Which is better, Midea electric water heater F80 16A or F80 15A

Blue diamond liner, anti-explosion, anti-solvent, anti-acid, long service life, durable;

Safety early warning: patented anti-electric wall technology completely solves all kinds of environmental leakage problems, monitors the electricity environment, and ensures bathing safety at all times;

Novel appearance design, smooth lines;

Mechanical knob switch, power on temperature adjustment, energy saving and power saving;

Extra-long and low heat load heating element, longer life;

Thickened polyurethane overall foaming technology, better thermal insulation and energy saving effect;

Fully automatic control: automatic replenishment of cold water, automatic heating;

Equipped with high-quality temperature controller, reliable work and accurate temperature control;

It adopts multiple protection devices such as anti-dry burning, anti-over-temperature, anti-leakage, anti-high water pressure, etc., as well as IP 4 waterproof design, which is safe and secure.

Brand: Midea: Model F80-15A: Maximum volume: 80L, maximum heating power: 1500W, Liner Material: Blue Diamond Liner, Liner, Rated Pressure Size, Product Dimensions: (Diameter*L): 450 x 760mm

Outer box size (L*W*H): 870 x 575 x 515mm Weight Product Net Weight: 28kg

Product Gross Weight:

Which is better depends on the amount of water you need for hot water. If you use a lot of water, you need to use a large inner tank, but the corresponding electricity will be more, and the insulation time of the inner tank will be short, and the corresponding electricity will be more. If you boil water and set it aside for a longer time, you will use more electricity accordingly.

Opposite; If the internal timid is small, the heat preservation is good, and the waiting time is short, the corresponding electricity consumption is less. You have to think holistically to know which one is affordable.

Summary. Hello, the above questions will be answered by me. Midea F80-15GA1 (H) water heater discharge method:

1. Close the water inlet valve, open the water outlet valve, and lift the safety valve handle, this method has a slow drainage speed. 2. Close the water inlet valve, lower the mixing valve and safety valve, and the water discharge speed is faster. 3. Close the water inlet valve, open the water outlet valve, and lower the sewage outlet nut to discharge the water at the fastest speed.

Hope it helps!

Midea's F80-15GA1 (H) water heater discharges.

Hello, the above questions will be answered by me. Midea F80-15GA1 (H) water heater discharge method: 1. Close the water inlet valve, open the water outlet valve, and lift the safety valve handle, this method has a slow drainage speed.

2. Close the water inlet valve, lower the mixing valve and safety valve, and the water discharge speed is faster. 3. Close the water inlet valve, open the water outlet valve, and lower the sewage outlet nut to discharge the water at the fastest speed. Hope it helps!

Can't find it. Hello, the above questions will be answered by me. The first way to discharge water from Midea electric water heaters is like this.

First of all, it is necessary to close the water pipe valve (inlet valve), and at the same time, it is necessary to screw one end of the drain pipe to the pressure relief hole of the safety valve and open the safety law handle. Hope it helps!

It can only be calculated to boil a pot of water: 80 liters of water temperature rises by 30 degrees and it takes kilojoules to total kilowatt-hours of electricity.

If you don't stop using hot water, calculate the degree according to the maximum power.

You don't need hot water for a day, and you need very little energy to keep warm.

This water heater can be used for about 15 minutes for a 7-litre shower for two hours. It is estimated that you are asking about the power consumption of being plugged in and insulated, which is not easy to say, the individual differences are relatively large, and it cannot be used twice a day in the southern winter.

Depending on how high your power is, 1000w is 1 kWh an hour.

2.Fire, the zero line is reversed. 3.The neutral line is live. In addition, there is a problem with the bottom line you are taking. If you put the bottom line between the water heater and the wall, wouldn't it be back to the water heater body if electricity leaks? Rectification is recommended.

There is no problem with the safety indicator light on, it is just a precaution, because the indicator light will be on if it exceeds 12 volts. If there is no ground wire, it is recommended to turn off the power when taking a shower.