Lovol 1004 tractor high temperature, Lovol 524 tractor parameters

Why is the water tank of Lovol 904 installed with Tieniu 55 at high temperatures and as big as the water tank?

Summary. Rated traction (kn) x0912

Rated power kW (hp) x09

Minimum ground clearance (mm) x09325

Front track (mm) x091250

Wheelbase (mm) x09

Tare weight (kg) x09

The working weight of the whole machine (kg) x092360

Displacement (L) X09 Lovol TB524 Tractor Comprehensive parameters.

Parameter Name: x09: Parameter content.

Overall machine type x09

Tractor type x09 wheeled.

Performance parameter x09

The working weight of the whole machine (kg) x092360

Power output (kW) x0938

PTO shaft speed (r min) x09540 760 or 540 1000 or 760 1000

Maximum lifting force (kn) x09

Rated traction (kn) x0912

Minimum ground clearance (mm) x09325

Front track (mm) x091250

Rear wheel base (mm) x091200-1500 (commonly used 1300) chassis x09

Transmission gears (forward + reverse) x0912 + 12 engine x09

Tractor-hydraulic transmission system x09

Oil capacity x09

Overall size x09

Overall length (mm) x093579

Overall width (mm) x091750

Overall height (mm) x092105

Hello, I am helping you to inquire about the relevant information and will reply to you immediately.

Summary. Lovol 1200 tractor temperature up 120 momentary loss of power: cause of failure:

The oil supply is too late or too early, the air filter is blocked, the valve is not tight, the cylinder gasket is burned out or not compressed, the piston, cylinder barrel, piston ring is worn, the piston ring is sintered or the oil supply to the counterpart is too small. Elimination method: adjust the oil supply advance angle, clean or replace the filter element, check and adjust the valve clearance, grind the valve, replace or tighten the cylinder head, clean and reinstall, replace the piston ring, and adjust the oil supply.

The Lovol 1200 tractor heats up to 120 and runs out of power in an instant.

Lovol 1200 tractor heating up 120 There is no power in an instant: the cause of the failure is staring: the oil supply is too late or too early, the air filter is blocked, the valve is not tight, the cylinder gasket is burned out or not compressed, the piston, cylinder barrel, piston ring is worn, the piston ring is sintered or the oil supply to the counterpart is too small.

Exclusion method: adjust the oil supply advance angle, clean or replace the filter element, check and adjust the valve clearance, grind the valve, replace or tighten the cylinder head, clean and reinstall, replace the piston ring, and adjust the oil supply tank grinding capacity.

The lack of engine oil will cause low oil pressure, and the friction surface of each old group part will not be well lubricated, which will cause serious wear and tear of the parts! It is estimated that the inside of your machine has been damaged to some extent. It is recommended to carefully check the oil, coolant, etc. before driving each time!

Large-load work, lack of oil, pull cylinder, holding tile, it is possible, crankshaft, connecting rod has different degrees of wear and tear.

Summary. Hello Dear Lovol 100!The tractor that left the factory in '14 was the M1000-D Lovol 100!There are several kinds of tractors that have left the factory in 14 years.

Hello Dear Lovol 100!The 14 year old tractor that left the factory is the M1000-D, and these are some of the relevant information I have gathered for you.