How to deal with the inspection port of the toilet sewage pipe for house decoration?

The toilet sewage inspection port can be sealed after the renovation is completed, and it must be sealed after the decoration is completed, for insurance. The toilet sewage inspection port is equipped with an openable inspection cover and is installed on the drainage riser and the long transverse pipe section for inspection and clearance.

The inspection port is generally installed in the riser, for the connection between the riser and the transverse branch pipe when there is a foreign body blockage, and the drainage riser of multi-storey or high-rise buildings should be installed every other layer, and the spacing between the inspection ports is not more than 10m. However, on the lowest floor and on the top floor of a building with a slope roof of more than two storeys with sanitary appliances, an inspection opening must be installed, and a ventilation opening can be used instead of a checkpoint for a flat-roofed building. In addition, if the riser is equipped with a B-shaped pipe, an inspection opening should be provided at the upper part of the B-shaped pipe.

When the drainage cross branch pipe section exceeds the specified length, an inspection port should also be set. The height of the inspection port is generally 1m from the ground to the center of the inspection port.

You just plug the drain pipe into the inspection well and cover it with mortar, according to my years of experience, if it is an inspection well in the greenery, there is not much sinking, there is no load on it, unlike the inspection well on the road, because it has to pass the car, so it sinks.

The inspection port can be sealed after the renovation is completed! I also have this in my family, which was sealed in the later period, and it was sealed in the later period for the sake of insurance!

To prevent sand garbage from falling in, plug the mouth with a cloth.

It is advisable to consult a professional construction personnel.

One is that the riser is sealed when the package is sealed, but the property will not agree.

One is to wrap the riser and tile the opening, and open it at the inspection opening.

The fifteenth episode of Tai Shi Ci fights the little overlord Sun Bofu vs. Yan Baihu.

In general, the drain pipe is wrapped after the inspection port has been treated.

If you want to check it, you need to disassemble it so that it can be checked.

See if there are any tears that need to be repaired and replaced, and then cleaned.

This is to make a reasonable and correct arrangement according to the actual situation.

Let's see if there is a crack that needs to be repaired and replaced, and I think the professional master must know.

This is the business of some decorators, and they must know how to deal with it.

I think other professional masters must know, right?

If the drain pipe in the bathroom is enclosed, it is best to ask a dedicated maintenance person for the inspection opening.

For such a treatment, in fact, most of them are professional decorators, and they have already carried out an operation when decorating。The choice to wrap the drain directly is to prevent the drain from being blocked in the future, and when checking the port, most of them will not be operated by themselves.

Because the process in this is relatively troublesome, if there is no quality problem, basically there will be no more open inspection of him, so the inspection mouth will basically be completely sealed. Because the drain pipe and inspection port of the bathroom are relatively hiddenFor most residents, there is not much concept of these two places themselves.

And if something goes wrong, you can't solve it by relying on your own abilities alone, so they will choose to just let it be closed. In addition, if the drain pipe and inspection port of the bathroom are not closed, it will cause other items to fall into the drain pipe in the subsequent use process, and it is very likely that there will be blockages and the second drainage.

It will be more troublesome to overhaul him after such a situation appears, so it will be directly processed in a closed way at the beginning to prevent all kinds of troubles in the later stage. Although it may sound like an undesirable action, it actually has more benefits in the process of subsequent use.

In today's life, it can be said that the bathroom is a very important room in this family, in this room, people have to bathe, wash, and defecate, etc., which is very important. In addition, when the hydropower master installs the hydropower pipeline, this is a very troublesome problem, and there are many things involved. We all know the power of water, in ancient times, people compared water to everything that can penetrate, and this is how the dripping stone wears out.

However, when the plumber installs, he will explain to the homeowners that the drainage pipe is wrapped, so that no other debris enters the drain, especially in the later stage of decoration. Because in the later stage of decoration, there are a lot of people coming and going at this time, and they are afraid that something important will fall down, so they can't take it out, but also to avoid such a thing.

Checking the presence of a port actually adds another risk to the home. When the developer delivered the house, some of the maintenance ports were not tightened. If the master decorator does not pay attention, the package is wrapped directly.

Drain water, which has been a hidden danger for many years, and water leaks from downstairs. Many owners simply can't think of this factor. As a result, all the floor tiles were removed and waterproofed, but the end result was still a leak.

The significance of the inspection opening is that if the water pipe is clogged, the water pipe will be unblocked through the inspection opening. Sewage pipes and domestic water will flow in the water pipes. The water doesn't get stuck in the middle, and the water flows from the upper layer to the lower layer.

In this way, it is necessary to seal it so that it is not necessary to happen in the future, so the advice of the hydropower master should still be listened to.

After the drain pipe is wrapped, it can also be sealed after the inspection port is renovated, which is more safe.

After the drain pipe is wrapped, it is best to seal the inspection opening, otherwise it will affect the drain pipe.

After the drain pipe is wrapped, the inspection port can be wrapped, too, to prevent other things from falling in.

After the insulation cotton wrapping column is built with red bricks, the maintenance port will be reserved when the drainage pipe with the maintenance port is built.

The drain pipe inspection opening in the bathroom should be reserved, one is to prevent important things from falling, and to prevent water leakage.

You can find a professional maintenance person to help you see, they have many solutions.

The general is to make a wooden board to cover it, and there is also a way to cut the joint on the back of the tile at the manhole when the bricklayer is tiling, and then use caulk to hook the joint, which does not look obvious on the outside.

This is done by going downstairs to the user to check the sewer for leaks.

The farthest end of the horizontal pipe part of your own house is a floor drain or wash basin, you can not have an inspection port, the first floor of the riser must be set up, and a multi-layer interval can be set up on several floors. There is no need for checkpoints.

The national water supply and drainage engineering acceptance specification stipulates that "an inspection port should be set up every other layer on the drainage riser, and the orientation of the inspection port should be convenient for maintenance.

There is no requirement for sewer pipes to leave checkpoints. High-rise sewers are generally separated by four floors with a checkpoint, my home is catching up with a checkpoint, it is best not to cover the whole package when decorating, leave the checkpoint out, make a small door, in case the water is blocked in the future Dredging will be convenient, the sewer pipe checkpoint is not good.

You put bricks at the checkpoint to cut the bricks, but don't cut them to the end, use grout on the hook, to be honest, you may not need it for 100 years, Beijing does this.

This is not true, but if the upstairs is blocked, you will be in trouble, and the property will ask you to remove and repair it.

Sewer dredging refers to the blockage of sewers in daily life, including sewer pipes for toilets, floor drains, sinks, vegetable sinks, etc. Some of these pipes are clogged due to accidental drops or installation errors. Some pipelines will be scaled during use, which will make the inner diameter of the pipeline thinner and affect the normal sewer discharge.

The above two situations are generally easy to deal with by using a pipe dredging machine to dredge directly or replace the pipe. If cement is entered during the renovation process, it is very difficult to dredge, and there are very few people who can effectively deal with it, so the cost is also very high.

In practice, the largest workload is municipal pipeline dredging. The use of these pipelines is more complex, once the blockage causes greater harm, the dredging of this pipeline generally uses high-pressure cleaning vehicles to clean the pipes, and the larger the diameter of the pipes, the higher the performance requirements of the vehicle. Generally, the cleaning range of high-pressure cleaning vehicles on the road is pipes with a diameter of less than 500 mm.

Pipes with a diameter of 600 or even 800 or more, this kind of cleaning truck can only rely on luck, which requires the use of ultra-high pressure cleaning vehicles to dredge. If you want to fundamentally solve the problem, you need to clean out all the sludge inside, which uses equipment such as sludge cleaning machines.

Ceramic tile and tile are refractory metal oxides and semi-metal oxides, through the process of grinding, mixing, pressing, glazing and sintering, and form an acid-alkali resistant porcelain or stone, building or decorative materials, called ceramic tiles. Its raw materials are mostly mixed with clay, quartz sand and so on.

Generally, many people use a kind of plugging material to wipe that piece, or make a baffle to cover it (similar to wrapping it up), and once you want to use it, you can remove the plugging material and baffle.

Leave a hole, and for the overall look, you can make up a brick, of course, if you can move. There is also the need to make a door, which should be regarded as decoration.

It is best to leave a hole in the whole brick, glue the brick on the side of the back along the edge of the short wooden block, and finally clip the brick into the reserved hole, and the outside cannot be seen carefully.