Subject 2: Reversing into the warehouse and leaving the warehouse right out of the warehouse, optimi

Key points of operation: 1. Pour into the garage from the starting point:

1 After the driver gets into the car, adjust the seat and rearview mirror, fasten the seat belt, reverse, release the parking brake lever, the car starts to idle and reverse, and the driver observes the garage through the right rear window.

2 When the black edge of the right rear window is aligned with the right line of the garage, turn the steering wheel evenly to the limit position.

3 After putting the car in the warehouse, the driver looked back at the left rearview mirror and immediately returned to the steering wheel after seeing the entire left side line of the garage.

4 Stop immediately when you see the left door handle level with the garage bottom line in the left rearview mirror.

2. Enter the return point from the garage: put the car in front of the garage in 1st gear, when you see the hood close to the curb, move the left steering wheel to the limit position, and stop the car straight.

3. Reverse into the garage from the return point:

1 Reverse, keep the limit of the steering wheel on the left, and reverse.

2 The driver should pay attention to the left rearview mirror and correct the direction so that the rear of the car is flipped over and stored.

3 After the vehicle is put into the garage, the driver should pay attention to the right rearview mirror, and when the right line appears in the entire garage, he should immediately return to the steering wheel.

4 Turn your eyes to the left side mirror and stop when the left door handle is level with the garage floor.

Fourth, from the garage into the starting point: the car and 1 front car out of the garage, when you see the hood close to the curb, turn right to the steering wheel to the limit, stop the rear car.

Fifth, the operation skills:

1. The whole process speed control uses 1 or reverse idling, starts according to the speed, and drives according to the speed.

2. Carefully observe and grasp the key points of turning, turn in time during the reversing process, and grasp the timing of steering.

3 Control the driving routeDuring the test, the driving route of the car is mainly determined by the speed of the vehicle and the speed of the steering wheel. When the vehicle is reversing, it is necessary to track the side line in time and correct the direction in time to keep the vehicle upright.

Out of the library is much simpler than in the warehouse, pay attention to the speed when leaving the warehouse, do not press to the side, and the right angle of the library line, mainly pay attention to the right line when leaving the warehouse.

1. Hang a file and leave the warehouse. When the hood covers the front line of the storage area, quickly shoot to the left to the direction of the kill, to the starting point of the exam.

2. Stop when the front wheel presses over the yellow starting line. (You don't need to bend the jujube back to the right direction, just return according to the original route). 3. Drive at low speed with reverse gear, look at the left rearview mirror, observe the distance between the body and the left front corner line of the storage area, and adjust the wheels into storage.

When it is greater than 30cm, it will be half a circle to the left, and half a circle to the right when it is less than 30cm.

4. When the body is parallel to the edge of the library, return to the positive direction.

5. Observe the left rearview mirror, and stop when the rearview mirror is just over the left front horizontal line of the reservoir area.

6. Outbound is the same as making the warehouse. When the hood covers the front line of the storage area, it quickly hits the right direction, and the body is returning to the right direction and drives out of the test area.

1. First of all, you need to check the rearview mirror of the vehicle before entering the vehicle.

2. Adjust the seat to reach the most ideal position when driving yourself.

3. When the rear wheels of the body reach the cash out of the warehouse, the steering wheel is killed to the left (one and a half turns).

4. When the direction of the body is right, go back to the right for half a circle in the direction of the bridge stool and count three seconds in the student's heart, and then beat the steering wheel to the left, and keep driving at a constant speed for two to three seconds.

5. Reverse into the garage from the left side: When the vehicle starts to start, then hit the steering wheel to the left, return the steering wheel half a circle to the right, maintain a constant speed, walk for four seconds, and then kill the steering wheel to the left.

6. When the body is parallel to the library sideline, return to the steering wheel.

7. When the body is completely reversing into the garage. That is, to complete the left side of the reversing warehousing project, and then to the right to drive the reversing warehousing project.

Subject 2: The most important thing is to find the right point and then beat the steering wheel to death, and the storage repair does not need to be repaired directly into the warehouse, etc., to see the body parallel to the line, back to the positive direction and then find the storage point (the door handle on the right side line of the person point can be) is very convenient. Here's how:

First, subject 2 reversing the mastery of the storage point.

A point is a point where we take a certain point as our visual reference and perform a specific action in the process of reversing into storage. Regardless of whether it is a right or left inverted library, there are two most important points:

The first point is the point where the steering wheel is killed to the left and right when the warehouse is reversed, and the characteristic is that the edge line under the left rearview mirror coincides with the starting line (dashed line).

The second point is when the body has been completely reversed into the garage, the body has been straight and in the center of the garage, then it is time for the right storage to be completed and parked, and the parking point at this time is what we call the second point.

The left side reverses into storage.

1. Left out of the warehouse.

Look at the left door, when the line out of the garage line is aligned with the middle of the two doors, the steering wheel to the left to hit one and a quarter, and then add a circle and a vertical, keep still to know, the window switch is pressed to the line out of the garage to stop.

2. Left storage.

Hang the reverse gear, pay attention to the steering wheel, that is, keep the steering wheel in a circle and one vertical. When the left rear wheel is pressed to the left corner extension line (note that it is fast pressed, it is too late to press the extension line, there may be some abstraction here, the extension line has to be imagined by yourself, it is the extension line of the left line in the library) The steering wheel is killed to the left, when the left rear wheel is fast into the garage, see if it is to be repaired, ensure that the left rear wheel into the garage and then look at the right rearview mirror, expose the right corner of the steering wheel back to the right. The parking point is the same as above.

During the exam, the whole process of reversing into the warehouse is the right into the warehouse, the left out of the warehouse, the left into the warehouse, the right out of the warehouse, the need to see the above points, according to the point operation can ensure that there is no problem. It is advisable to slow the whole process, because slow can have time to fix, but it is not possible to stop.

The right side of the car is reversed into storage.

1. Right warehousing.

At the first point, the lower edge of the left mirror is pressed parallel to the left mirror's library line when the steering wheel is killed to the right.

The second point, when the most convex part of the body and the right corner of the garage are two finger widths in the right rearview mirror, the steering wheel turns back to the left, and here it is emphasized that the next circle is not more or less.

The third point, in the right rearview mirror, points to the middle of the front door handle of the car, and then to the right.

Fourth, from the left rearview mirror, you can see that the steering wheel in the left rear corner immediately returns to the right.

The fifth point, that is, the parking point, is still to stop when looking at the lower edge of the left rearview mirror and the fast pressure parallel to the left rearview mirror.

2. Right out of the warehouse.

When the left rear wheel out of the library line, to the right to kill, look at the window line and the library line parallel to the back of the right, at this time should be large in front of the small back, this is because the body itself is in arc, it looks oblique in fact stopped right.

The left library can be the same as the right library step in the opposite direction, the following is an introduction to the left library that my coach taught at the time, the advantage of this left library is simple, the disadvantage is that there is a dead spot when the library is reversed. (What is a dead spot?) It is to be repaired early, and it may be pressed late)

C1 driver's license subject 2 reversing storage test highlights and skills: 1. Operation: 1. Step on the clutch and brake; Hang the reverse gear, (new regulations:

hit the right turn signal), release the handbrake; Loose foot brake; 2. Slow release clutch reversing; Look back at the right rear, the middle column (black bar) of the right rear window is aligned with the right corner of the garage, and immediately go to the right at a constant speed; As soon as you see the entire left sideline in the left mirror, you immediately return to the steering wheel. Observe the rearview mirrors on both sides and straighten the body; When the left door handle (blue dot marking) is level with the bottom line of the garage, it will stop. 3. Shift one gear forward, when the head cover is close to the white line (7 meters line) and is about to touch the white line, hit the steering wheel at a constant speed to the left, turn to the left, and stop the car straight.

4. Don't go back to the direction, keep the steering wheel to the left, directly reverse gear, backwards, and pay attention to the left rearview mirror. When you see the entire right line in the right rearview mirror, you immediately return to the steering wheel. Continue to look in the left rearview mirror and straighten the body; When the right door handle (blue dot marking) is level with the bottom line of the garage, it stops.

5.Shift one gear and move forward, when the headhead cover is close to the white line (7-meter line) and is about to touch the white line, hit the steering wheel at a constant speed to the right, turn to the right, and stop immediately. Second, the test standard does not follow the prescribed route order, 100 points will be deducted if the vehicle is not completely poured into the warehouse, 100 points will be deducted from the body line, 100 points will be deducted from stopping halfway, and 100 points will be deducted (before the test students can park before entering the warehouse, now, once the GPS positioning determines that the vehicle is in a state of complete stop, the students will be directly deducted 100 points. )

No matter which side you are falling, you have to look at the reversing mirrors on both sides, which side is wider and which direction you are heading.

The simplest way to reverse into the garage, when the front wheel of the car retreats past the dashed line, it is the time to kill the direction, pay attention to the left dotted line, and notice that once the front wheel exits the dashed line, it will immediately kill the direction, (in fact, the dashed line is the preset steering dashed line for the driver).

Here's how I usually do this: drive into the reversing area and stop (don't go too far) when the front wheels don't go far beyond the dotted lineThen reverse, turn your head to look at the point behind you, and then kill the direction almost immediately (because the wheel doesn't go far beyond the dotted line, even if you can't see the point behind you, you can kill the direction in about a while).

Or you don't look at the dots in the back, just look at the dotted line and kill it. But generally I don't recommend this, after all, this is reversing, or the rear is a reference, the dotted line is a reference standard, and there is a small trick, that is, it is easy to reverse after reversing, you can pay attention to the rear garage line and the highest tangent of the rear wheel when parking, so that it is perfect to park in the middle. (Of course, this standard varies from car to car, so you can get out of the car and find a reference line yourself.) )