Section 3 manual transmission starts correctly, do you need to step on the accelerator to start with

First, "step" on the clutch, "hang" in first gear, "hit" the left turn signal (to remind the driver of the rear car to pay attention to safe avoidance), "honk" (to attract the attention of pedestrians or motor vehicles around the vehicle) and then "release" the handbrake.

Remember the following starting mantras:

Start 1st gear hangs, turn (lights) honk.

Release the hand brake and don't miss the rear view.

Clutch "fast, slow, stop", gently add oil.

Pause to "add" with oil", the point is on it.

1. Before starting, the test requires the left turn signal to be used first, and then start normally after observing whether there is a vehicle passing through the rearview mirror, in order not to do superficial work, but to remind the rear car that I want to start, on the other hand, under the premise of full observation, we will start more calmly. Observe before starting, and release the clutch when the conditions are suitable for starting, so that the operation will not be affected by the tension of the passing vehicles, and you can start slowly.

2. The starting sequence is to hit the turn signal, press the clutch pedal to the end with the left foot, hang it into first gear, press the horn, and then release the handbrake to start. First of all, gently lift the clutch to the semi-linkage point, then hold still, when the car is moving forward, you can slowly release the clutch, and lightly press the accelerator to start.

3. The timing of gear shift is not difficult to master, the timing of gear shift is different for each car, and it is necessary to shift gears according to the specific situation, that is, speed and road conditions. Don't keep your eyes glued to the tachometer during the exam, pay more attention to these in your daily practice, and you will soon be able to grasp the reasonable timing of gear changes.

It is important to note that:

1. When you hear the voice prompt "please start", step on the clutch, put the gear into first gear, hit the left turn signal (more than 3 seconds), and at the same time (turn the head left) to observe the left rearview mirror, confirm the safety, sound the horn, put the parking brake, start smoothly, and correct the turn signal. Backward slipping is prohibited at the start of a slope.

2. After the candidate completes all the required items and the driving distance is greater than 3 kilometers, the system will automatically prompt him to pull over and park Hongxiang.

3. Turn signals for turning left and right at intersections, changing lanes, turning around, overtaking, and pulling over, be sure to wait for the end of the instruction.

Section 3 starts with detailed steps

1. Turn on the left-turn silver heading lamp; 2. Step on the clutch; 3. Hang a file; 4. Honk the horn for more than three seconds; 5. Pull the handbrake with the right hand, and slowly balance and lift the clutch to semi-linkage (the body shakes or the tachometer needle drops); 6. Release the handbrake quickly; 7. After walking 2 meters on the semi-linkage start, the clutch can be slowly released to the linkage state; 8. Look left and right in the rearview mirror again to ensure safety and merge into the driving lane.

Subject 3 Getting Started Steps:

1. When you hear the voice prompt "Please start", press the clutch pedal with your left foot, and then put the gear into first gear.

2. Turn the turn signal switch down, the left turn signal must be maintained for more than 3 seconds, and at the same time, turn your head left to observe the left rearview mirror, and sound the horn after confirming the safety.

Subject 3 starting attention:

1. When lifting the clutch, we can observe the speed or engine sound, when the speed is in line with the engine or the engine makes a low sound, the speed of lifting the clutch should be slow, and then refuel lightly.

2. Be sure not to slip the car, if the car is more than 30 cm during the exam, you must have failed the course. So before letting go of the handbrake, it is best to observe the road conditions ahead, if it is uphill or downhill, it is best to step on the brake with the right foot, slowly release the clutch, when the body begins to shake more vigorously and cautiously, the left foot stabilizes the clutch pedal and does not move, the right foot slowly releases the brake, and when the car moves, then completely release the brake.

Or postpone the handbrake, put the right hand on the handbrake when starting, gently lift the clutch with the left foot, slightly add some oil to the right foot, and gently lift the clutch with the left foot to the semi-linkage state, keep the clutch still, and then make up some oil a little, and then immediately release the handbrake.

1. Press the clutch pedal and hang into first gear. When you hear the voice prompt, please take a losing step, step on the clutch pedal with your left foot, and put the gear into first gear.

2. Turn on the left turn signal, turn the turn signal switch down, and the left turn signal must be kept for more than 3 seconds.

3. Observe the left rearview mirror, turn your head left to observe the left rearview mirror, and sound the horn after confirming safety.

<> The following are the precautions for starting with subject three:

2. Remember not to slip, if you slip more than 30 cm during the exam, you must fail the course.

3. Before letting go of the handbrake, observe the road ahead and check the teasing situation, if it is uphill or downhill, step on the brake with your right foot and slowly release the clutch.

4. When the body begins to shake violently, the left foot holds the clutch pedal steadily, the right foot slowly releases the brake, and when the car moves, then completely release the brake.

1. Get started. Step on the clutch, step on the brake, hang the first gear, hit the left turn signal, honk the horn twice, observe left and right, release the handbrake, release the clutch, release the brake.

2. Gear operation.

Second gear on third gear: step on the accelerator, the speed rises to about 20, step on the clutch, hang the third gear, release the clutch, and step on the accelerator.

Third gear on four gears: Same as above, the speed rises to about 35 40, hang four gears.

Four gears down to three gears: step on the brakes, step on the clutch, the speed drops to about 30, hang three gears, release the clutch, and step on the accelerator.

Third gear down to second gear: Same as above, the speed of the car is reduced to about 20, and the second gear is hung.

3. Lane change and overtaking.

Turn left and right, observe whether the steering side rearview mirror is suitable for lane change, and step on the accelerator.

4. Pass through various areas and intersections.

Passing through schools, sidewalks, intersections, etc., as long as you hear the word pass, apply the brakes.

5. Keep driving in a straight line.

In the case of third or fourth gear, hold the steering wheel tightly, step on the accelerator, increase the speed of the car banquet to 40km h, keep a broken distance, (note: the steering wheel can not be greatly adjusted during the period) When you hear that you have passed or tested the next item, you can reduce the speed.

6. Turn left and right.

Change lanes first, go to the lane that is allowed to turn well, hit the turn signal, downshift, and second gear is the most suitable.

7. Turn around. Downshift, (one gear is the most suitable) hit the left turn signal, out of the road crossline, can be adjusted to the right appropriately, and then control the clutch slow rubber to turn slowly to the left, (note: the U-turn is not completed, never upshift).

8. Pull over.

Downshift, (first gear is the most suitable) hit the right turn signal, move slowly in the rightmost lane, slowly adjust the distance from the side of the road, and the front of the car and the curb completely coincide to 30cm (optimal).

9. Get off the bus. After the car is stopped, hang neutral, pull the handbrake, release the clutch, release the brake, turn off the engine, unbuckle the seat belt, observe the traffic flow in the left rear, open the door, get out of the car, and close the door.

The detailed steps of the starting operation of Kesan manual transmission are: step on the clutch pedal, hang in the first gear, turn on the left turn signal, observe the left rearview mirror, put down the handbrake, and change the second gear.

Materials prepared for the old blind: vehicles. 1. Press the clutch pedal and hang into first gear. When you hear the voice prompt, please start, press the clutch pedal with your left foot, and put the gear into first gear.

2. Turn on the left turn signal, turn the turn signal switch down, and the left turn signal must be kept for more than 3 seconds.

3. Observe the left rearview mirror, turn your head left to observe the left rearview mirror, and sound the horn after confirming safety.

Section 3 manual transmission start teaching.

In the first step, when you hear the voice start, press the clutch pedal with your left foot, press all the way down, and then put the gear into first gear with your right hand. The second step is to hit the left turn signal, hold it for three seconds and then observe the rearview mirror, if there is a car, keep the current action to confirm that there is no car or the vehicle is at a safe distance. The third step is to put down the handbrake, step on the brake, slowly lift the clutch with the left foot until the clutch reaches the semi-linkage state, release the brake with the right foot, and gently refuel the accelerator.

In the last step, release the clutch completely after a smooth start, and slowly refuel until you reach the speed of hanging 2nd gear. Step on the clutch, shift into second gear, accelerate the light gas, and slowly drive into the driving lane. If you are not skilled, you can also complete the steps of entering the carriageway separately.

This is the detailed steps of the third branch, and we must be bold and careful.

1. Insert the key into the ignition lock, turn on the ignition switch, and then observe whether the instruments are working normally, and start the engine. If the instrument is not working properly, the engine should be turned off immediately, and the engine can be restarted only after checking and eliminating the fault.

2. Step on the clutch pedal and put the gear lever into 1st gear.

3. Turn on the left finger (right) turn signal, honk the horn, and observe the front, left and right, above and rearview mirrors of the vehicle at the same time to see if there is any obstacle to the start, and pay special attention to safety.

4. Relax the parking brake lever (commonly known as "hand brake") and hold the steering wheel (commonly known as "steering wheel").

5. Lift the clutch pedal (this is the key to a smooth start). The essentials are: first quickly lift the clutch until the engine sound becomes lower (at this time the pressure plate and the follower disc begin to rub), release the clutch pedal to slow down, wait for the body to shake slightly (the clutch is in the associated movement), pause the clutch pedal slightly, and at the same time refuel a little, and then slowly lift the clutch pedal.

The third subject is a part of the motor vehicle driver's license assessment, which is the abbreviation of the road driving skills and safe and civilized driving knowledge test subjects.

The content of the road driving skills test generally includes: preparation for getting on the car, light simulation test, starting, driving in a straight line, adding and decreasing gear operations, changing lanes, pulling over, going straight through intersections, turning at intersections, meeting cars, overtaking, U-turns, night driving, etc., and the content of different quasi-driving tests is different. The content of the safe and civilized driving knowledge test generally includes:

Safe and civilized driving operation requirements, safe driving knowledge in bad weather and complex road conditions, and handling knowledge after traffic accidents.

1. Observe before starting, before starting, the test requires you to play the left turn signal, and observe whether there is a vehicle behind you through the rearview mirror before starting normally.

2. Gently lift the clutch to semi-linkage, and then stabilize not to move, when the car slowly goes forward, you can slowly release the clutch, lightly step on the accelerator, the steering wheel to the right half a circle, and observe the right rearview mirror.

3. Confirm that there is no barrier, slowly lift the clutch to semi-linkage, stabilize the clutch, release the foot brake, and the vehicle starts.