn it on.

If the earpiece gets water, it is recommended to dry it with a hair dryer and try again, if it still doesn't work, take it to a repair shop for repair.

If the iPhone XR gets into the water, don't turn it on again. Because the water has entered the earpiece, the earpiece is damp and hoarse, and then it will corrode the motherboard and battery and other things inside the fuselage, so it is recommended to turn off the power and then send it to the maintenance point to disassemble the machine and clean up the water, which is the best way.

iPhone XR earpiece is hoarse**App Sonic free. Press and hold the small water drop icon. Then brush the earpiece with a small brush. Perfectly solve the problem of the sound of the earpiece becoming smaller due to water ingress.

iPhoneXR, the earpiece goes into the hoarseness, maybe it's water, or the speaker is blocked. You can find it directly, and you can just rest and repair it.

This requires the water to be cleaned first, and if it still doesn't work, the handset must be replaced.

Then you can turn off the phone, later, wait until the water on it is all dry, and then turn on the machine when the dry oil is full, if there is still sandstone, that is, the ear horn has been damaged.

If there is a hoarse sound after the mobile phone earpiece enters the water, at this time, turn off the mobile phone in time, and then wipe off the surface moisture and then put it in a ventilated place, and do not operate it by yourself.

Ah, if you get off the Apple phone, if you get into that water hoarse, that is, dry the water, and then use it after it dries, if it doesn't work, then it will form a pull, and it will not be damaged.

Hello! For this problem, it is recommended to let it stand in a ventilated and dry place for two days, and then try again, if it still doesn't work, you can use the cold air or weak speed of the hair dryer to blow it.

Hello, the water in the Apple mobile phone means that there is a problem with the electronic components inside and needs to be replaced.

If this happens, it's likely that your earpiece is mixed.

I'm afraid that the 8 earpiece has been faulty, and it needs to be replaced with a new earpiece, after all, at least that one is broken.

No way.

There may be a slight problem with this earpiece, and it can be repaired.

In this case, it is recommended that you quickly take it to the after-sales service center to find a maintenance staff to help you repair it, otherwise it will be broken.

If the iPhone XR earpiece gets into the water, it is recommended that you replace it in time to avoid damage to other parts.

Take it out for repairs, and it's quite cheap to replace it with an earpiece.

If the receiver gets into the water, it will definitely affect the obedient call, and the quality of this cashier is really normal.

Listen to the surprise, you can use a hair dryer to dry you, so it feels okay.

iphonexr, the earpiece enters the water and brushes your teeth, you can consult the after-sales personnel, and then let the after-sales personnel guide the operation.

The reason for the noise is that the frequency of the eardrum vibration decreases, which will make the dust attached to the speaker stick tightly to the eardrum, resulting in noise. It can be solved by cleaning the speaker and replacing the speaker.

When the speaker is invaded by this type of liquid, it is necessary to check the waterproof cover as soon as possible and then rinse the speaker hole with clean or warm water, rather than drying it with paper or a towel, so that the drink in the speaker hole can be washed out.

If it is not rinsed in a short period of time, the drink will become viscous and directly block the speaker when it dries, wipe the speaker hole with alcohol to dilute the bonded liquid, and then flush the speaker hole with warm water (about 40 degrees) (the water flow is not too urgent), and then wipe it dry and place, during which you can play the song, which can be recovered in 1 to 3 hours.

Hello Pro, here are several solutions for you:1Shutdown:

This is definitely the first step to saving the phone. Regardless of the level of water ingress into the phone, please turn it off first, otherwise the circuit will be burned out. 2.

Check the location of the water intake: In most cases, the headphone jack and charging hole are where a lot of water gets in**, because as long as there are no cracks, there will be no cracks elsewhere. If it's just a little bit of water, then use a hair dryer, let it cool and dry it with a light breeze.

Because most of the water is coming in through the headphone jack, the phone should be upright. 3.Wait a few days before turning it on:

After the phone is dry, it can be turned on and used normally. Of course, if you can't turn it on, it may be due to too much water that has damaged the internal circuit. Send it for repair in a timely manner.

Thank you, I hope it helps.

1. Use a clean fine-bristled toothbrush to brush the metal mesh on the earpiece, and it is basically normal after brushing it a few times.

2. If it is not dry, wrap it around a small vacuum cleaner or hair dryer and suck it in turn, and blow dry. If it is a corrosive liquid such as acid and alkali, it will also corrode the components of the motherboard, or have a chemical reaction with the motherboard, affecting normal use.

3. Dry the moisture inside the phone and take your phone to the mobile phone repair shop for inspection. Do not continue to use your phone after wading in water, if the water interferes with the circuit, your phone will not work.

It's because of the water ingress, so if there is a problem, you should check it out as soon as possible.

But the Apple phone is flooded, so there will be a problem of noise when listening to songs, you can go to Apple's after-sales side to clean the earpiece.

If the water gets in, blow it with a hair dryer, and if it doesn't work, you have to fix it.

I'm an Apple maintenance engineer, so let's talk about a few points.

1. Apple XR has a partial waterproof function, and daily splashes can be waterproof, 2Apple XR really can't be replaced with a new one if it gets water, and it's not covered by the warranty.

3.There are several waterproof test strips in the iPhone, which turn red when exposed to water or water vapor. There is no warranty.

4。Daily use is not only water, water vapor into the inside of the phone will also cause the motherboard to short-circuit and not turn on.

5. If you don't turn it on, you won't turn it on, but the individual chips on the motherboard are short-circuited, and you don't need to replace the entire motherboard, let alone replace the phone. Of course, if you can provide a free warranty, it will be free, otherwise you will go to repair, and you must not listen to the tricks of a small shop without technology, and you must change the motherboard.

It's only a few hundred to change the chip, and it's not 2,000 to change the motherboard!

6.In addition, if there is heat after entering the water or it keeps restarting, it is recommended to clean the water, blow it on the card slot with a hair dryer, and put it in the rice to bread. Turn it on again the next day to try, if it's not normal, send it for repair.

Don't charge, don't charge, don't charge.

It will burn out the motherboard further.

7.If there is a lot of water, even if it is normal for the time being, it is recommended that you disassemble the machine to clean up the water, otherwise there is a dark disease, and the parts inside are all metal structures, and there will definitely be problems if the corrosion rusts to a certain extent.

8。After the water ingress the sound, the speaker is water, it can be disassembled and cleaned, and the individual can be restored, and a small part of the corroded circuit will be replaced.

Let's talk so much first, and then ask if you don't understand.

The waterproof performance of the mobile phone is not very good, don't think about it like a waterproof watch, the mobile phone just prevents water from entering the inside, but there will be water outside the earpiece and amplifier, so there is sound.

Some of the original parts of the mobile phone can not see the water, it is easy to cause a short circuit when exposed to water, and it is not normal to be hoarse and hoarse, you can go to the repair shop to repair it, or you can use a hair dryer to blow on the charging hole and the empty forehead of the earphones, dry the water, and try it after evaporation.

That's how the speaker has water,The so-called mobile phone is not afraid of water is also conditional,You must know that water is pervasive,Sealing traces8Your screws will be soaked in water,Not to mention the mobile phone,Of course,In important parts, the mobile phone waterproof will be handled very well,The speaker will be fine after a few days of water。 The most feared thing is the seawater.

Water reacts electrochemically with many metals, especially when electricity is applied and water contains complex ions.

There is a hoarse sound that your speaker is in the water, if other functions are not affected, the speaker is in the water, you shake the phone hard to remove the water from the speaker, and then blow it with a hot hair dryer (be careful not to blow too hot), there is no big problem, don't play like this in the future.

Apple's mobile phone is waterproof, it's just for accidentally falling into the water, who has nothing to do with the phone deliberately put the phone in the water, do you do experiments, there is a sound that the water is not dry in place, you need to continue to observe the situation.

The mobile phone should be flooded, and it is said that it is waterproof, which means that it is tightly closed and will not hurt the motherboard, and it should not be in the water for too long.

Now the phone should not be waterproof. You also say that when they say waterproofing, they say that it's okay to drop a little bit, but if you want to say that it's okay to fall all into the water, it's not okay. You'll have to go to the phone store and ask him to take it apart and see if there's any water.

It should be your phone going in a little bit of water control, and it will be fine after a long time, like when you take a shower, your phone has steam in the bathroom.

iPhone XR supports IP67 waterproof, can be soaked in water at a depth of one meter for 30 minutes, and you can take it to Apple after-sales service to check it.

This kind of water ingress can only be taken to find someone to open the shell and wipe the motherboard and headphone jack inside with high-concentration alcohol, because after the water ingress, Apple will no longer report for repair.

This is very normal, which mobile phone gets into the water, the first thing to start with is no problem at all, is it impossible?

Put it in a rice tank for two days to dry and dry, and there will be a lot of inexplicable problems when the mobile phone gets into the water.

Shake the phone wildly, try to shake the water clean, and then blow it with a hair dryer. Let it sit for half an hour and then use it, and that's how good mine is.

Isn't this normal, the phone will be a little wrong when you take it out of the water, right? Either change your phone or fix it, I don't have a good idea.

It's nothing, this is a waterproof phone itself, but the blisters block the holes of the speakers, shake them by hand, and it is best to air dry them naturally in a dry and ventilated place.

It's just waterproof, and it will still get into the water if it takes too long.

I'm an Apple repair engineer, so I'll talk about it.

Apple XR is IP68 waterproof, if there is not much water in, it is completely fine, such as after taking it back, there is nothing that can be ignored.

However, if you soak in water for a long time or have dismantled the machine before to destroy the watertightness, it will definitely not work.

If there is a black screen, no boot, restart, and the screen does not move after entering the water, it is likely that there is a problem with the screen or motherboard.

Since water ingress is not covered by the after-sales warranty, it can only be repaired at a cost.

Pay special attention to motherboard maintenance, and don't replace the entire motherboard as soon as you hear that the motherboard is broken.

If the motherboard is broken, don't be afraid, the motherboard is not a whole piece, there are many small chips in it, including baseband, CPU, hard disk, WiFi module, touch screen IC and so on.

Many small local masters don't know how to repair chips, so they let the entire motherboard be replaced, which is very expensive.

In fact, you only need to change the chip, which can save more than half.

The yellow chip in the picture below is the most common power supply IC, and if it is burned, the screen will be black and will not turn on, just change it. The cost is 23 hundred, don't listen to what the small store says, change the motherboard of 34 thousand at every turn.

I have been doing mobile phone chip repair, and I know these very well.

Generally, if you don't have a mobile phone, you can turn it on.

Taking Apple mobile phones as an example, the reasons and solutions for its XR no sound are as follows:

1. If the handset cannot be used due to the problem of mobile phone system settings, press the volume plus button to increase the volume when calling; You can also restore all settings with one click, and you can return to normal after general restoration.

2. If there is a problem with the mobile phone system and the earpiece cannot be used, you can generally restart the mobile phone to solve it; If necessary, the iTunes software connected to the computer can perform automatic recovery or automatic system upgrade to solve the problem.

3. If none of the above methods can be solved, it may be caused by problems with the hardware of the mobile phone, such as whether the headphone jack is flooded, whether there is dust or other impurities that cause a short circuit in the internal circuit, thus triggering the headphone mode.

4. After excluding the above factors, the mobile phone earpiece is still unusable, it may be caused by the earpiece is broken, the circuit is short-circuited or open-circuited, etc., and this situation needs to be solved by contacting Apple's official after-sales service for disassembly and maintenance.

1. The most common is that the volume is not turned on and the phone is set to vibrate. Many people often forget to modify it after adjusting it to Zhenqing to talk about it, and the mobile phone is placed on the pillow, and the sound is very small when it vibrates, resulting in not being heard.

2. The speaker of the mobile phone is broken, and in this case, you need to take it to the mobile phone repair shop for repair. Generally speaking, it is best to return to the factory for maintenance, and do not repair it in a small shop to prevent the other party from replacing parts.

3. The phone has a software failure and the audio driver is damaged.