The formwork supports the technical disclosure of high formwork

High formwork formwork support engineering safety technology disclosure.

gdaq330202

Construction unit: project name sub-item.

Engineering type of work.

1. When entering the construction site, safety operation procedures and safety production discipline must be observed, and special operations personnel must be certified to work.

2. Operate in accordance with the requirements of the high formwork support scheme.

3. Before operation, check whether the tools used are safe and firm, and whether the operating conditions and foundation meet the safety requirements.

Fourth, in strict accordance with the floor height of more than 5m high formwork formwork support safety construction plan for erection, unqualified materials, fasteners are not allowed to use.

5. The bottom of the bracket pole should be provided with a base or backing plate and a longitudinal and horizontal sweeping rod, the fasteners on the pole should be staggered, the bracket pole should be set vertically, and the perpendicularity of the 2m height is 15mm.

Sixth, the length of the column is strictly forbidden to lap, must be connected by butt fasteners, the butt joint of the adjacent two columns shall not be in the synchronization, and the distance of the butt joint along the vertical staggering should not be less than 500mm, and the center of each joint should not be greater than 1 3 of the step distance from the main node.

7. All single column supports should be in the center of the bottom skids and the beam bottom formwork, and should be in close contact with the bottom skids and the top beam bottom formwork, and should not bear eccentric loads.

8. A longitudinal scissor brace should be arranged on the four sides of the formwork support and every four rows of support poles in the middle, which shall be continuously arranged from bottom to top.

9. When transmitting steel pipes and other materials, it is strictly forbidden to touch, touch or pressure the power supply wires.

10. Wrenches, fasteners, and nuts should be put into the tool bag and not allowed to be thrown.

Ten. 1. The size of the template is accurate, and the installation template must be nailed (buckled) firmly in time, and no loose plate or floating plate shall be left, and the reserved orifice should be closed firmly in time.

Ten. Second, the use of hand-held electric drills, electric saws should meet the requirements of safe electricity, if there is a fault, should be turned off first, sent to the machine repair team for maintenance, unauthorized maintenance is not allowed.

Ten. 3. In case of six-level gusts of wind or heavy rain, the operation should be stopped.

Ten. Fourth, the erection must be strictly accepted, unqualified is not allowed to carry out the next process operation, is not allowed to strengthen the side of the steel bar while binding the steel bar operation, to prevent collapse accidents.

Ten. 5. On-site supplementary disclosure content:

Signature of the informant:

Date: Signature of the recipient (all members):

Note: This disclosure is in triplicate, one copy for the team, one copy for the informant, and one copy for the data custodian.

According to the Ministry of Construction (2009) No. 254 document, the technical disclosure of formwork support high formwork support can be carried out according to the content of the high formwork support scheme.

The relevant requirements of the No. 254 document of the high support formwork.