What should I do if the phone interface keeps being like this after flashing and turning on?

The device cannot be started due to the failure of flashing, the main reason is the flashing package, caused by operation problems, you can try to reflash other ROMs.

Take card swiping as an example: use memory cards (SD, TF, etc.) to flash the machine, card swiping process:

3. Shut down, remove the SIM card, install the memory card, and it is recommended that the important things in the memory card should be backed up.

4. When shutting down, press the power button and the volume plus button at the same time, about ten seconds, and then let go.

5. Enter the recovery mode, i.e. REC mode.

6. Select Wipe Cache Partition to clear the cache.

7. After clearing the cache, select Wipe Data Factory and restore the factory settings.

8. Select "Install Zip from SDCARD", the power button is OK, then select Apply SDCARD:update, and the power button is OK, that is, select the flash package from the memory card to flash the machine, and wait patiently for it to be completed.

Use that volume up and down key to move to almost the bottom, restart, and then, press the power button, and that's it.

Flashing failure will cause this situation, try to reflash other ROM packages, follow these steps:

Save the ROM package into the root directory of the SD card of the mobile phone with the mobile phone card reader;

Enter recovery (different phone models have different entry methods, such as holding down the power button + volume plus);

Select Dual Clear Phone Data (two options starting with wipe);

Select: Install Zip from SD Card

Select the new ROM package and confirm the installation;

Once the installation is complete, restart your phone.

Put the firmware back into the TF card, and then flash the computer again through this interface.

This is the flashing interface, right?,Have you flashed the ROM?? If it doesn't work, just cool wipe it first and then brush it in.,Choose the right rom bag.。

Isn't there a reboot of my phone in the interface?,Just restart the phone.,Just reboot or something.

The first reboot after flashing is slow, and it will take a few minutes to wait.

This is mainly due to system instability and poor compatibility when upgrading or flashing, resulting in system crash or boot file corruption.

Try to solve it with the following method:

1. Restore factory settings.

1. Press and hold the volume down button + power on button at the same time in the shutdown state.

2. The boot interface appears, release it, and enter the recovery flashing tool for a while. Through the volume up and down, select wipe data, OK (the volume button is up and down, the power button is OK), the options appear, and yes.

3. Click Wipe Cache after returning to the menu until it automatically returns to the main menu.

4. Select reboot and reboot. Select Perform data purging and Cache purging, respectively.

Second, if the above methods can't solve the pretending state decision, it is likely to be a hardware problem, and it is recommended to find a maintenance and repair personnel to solve it.

What preparations are needed before flashing.

Necessary preparation - back up your phone data, data is priceless (you can use cloud services or phone backup software to back up).

If the Find Phone function is enabled, please turn it off in advance, otherwise you will need to enter the unlock password after turning on the phone (the flashing package will not have a password).

It is recommended to turn off the lock screen password for Android version and later, otherwise Recovery does not support decryption and may be garbled when reading the built-in storage.

This **ROM package has been tested by my real machine, and the function is normal and can be used with confidence, and it supports root authorization removal system verification.

Some functions require root permission, for a better experience, it is recommended that supersu set up to enable trust system users.