5 work summary templates for supervision in the first half of the year

1. Do a good job of pre-control and strictly control the start of work.

In the whole supervision process, we adhere to the pre-control and active control, according to the contract and design documents to prepare the supervision plan, the development of specific supervision procedures, clear work content, actors, acceptance standards and work requirements.

Before the start of the project, according to the requirements of the supervision specifications, we reviewed the qualifications of the construction unit, on-site quality management, technical management organization, personnel, system and the qualifications and employment certificates of special types of operators. According to the construction organization design plan submitted by the contractor, the construction organization design was reviewed, and the "supervision plan" was prepared accordingly to conduct an on-site review of the measurement, positioning and pay-off of the project, including the axis size and horizontal elevation, which further clarified the supervision objectives and requirements, and created conditions for the smooth development of the supervision work.

2. Strictly control the entry of raw materials and semi-finished products.

All raw materials and semi-finished products must first be inspected in writing, that is, the inspection certificate, permit, warranty policy, etc., and the appearance inspection shall be carried out after meeting the requirements. The construction materials certificate and quality insurance policy of this project are complete, and the main building structural materials such as steel, cement, stone, and yellow sand have been re-inspected after entering the site, all of which meet the qualified requirements.

3. Strict process inspection and strengthen process control.

In the process of construction supervision, strengthen the means of inspection of the construction process, so that the first inspection after the construction, the previous process is not accepted shall not enter the construction of the next process, the acceptance of the concealed project Our project supervision department attaches particular importance to the on-site supervision of the key and key parts, such as cast-in-place reinforced concrete, beams, plates, ladders, roofs, etc. In the construction, we attach great importance to and strictly control the construction quality of reinforced concrete engineering, especially the floor engineering, in the whole construction process, we focus on the quality of steel binding production, the pouring thickness of the plate, the mix ratio of concrete, slump and maintenance, etc., to ensure the construction quality of concrete. In the construction of the wall, we grasped the following keys:

One is the wet water of the bricks; the second is the correct mixing of mortar; The third is the quality of masonry, in which the fullness, cohesion, vertical flatness of the mortar and the setting of tie ribs are supervised as the key.

In the process of supervision, a total of 9 supervision work contact sheets, 33 supervision engineer notices, 3 safety hazard rectification notices, in the process of project implementation for project quality, cost, progress, safety, contract management and other matters held weekly site meetings, and according to the actual situation of the project held 12 times.