What is the reason for the Wanjiale gas water heater plug tripping?

1. The water heater will automatically trip as soon as it is turned on. 2. The water heater leakage protector tripped. 3. The leakage protection plug has poor contact with the inferior socket, and it is misstarted due to overheating.

Gas water heater refers to a gas appliance that uses gas as fuel to transfer heat to the cold water flowing through the heat exchanger through combustion heating to achieve the purpose of preparing hot water.

Gas water heaters.

The plug tripped, it is recommended that you change the socket and try again, if it still trips, it may be that the water heater is malfunctioning, right.

If the plug of the gas water heater trips, it is a fault with leakage. The main thing is to check whether there is any leakage of this fan. There is also whether the power cord is damaged, touching the shell and touching the metal.

The former is more appropriate, first, the story is mainly about Robinson's life at sea, and the word "drifting" is more relevant than holding Mingxiao; The second is that the extension of "adventure" is larger, not only in the seaside, in the mountains, in the desert, and even in the city, you can have adventures, and "rafting" itself also has the meaning of going through a lot of hardships. So, the former is more suitable.

It is possible that there are some abnormalities in the circuit breaker itself, which leads to frequent tripping trips. It is possible that the water heater has leakage, and the leakage protection switch will trip to protect it. It may be that the voltage is too large, and the load of the leakage protection switch is exceeded and the power of the water heater is not matched, or it will also trip if the material base is too small.

No matter what kind of reason it is caused by tripping, it is necessary to ask the after-sales service to deal with it in time to avoid damage to the water heater, and at the same time prevent potential safety hazards such as electric shock and fire caused by leakage. Auspicious.

Wanjiale water heater tripping reason:

1. Whether the leakage protector has been damaged.

The water heater trips after being plugged in, the first possibility can be ruled out, the leakage protector is damaged, and we all know that everything is normal before it is not plugged in.

Second, the short circuit phenomenon of the circuit and electrical, resulting in excessive current and tripping of the water heater after plugging in, may be due to the short circuit of the circuit, or the function is too large and causes the tripping phenomenon.

3. Whether the power supply is grounded or repeatedly grounded.

For example, if the wire is damaged, if it is a neutral line, it is more necessary to pay attention to it, which is likely to lead to leakage. 80% of such failures are caused by faulty power lines, because the power plug comes with leakage protection, and as long as it leaks, it will trip. Automatic protection is also possible when the heating tube is ruptured, but it is less likely that the heated tube will rupture.

The reason for the failure of the power plug is most likely due to the tripping caused by excessive humidity and water ingress of the plug. As long as the water is dried, or the inside is dried with a hair dryer, it can be used normally.

Fourth, the scale of the heating pipe of the water heater is too thick.

Clean and descale the replaced heating pipe, and you can find out where the electricity leaked. After the water enters the quartz sand layer, the water heater will leak and trip. Originally, the heating pipe and the water heater shell were insulated, and if you measured it with a multimeter, the resistance should be smaller.

Fifth, whether it is connected with the neighboring house.

Check whether the household tripping is a leakage switch or an air switch, if it is a leakage switch, it must be caused by the leakage of the water heater, if it is an air switch, it is due to a short circuit inside the water heater to cause tripping.

6. The components of the water heater are damaged.

Whether it is the damage of the components of the water heater itself or the damage of the circuit of the water heater, it may cause the water heater to be plugged in and trip, which is also the function of the water heater thermostat to protect the water heater.

Summary. Hello dear, Wanjiale electric water heater tripping as soon as hot water is put out may be 1Because the leakage protector is damaged.

2.The electrical circuit is short-circuited, resulting in excessive current. 3.

Power supply grounding or repeated grounding. 4.The scale of the water heater heating pipe is too thick.

5.String power with the house.

Hello dear dear, Wanjiale electric water heater Shen Pei Sui a hot water trip may be 1Because of leakage, the denier protector is damaged. 2.

The electrical circuit is short-circuited, and the current is too large. 3.Power supply grounding or repeated grounding.

4.The scale of the water heater heating pipe is too thick. 5.

String power with the house.

1. The aging of wires can lead to the tripping of Wanjiale water heater. Solution: Reinstall the wires before aging, after all, there are safety hazards in the use of aging wires.

2. Cause of heating pipe leakage: The scale of Wanjiale water heater is too thick, which causes Wanjiale water heater to burst, and the water enters the quartz sand layer, causing Wanjiale water heater to leak and trip. Judgment method:

If you use a multimeter to measure the resistance, if the resistance becomes smaller, it will prove that the heating tube is leaking; Clean the Wanjiale water heater regularly, and replace the heating pipe of Wanjiale water heater in time. Replace the heating pipe, and ask the maintenance personnel to replace it if you can't do it.

3. The power of Wanjiale water heater is too large, and the backup key of Wanjiale water heater is heated normally and suddenly trips. Solution: It should be that the home circuit cannot withstand the home circuit due to too many electrical appliances at home, either reduce the total power of household appliances, or replace the wiring that can withstand higher collision power.

4. The leakage protector of Wanjiale water heater is damaged. Solution: Find a professional repair personnel to repair or replace.

5. Leakage between other live components and the casing. Solution: Check and replace damaged components one by one.

6. The leakage protection plug is in poor contact with the inferior socket. Workaround: Replace the outlet.