What should I do if the phone tail plug is loose?

First of all, you can try to change the charging cable, if it is not the problem of the charging cable, but the mobile phone jack, put the thimble into the mobile phone charging jack, and gently push the position of the spring to the right. You carefully use the needle to point a small point of unused special watch oil or organic oil on the data line, flatten the second row of spring points in the ditch, and use the needle to dial it right below (be careful not to hurt the inner contact), push the spring upward, then it will not be loose, the oil must be wiped dry before it can be charged. That's the only way to go where you can fix your phone

And you don't have to go to the place where you buy a mobile phone to repair it, mobile phones are all popular products, almost can be repaired, if you can't repair it, buy a charging pad charger. But there are various causes and solutions for each phone.

Take the Apple mobile phone as an example, its tail plug is connected by a physical buckle.

1.It is recommended to clean up the dust first, you can use a thin toothpick to gently pluck in the tail plug to confirm whether there is dust, and wipe the gold finger with an alcohol cotton wool after picking out the dust.

2.If the internal buckle is loose, there is basically no maintenance value, and it is recommended to replace the tail plug directly.

3.It can be replaced directly at the after-sales service or maintenance point, which is not difficult, just disassemble the existing interface after disassembling the motherboard, and then solder the new one.

Of course, can't it be charged if the interface is sent? Not exactly. If the interface is loose, there may only be intermittent charging due to poor contact, you see, as long as there is no intermittent charging, it will not affect normal charging.

Many people have reported that the reason for vivo's mobile phone port is that the interface is loose, but it does not affect the charging. Hahaha.

The trick of loosening the tail plug of your phone is good when your phone can't be charged.

The battery should be removed first when repairing, otherwise it will cause other failures caused by UMC, that is, it cannot be operated with electricity. It is possible that dust needs to be cleaned up.

Here's how:

1. Prepare a transparent tape and a thin toothpick.

2. Roll the toothpick on the tape. The sticky side faces outwards and the non-sticky side faces inward. Wrap diagonally slowly.

3. Roll into a long tube. It's the same size as the tail plug of a mobile phone.

4. Reach into the tail jack and use the stickiness of the tape to bring out the dust. Scratch a few times in the charging hole, and you can see the dirt inside with a flashlight.

5. Determine that it is a tail plug problem, and take it to the official maintenance station to replace the tail plug. If the location of the mobile phone charging port is damaged, it is recommended that you bring the machine, purchase invoice, and repair card to Samsung for inspection, and the on-site engineer will help determine what the repair is and whether it is within the scope of the warranty.

2.You can use a thin toothpick to gently stir in the tail plug to confirm whether there is dust, pick out the dust and wipe it with an alcohol swab.

3.Or find the mobile phone card needle or sewing needle, and gently toggle it with the card to align the interface hole until the dust is out. If the internal buckle is loose, there is basically no maintenance value. It is recommended to replace the tail plug directly.

Flowers] [flowers] [flowers] [flowers] [flowers] [flowers].

The question is not, that is, the mobile phone card contact is not good, and the mobile phone card is always not recognized, and then yesterday I found someone to get the mobile phone card and finally could not identify it, but the charging could not be charged.

Question: Is it possible that the tail plug is loose?

Question: Is it troublesome to disassemble, and which is cheaper to replace the tail plug?

Question: How long does it take to disassemble the machine?

Ask how much it is.

Asking a question, that means it's better to change the tail.

Flowers] [flowers] [flowers] [flowers].

How to tighten the loose tail plug of the mobile phone, teach you a trick, and fix it immediately!

1. Generally, there are only two problems with the loose tail plug of the mobile phone, the charger is damaged or the interface is damaged.

2. If the data cable interface is damaged, compare it with the original one. If that doesn't work, switch to a non-original cable.

3. There is a problem with the charging interface of the mobile phone, it may be dust inside, or it may be that the tail plug needs to be replaced.

4. If there is dust inside, you can try a hair dryer or a tool that can clean the inside to remove the dust. However, if you go to the gods by yourself, the dust is generally not easy to get, and it is easy to hurt the mobile phone.

5. Most of them still need to go to the mobile phone repair shop for repair, and the repair fee is about 30 yuan for the end plug and 10 yuan for the ash cleaning.

The looseness of the charging interface of the mobile phone is mainly due to the dusty charging port, which leads to the charging cable socket not being plugged in place, resulting in looseness, poor plugging, easy to fall off and other problems.

You can use a thin toothpick to gently pluck inside the tail plug to confirm whether there is dust, pick out the dust and wipe it with an alcohol swab.

Or find out the stitch or sewing needle that comes with the mobile phone first, and then use the card to align the interface hole and gently toggle it until the dust inside is cleaned. The interface can be restored to the original plug tightly.

If the internal buckle is loose, there is basically no maintenance value, and it is recommended to replace the tail plug directly.

Mobile phone daily maintenance:

1 Don't wait until your phone battery runs out to charge.

Generally, we will have an idea that it is better to charge the battery of the mobile phone after all the power is discharged, which is basically true, because most of the rechargeable batteries we used in the past are nickel-cadmium (NICD) batteries, and nickel-cadmium batteries have the so-called memory effect, if they are not discharged and recharged, it will lead to a rapid reduction in battery life.

2 When the phone is charging, do not plug it**.

The reason is that when the phone is charging, it will be potentially dangerous if the call is answered.

Don't wait until the phone is used for a short time before activating it, as it will cause insufficient discharge due to insufficient time, and the memory of the battery will still remain. The usage time after activation will still be short.

1. In the process of using the mobile phone, the charging socket is often not tight, resulting in the inability to charge or poor charging contact, so the charging plug will shake left and right in the mobile phone.

2. I usually think that the charging interface of my mobile phone is broken, but in fact, the reason for this situation is the dust and lint accumulated in my pocket and bag for a long time.

3. The solution is to use sharp tools such as tweezers or paper clips to gently pick out the compacted dust when the machine is turned off.

5. Finally, after the charging interface is cleared, the phone can be charged normally.

If the tail plug of the mobile phone is loose, we try to check whether it is due to dust inside or foreign objects that cause the data cable socket to be unable to be firmly plugged in; If the problem has been ruled out as a foreign object, it may be due to the loosening of the tail plug after repeated use, and it is necessary to go to the maintenance point for repair. Here's a closer look:

1. The main reason for the loosening of the mobile phone charging interface: the charging port is dusty, resulting in the charging cable socket not being plugged in place; Use a thin toothpick to gently pick in the tail plug to confirm whether there is dust, pick out the dust and wipe it with an alcohol swab; First, find the needle or sewing needle that comes with the mobile phone, and then use the card to align the interface hole and gently toggle it until the dust inside is cleaned. The interface can be restored to the original plug tightly.

2. If the internal buckle is loose, there is basically no maintenance value, and it is recommended to replace the tail plug directly;

Method 2: If the tail plug of the mobile phone is not in good contact, only one side can be fast-charged, and the reverse is not good, it looks like it is charging, but it is actually discharging, and it depends on which side of the charging point speed is correct. Fast charging can reach one or two thousand mAh, if the speed is found to be negative when charging, it is plugged in backwards, just paste it with tape in this way, so that the contact position will be adjusted, and it is very stable, it will not be bad contact while charging and playing, it may be useful for some mobile phones, let's see for yourself, I have used this method for several months, it is very stable.