How to clean a kitchen drain clogged with grease

How to deal with the blockage of kitchen pipes First of all, you can use the following methods;

1.Boiled water. Boil a large pot of boiling water and pour it directly into the clogged pipe; Then store a pool of hot water, and when it is full, pull out the plug and release the water.

2.Boiling water + dish soap.

If boiling water is not effective enough, you can add detergent such as dish soap, laundry detergent or laundry detergent to the boiling water, and then mix a large amount of detergent with boiling water to flush the pipe.

3.Pipeline dredging agent.

The main ingredient of pipeline dredging agent is sodium hydroxide, first pour the dredging agent into the blocked pipe, wait for one to two hours, and then pour in a basin of boiling water, which can basically be solved.

4.Dismantling and cleaning.

The most susceptible area of the kitchen to be clogged with oil is usually the "backbend", because a part of the water is stored in the "backbend" to prevent unpleasant smells. However, kitchen wastewater contains a lot of grease, which slowly accumulates in the "return bend" after cooling, and is easy to clog after a long time.

You buy some baking soda, and then prepare table salt, pour it into the sewer pipe at a ratio of 1:2, if your pipe has a lot of oil, put more water, and then don't put water, wait 30, 45 minutes, and then rinse it off with hot water, and once a half a month.

What to do if the kitchen drain is clogged with oil and difficult to clean, this method can be used to clean quickly.

The first step is to grab a handful of alkali and put it in the hole, then put salt, then put white vinegar, and finally pour hot water into the hole, and the hole slowly blisters. I've tried this many times, and the effect is really amazing. First of all, I went to the street to buy a pound of soda (four yuan a catty, which is sold in dry and miscellaneous stores), and prepared a little more hot water, I have a way, which is to boil a large pot of boiling water.

Add laundry detergent to the boiling water and add a little more. Then add dish soap. Add a little more, too.

Clean the water that does not seep down the sewer. It must be clean!; Use hot water to pour into the sink and replace the cool water in the pipe trap.

Then remove the hose from the washing basin and scoop two scoops of flake soda with a spoon.

The reason why the drain is clogged is because there are a lot of oil stains and stains, at this time we sprinkle some baking soda on the pool because baking soda has a strong decontamination effect. Then pour in freshly boiled water. This dissolves oil very well.

The vegetable residue and grease in the sewage are insoluble in water, slowly adhere to the pipe wall, and form a bacterial film on bacteria and metabolites, and the bacterial film and dirt continue to accumulate and the aqueduct is blocked, and the bacteria gather to emit a foul smell! Also known as: caustic soda, caustic soda.

Its scientific name is sodium hydroxide, which is a flake translucent solid, which is highly soluble in water and forms a sodium hydroxide solution with water, which is a strong alkaline solution and an important chemical industry in industry.

Special dredging agent for pipelines, pour directly into the sewer, generally pour half a bottle to a bottle, special dredging agent needs to choose a dredging agent with the function of dissolving oil pollution, select the dose according to the severity of the blockage, wait for about 1 hour, pour hot waterAfter removing the hose, it is easy to do, shake it hard, you see that it will shake out a lot of stool-like substance, if you can't shake it out, you can find a long straight stick (there is no long stick can be dismantled and straightened by a hanger) and poke it. The prevention plan is important to be persistent, don't leave it to chance, eat three meals a day, 365 days a year, and don't be careless.

You should use a professional dredging agent, you can pour the dredging agent into the drain, and pour some boiling water after 12 hours, so that the oil in the sewer can be dissolved, and the sewer can be dredged well.

The best thing to do is to find someone from a housekeeping company and ask them to unclog the sewers.

Oil stains in kitchen drains are mainly caused by oily dirty water on the pipe walls. As soon as this oil is heated to 80°C, it will turn into a liquid and flow. The method is to put a small amount of baking soda in a pipe, boil a pot or two of boiling water, and slowly pour it out of the drain to melt the fat in the pipe.

Baking soda + boiling water Pour baking soda directly into the sewer, dissolve the baking soda with the water in the sewer, and after a few minutes, after the baking soda and the oil ester of the sewer have fully reacted, pour it with boiling water, and it will basically be dredged.

2.Pipe dredging agent If the method of boiling water and baking soda still cannot dredge the sewer or the dredging result is not ideal, you can also choose to buy a special pipe dredging agent, which has a variety of ingredients that dissolve the oil.

3.Dedicated unclogging device.

Insert the dredge into the drain, then add an appropriate amount of dish soap, and clean the oil stain from the drain by rotating the dredger, and the drain is basically dredged. Now it's basically possible to buy.

Sewers are a type of urban public facility that has been used as early as the ancient Roman period. The prototype of modern sewers originated in Paris, France, and Paris still has the largest urban sewer system in the world. Generally speaking, the sewer system is used to collect and discharge domestic wastewater generated in the city and industrial wastewater generated in industrial production.

Urban rainfall is counted as urban wastewater for the time being).

Hope it helps, dear

That toilet plug just had a few pokes in the drain, no problem.

There are ways to remove sewer oil:

1. Add hot water with caustic soda in a ratio of about 1:500, then pour it into the drain slowly, and turn on the faucet to rinse the vegetable basin and sewer for a few minutes after pouring.

2. Put the stomach digesting tablets or vitamin effervescent tablets on the inside of the sink outlet, and then rinse with boiling water.

3. With vinegar and baking soda, first rinse the drainage pipe with boiling water, then pour a small bowl of baking soda powder (about 200 grams) into the sink, then pour a small half bowl of vinegar, wait for about 4-5 minutes, and then pour boiling water into the outlet for at least 5 minutes.

4. Pour laundry detergent into the sink outlet, then rinse with hot water, and try three to five times.

5. Use a special pipeline oil cleaning agent and operate according to the instructions for use.

6. Please ask a professional pipeline dredging master to provide door-to-door service.

1. How to clean up the oil blockage in the kitchen sewer?

1.Animal fat blockage: If it is oily, it is recommended to use boiling water, of course, if you can buy concentrated sulfuric acid, the effect is better. If something is blocked, you have to use the kind of special tools you said upstairs used to clean the pipes.

2.Cement blockage: 70% hydrochloric acid can't be found, 35% is sold everywhere, you can try it. Add a small amount of flour to act as a corrosion inhibitor, and urotropine is good. It can reduce corrosion to steel.

3.Go to the market and buy a 2-meter spring wire pipe dredging tool, bend the head 1-2cm at 10-20 degrees, dredge it back and forth at the sewer inlet and outlet, and rinse it with water.

4. Soda and vinegar dredging method: first pour half a cup of cooked baking soda powder into the sewer, and then pour half a cup of vinegar, after the soda reacts with the acid in the vinegar, the thick substances in the pipeline can be removed.

5.Use water pressure dredging method: take a plastic pipe (or rubber pipe) with a diameter of 10 mm and a length of about 1 meter, fasten one end to the faucet, insert the other end into the pool to block the early or place, wrap it outside the rubber pipe with a cloth, block the water outlet of the pool, open the faucet and twist it up, and the pressure of the water with the water is enough to wash away the blockage.

Rinse with boiling water, most of the clogging of the water is grease blockage, and the boiling water can be dissolved.

2), the best way is to call ** ask for housekeeping, and get rid of the disease.

3) If it is oily, you can use 20% Sufonda water to pass through. If something is blocked, you can only use tools for stupid scum.

6.Here's how to do it:

1) Flush into the waterway with boiling water in a large pot.

2).Then prick it several times with a thick iron wire until the boiling water runs out.

2. How to prevent oil clogging in the kitchen drain?

1. Clean the kitchen drain regularly with boiling water and laundry detergent. Usage: Boil a pot of boiling water and add laundry detergent to flush out of the sink, which can dissolve more oil on the pipe wall, which is effective in winter.

2.There is a funnel-like thing in the sink in the sink that filters out large residues, try not to take them off. Extend the clogged pipes cycle.

3.Toilet sewer: A toilet is usually connected to a bathroom and washbasin. The drains in washbasins and bathrooms are mostly caused by hair. The blockage of toilet drains is mostly caused by users carelessly, or accidentally throwing toilet drains into them as garbage cans.

4.Try to clean your hair as much as possible when brushing and don't flush it down the drain.

1. Boiling water. If you wash your dishes often, you will know that it is easier to wash the grease stains on the dishes with hot water than with cold water. For non-serious sewer blockages, we can also use the same principle, using boiling water to flush the sewer, that is, using hot water to melt the oil remaining on the sewer pipe wall.

Prepare enough boiling water (it is recommended to prepare a full pot of boiling water) and keep it continuously poured into the sewer.

2. Baking soda + boiling water. We all know that the chemical name of baking soda is sodium bicarbonate. Sodium bicarbonate is alkaline when dissolved in water, while the oil esters in oil stains are hydrolyzed under alkaline conditions.

Take an appropriate amount of baking soda and pour it into a pot filled with hot water, and pour the baking soda into the drain continuously and slowly; You can also pour baking soda directly into the sewer, dissolve the baking soda with the water in the sewer, and after a few minutes, after the baking soda and the oil ester of the sewer have fully reacted, pour it with boiling water, and it will basically be dredged.

3. Use pipeline dredging agent. If the method of boiling water and baking soda still can't dredge the sewer or the dredging result is not ideal, you can also choose to buy a special pipe dredging agent, which is sold in supermarkets and various shopping malls. This is because there are a variety of ingredients in these special dredging agents that dissolve the oil.

4. Special dredging device. In contemporary society, as long as we can think of something, there is basically something for sale. Boiling water and dredging agents can't solve the sewer blockage, so you just want to find something to see if there are other things blocked.

At home, we generally choose iron wire, but the iron wire is not easy to operate at the bend of the sewer, here you need to buy a special dredge, insert the dredge into the sewer, clean up the oil stain of the sewer by rotating the dredger, and the sewer is basically dredged.

5. Leather picks. To clean up the sewer oil, in addition to the special dredging device of method four, there is also a leather picker. By pulling the handle, a vacuum space is formed between the piston inside the leather tube and the sewer, and the continuous lifting handle generates pressure to suck up the clogged dirt in the sewer to dredge the sewer.

If the kitchen drain is blocked, it will affect daily use. How to deal with the grease blockage in the kitchen drain? PChouse will take you to find out.

1. Pour hot water directly, because the pipeline is blocked by some oil stains, hot water can effectively dissolve the oil stains, directly boil a pot of boiling water, and quickly pour it into the sewer pipe, the stains can be dredged when they are dissolved.

2. It can also be used to pump and dredge the method, with a pump hose directly into the sewer mouth, and then continue to pump and pour water, which can also play a certain role.

3. Through the water pressure, increase the water pressure, connect the faucet and the sewer pipe with a plastic pipe, open the faucet to the maximum, continuously fill the water, and through the high-pressure water flow, it can play a role in dredging.

4. If the above methods still do not work, it is necessary to use a combination of dredging agents to effectively dissolve the dirt. Baking soda and white vinegar are both able to quickly dissolve stains. In addition, it can also be diluted with hydrochloric acid and poured into the sewer, pay attention to be diluted, otherwise it is easy to corrode the inner wall of the pipe.

Not only can it be dredged, but it can also play a disinfection role.

5. If there is no effect, the ultimate method is to disconnect the connection of the pipeline interface and remove the debris on the inner wall of the pipeline, so as to solve the blockage problem from the root.