-
Dear Samsung users, Hello!
Sorry, since the specific model of your phone is not known, it is recommended that you:
2.Back up your phone data (**book, short message, multi** files, etc.), restore factory settings (settings-reset-factory reset) If the problem still exists, it is recommended that you bring the mobile phone three-pack voucher and send the mobile phone to the nearest Samsung service center for testing.
-
I have also encountered such a problem on my phone, this is the phone system is damaged.
Your phone is rooted, right? It's normal to have such a problem, just restore the factory! Equal to the grid machine.
Method: Press and hold the power button and volume down when you turn it on, otherwise the volume increases. There's one anyway.。。 Then you will enter an English interface、There is a factory reset option in it.,It's in English.,If you can't understand it, just don't read it!
-
We recommend that you perform the following steps:
Step 1: Please press and hold the power button and the down volume button at the same time to restart the device for more than 7 seconds.
Step 2: If your phone supports Smart Manager or Memory Manager, it is recommended to close the apps that do not need to run automatically (it is recommended to set the auto-start of instant messaging apps such as WeChat and QQ to "On").
Under the Standby page, find and click Smart Manager.
2.After reading the "Use a network connection" prompt, click OK. (Some of the smart manager's skills require a WLAN connection, and the database will only be updated when the WLAN connection is used.) )
3.Click [One-click Optimize Preparation].
4.Optimization is complete. After optimization, both usable storage and usable memory are freed up.
-
Summary. Hello dear, I'm glad to answer your <>
<> Samsung phone keeps restarting the loop because: 1. Software problems: There is a problem with the software that causes the phone to reboot the loop.
At this time, you can try to restart the phone, if it is still rebooting loop, you can try to restore the factory settings. 2. Hardware problems: If there is a problem with the hardware of the phone, it may also cause the phone to reboot the loop.
At this point, you need to take your phone to a repair shop for repair. 3. Battery problems: The phone's battery is aging or damaged, which may also cause the phone to restart the cycle.
At this point, the battery needs to be replaced.
Samsung phone keeps rebooting loop.
Hello dear, I'm glad to answer your <>
<> Samsung mobile phone keeps restarting the cycle because: 1. Software problems: There is a problem with the software that causes the mobile phone to restart the cycle.
At this time, you can try to restart the phone, if it is still rebooting loop, you can try to restore the factory settings. 2. Hardware problems: If there is a problem with the hardware of the mobile phone, it may also cause the mobile phone to restart the Wu Cheng Pi cycle.
At this point, you need to take your phone to a repair shop for repair. 3. Battery problems: The battery of the mobile phone is aging or damaged, which may also cause the mobile phone to restart the cavity difference cycle.
At this point, the battery needs to be replaced.
Why is Samsung phone on state.
Why can't it be turned on even when charged?
Dear, the Samsung phone is turned on because of software problems, hardware problems, and battery problems, you can check it.
Dear, this may be a battery issue.
-
Summary. Hello dear, I'm glad to answer your <>
Samsung phone keeps rebooting loop can be caused by several reasons:1Software Issues:
It can be caused by a system crash, an application conflict, or a virus infection. At this point, you can try going into safe mode, uninstalling recently installed apps, or resetting your phone's settings. 2.
Hardware issues: This can be caused by aging batteries, power issues, memory failures, or other hardware failures. To check that the battery is working properly, try charging it with a different power adapter.
3.Flashing issues: If you have just flashed your phone or installed an unofficial ROM, it may cause your phone to enter a reboot loop.
The solution is to reflash the phone or install the official Broken keys or touchscreen: If you find that your phone restarts the loop during a specific operation, it may be caused by a damaged button or touchscreen. <>
Samsung phone keeps rebooting loop.
Hello dear, I'm glad to answer your <>
Samsung phone keeps rebooting loop can be caused by several reasons:1Software Issues:
It can be caused by a system crash, an application conflict, or a virus infection. At this point, you can try to enter the safe mode, uninstall recently installed apps, or reset your phone's settings. 2.
Hardware Issues: This may be caused by aging batteries, power issues, memory failures, or hardware failures. To check that the battery is working properly, try charging it with a different power adapter.
3.Flashing problem: If you have just flashed the phone or have missed an unofficial ROM installed, it may cause the phone to enter a reboot loop.
The solution is to reflash the phone or install the official Broken keys or touchscreen: If you find that your phone restarts the loop during a specific operation, it may be caused by a damaged button or touchscreen. <>
The following is a related extension, I hope it will be helpful to you <>
The problem of reboot loop on Samsung phone may be caused by several reasons that are not the same:1Software Issues:
It may be due to a bug in the operating system or a conflict with a third-party application. Workarounds can try clearing cache, restarting your phone into safe mode, uninstalling recently installed apps, doing system updates, etc. 2.
Hardware issues: This can be due to aging batteries, power issues, memory failures, or other hardware failures. To do this, try replacing the battery, checking whether the power cord is plugged in tightly, troubleshooting hardware, etc.
3.Virus infection: A phone infected with maliciously accused software or viruses may cause the loop to restart.
-
The mobile phone has been automatically restarting the cycle is likely to be caused by the mobile phone system laughing and rubber error, you can try to go to the official website of the mobile phone ** flash package and flash tool to repair the mobile phone system, if you can't deal with it yourself, please try to send the phone to the after-sales service for repair.
Poor contact of the battery contacts can also cause this situation, the solution: open the back case, it is recommended to adjust the position of the contacts by yourself with a needle. There is also a possibility that the mobile phone system crashes, the solution: upgrade the firmware on the official website for system upgrade.
Precautions for using mobile phones:
When the mobile phone signal becomes weak, the mobile phone will automatically increase the transmission power of electromagnetic waves, so do not put your ears close to the mobile phone at this time.
Do not answer the mobile phone in the corner of the wall, the signal coverage in the corner of the building is relatively poor, so it will increase the radiation power of the mobile phone to a certain extent. Based on the same reason, when you are in a small and enclosed environment such as an elevator, do not move around at will when you receive a mobile phone, as frequent movement of the position will cause the strength of the received signal to fluctuate, thus leading to unnecessary short-term high-power transmission.
-
Because Samsung phones have an automatic reboot to optimize the device function is turned on, the phone will reboot repeatedly from time to time to keep the phone system smooth. If you don't need to pay back a loss, you can turn off this function in the phone settings.
1. Open your phone, find Settings in the notification bar of the slide, and click Enter the empty Tong, as shown in the figure below:
2. Pull down in the phone settings to find the reset, and click to enter, as shown below
3. Find Auto Restart in Reset and click to enter, as shown below
4. Find the switch button in Auto Restart, and click Close to solve the problem, as shown below
-
Samsung phone keeps rebooting loop, which can be handled by the following methods:
1. Check whether the application software is opened at the same time, and it is recommended to exit the unused software;
2. Check whether the mobile phone battery is in good contact, loose and other reasons;
3. In addition to the above reasons, it is still impossible to deal with them, it is recommended that you go to the mobile phone after-sales maintenance point for inspection.
Samsung mobile phone is a smart phone developed by Samsung Group, and Samsung mobile phones really began to be popular all over the world from the A series. The A-series slag block was originally a folding mobile phone series, and the earliest Samsung SGH-A188 (white shape Heng Mo) and SGH-A288 (internal and external dual screens) are all classics.
The Galaxy series is arguably the most successful series of Samsung phones to date. In the entire Galaxy series, Samsung has adopted Android's smartphone operating system. On December 9, 2016 (Beijing time), Samsung was ready to upgrade its software in the United States to permanently disable the Galaxy Note7 phone.
-
If the phone can be used normally for the time being after the phone automatically restarts, it is recommended that you try the following methods:
1.Check whether the auto-restart function is set: Settings-Reset-Auto-Restart, after turning on, the phone will automatically restart the device at the set time (some machines support this function to slow down).
2.Try to update the system version of your phone (please back up the data in your device before upgrading).
4.If the phone battery is removable, it is recommended that you replace it with another original battery to rule out whether it is a battery problem.
Possible reasons for this are:1.The phone is running out of memory.
2.Software Conflicts.
3.Hardware issues.
I deduce it's basically related to your new memory...
As for the reasons, there may be: >>>More
It is recommended that you connect the power cord during normal use, and if the battery is removable, it is recommended to remove the battery; Try not to completely drain the battery when using it, and it is best to turn it off and charge it when charging.
The device cannot be started due to the failure of flashing, the main reason is the flashing package, caused by operation problems, you can try to reflash other ROMs. >>>More
After the mobile phone is turned on normally, it cannot enter the system normally, which is likely to be caused by a problem with the mobile phone system. >>>More
Apparently the hard drive was broken... It may have affected the disk inside the hard disk.,Cause some data to not be read.。。 Plugging in the hard disk computer slows down, indicating that the speed of the hard disk has decreased, it seems that you have to repair it, but don't worry, the data of the hard disk is not easy to lose, and you can recover the data by repairing it in a professional place.