I just bought a router, how do I set it up?

I would like to ask this question as well.

The installation and setup of the router is as follows:

1.First connect the line, you can refer to the figure below.

2.After the line is connected, open a browser, enter the management address and management password of the router, and then enter the router background (the login address and login password of the specific router can refer to the manual or the label on the back of the router).

3.Once you've logged in to your back-office, select Quick Settings, then click Next.

4.Choose the way to access the Internet, usually ADSL users choose the first PPPoE, if you use other network service providers, then choose the following two according to the actual situation, if you don't know how to choose, directly select the first item to automatically select, convenient for novice operations, click next after selection;

5.Enter the password applied for from the network service provider, and go directly to the next step after entering.

6.Set the wifi password, try to make the alphanumeric combination more complicated, and it is not easy to be rubbed off the network.

7.After entering it correctly, it will prompt whether to restart the router, select Yes to confirm the restart of the router, and you can access the Internet normally after restarting the router.

Set up a wireless router at home and use a computer or mobile phone to access the Internet from any address in your home. However, many people usually buy a wireless router home and don't know how to set it up. Here's how to set up the router I just bought, I hope it will help you.

Step 1: Go to the router's settings homepage, click "Setup Wizard" on the left and then click to enter (usually automatically pops up).

Step 3: Now you have entered the Internet mode setting page, you can see that there are three ways to choose from Internet access, pay attention to the fact that if your home is using ** line dial-up Internet access, choose PPPoE (ADSL virtual dial-up) dynamic IP, the general computer can be used directly plugged into the network, and there is a DHCP server on the upper layer. The static IP is generally a private line or something, or it may be the cell bandwidth, etc., and the upper layer does not have a DHCP server, or wants to fix the IP.

I'll take the more common dial-up Internet access method as an example to set up a wireless router, and then click "Next".

Step 5: This step enters the wireless settings, we can see the channel, form, security options, SSID, etc., usually the SSID is a name, you can fill in at will, and then the form is mostly 11BGNWireless security options, we have to choose WPA-PSK WPA2-PSK, so that it is safe, so as not to let people hack and rub the network.

Step 6: The system will pop up a wizard prompt page with successful settings, click "Done" and the router will automatically restart, so you can wait patiently. The interface that appears after success.

1. First of all, connect the line as shown in the figure.

2. Enter the router's ** in the browser to log in to the router's management interface.

3. Then wait for the system to automatically detect the Internet access mode and fill in the broadband and broadband password.

4. Then set the name and password of the wireless router.

5. Click OK to do so, so that the Internet is set up successfully.

Notes:1. When setting, you need to distinguish the case of English letters.

2. The broadband password and the password of the wireless router need to be recorded.