How to clear the MG MG5 tire pressure monitoring fault light when it is on

MG MG5 tire pressure monitoring.

The fault light is on for situation analysis and solutions.

1. The tire pressure monitoring light is on due to the tire being punctured.

Solution: This situation is usually very slow air leakage, for a while can not find out which tire is it, then you can use the tire pressure gauge to measure, front, rear, if there is a lack of air, make up for it, and then observe the tire pressure warning light, if it lights up again after a few days, it may be necessary to check the tire. 4S shop, the usual way for maintenance personnel to deal with it is to adjust the pressure of the two front tires and the pressure of the rear tires, and then cut off the tire pressure alarm, and let us run for another day to see, if you don't call the police again, there will be no problem, and then the police may be a tire that is punctured, and you need to go to a professional car maintenance agency for inspection.

2. The tire pressure monitoring fault light is on due to the high tire pressure of the automobile tire.

Solution: Standard tires: Enhanced tires: Maximum air pressure: should not be greater than, so when a tire exceeds it, the tire pressure monitoring light will be triggered, and the tire will be deflated according to the display data of the tire pressure equipment.

3. The tire pressure monitoring light is on due to low tire pressure driving time for too long.

Solution: This situation usually occurs in: the tire pressure of a tire is too low, and the tire temperature rises due to high-speed operation, which causes the tire pressure to rise, and then the tire pressure rises, so you should stop in time to rest or replace the spare tire.

4. The tire pressure monitoring light is on due to the low tire pressure that has not been refilled for a long time.

When the solution: when the air pressure is lower than the bottom, the tire pressure monitoring light is on, so you should usually check to see if the tire pressure detector is normal. When there is a situation in the car, if the tire pressure monitor does not alarm in time, it is a problem with the tire pressure monitor.

If the ignition switch is on start, the indicator light point and the TPMS indicator light will be on at the same time for 2s and then turn off. In this case, either the original receiver of the vehicle has not been learned, or the receiver controller has been replaced, and the receiver controller has not been learned. You can go to the 4S store and ask professionals to use handheld learning tools to re-obtain all tire sensor IDs and bind the receiving controllers.

It should be that the sensor signal of that tire is lost or broken, learn it first, and replace one if it is not good.

MG 5 commonTire pressureThe monitoring device is generally in the middle of the dashboard in the trip computer. A lot of driving information is in this, but also on the center console, generally every time the key or ignition is inserted in the early corner, the tire pressure monitoring device will be displayed in its corresponding position is a simple tire pressure monitoring system, is the use of ABS ready-made sensing function to compare the number of rotations of the tire, the circumference of the tire with insufficient tire pressure.

It's also shorter, so if one of the four tires is underpressed, the number of revolutions will be different from the other tires.

Tire pressure monitoring systemTire pressure monitoring system is a kind of real-time automatic monitoring of various types of wheel buried tires, which can provide effective safety guarantee for driving.

Hello dear for your question. Dear, the reset method of MG 5 tire pressure lamp is as follows: 1. Re-set the fault lamp; 2. Press the SET button with tire pressure gauge logo on the right side of the front of the gear lever for a long time; 3. Press the tire pressure monitoring button until the light goes out; 4. Set by multi-function steering wheel; 5. Use a computer detector to reset and eliminate; 6. With the ignition switch turned on, press and hold the button in the upper left corner of the passenger glove compartment until the tire pressure light goes out. The effects of high tire pressure are:

1. High tire pressure will increase the friction between the tire and the ground; 2. Reduce the adhesion of tires, affecting the braking effect and driving comfort of the car; 3. Make the tire stop the oak smile pattern to accelerate the wear and reduce the life of the tire.

MG 5 common tire pressure monitoring equipment is blinded by the square in the middle of the dashboard in the driving computer. A lot of driving information is in this, but also on the center console, generally every time you plug in the key or ignition will be displayed in its corresponding position in the tire pressure monitoring device is a simple early state point of the tire pressure monitoring system, is the use of ABS ready-made sensing function to compare the number of rotations of the tire, the tire circumference of the tire with insufficient tire pressure also becomes shorter, so if one of the four tires is not enough, the number of rotations will be different from other tires when driving.

Tire pressure monitoring systemTire pressure monitoring system is a system that can automatically monitor various conditions of tires in real time and provide effective safety guarantee for driving.

MG 6 Fetal Pressure Monitoring Light Clearance Restoration is as follows: Shirt Notice.

1. First park the car in the garage or in a safe area to avoid danger.

2. Start the MG 6 vehicle, the central control screen will light up, and click the red box or the car selection button.

3. Find the red box selected "tire" on the central control screen and click to enter.

4. Click the "set" button selected in the red box to enter the next setting.

5. Click the "OK" button selected in the red box to enter the next step of settings.

6. Wait for the "tire pressure monitoring initialization" to be completed, and then the tire pressure fault light can be eliminated. Sail trembling.

There are three ways to deal with it: after a tire is fully hit, the fault light will be automatically eliminated after turning on the town for a period of time. Second, after making sure that the four tires are fully inflated, press and hold the shoulder of the car return, which is the arrow to the left, and the tire pressure light will be reset after holding it.

There is a button on the side of the third center console that is an exclamation point in parentheses, and it can be eliminated by pressing and holding it.

New MG 6 ( Price |The new MG 6 front grille adopts a dot matrix design, and the lower part of the grille is designed to be trapezoidal, and the side of the body adopts a double waistline design, and the upper waistline extends from the tail of the headlights to the rear door panel, and echoes the gently sliding roofline.

The new MG 6 adopts a wrap-around and biased design style on the side of the driver's seat, in which all the interior red and black contrasting designs are in line with the tastes of young consumer groups, while the details show the craftsmanship and refinement, but also make the vehicle full of grade, flat-bottomed multi-functional leather steering wheel, paddle shifters, electronic parking brakes, metal pedals and sports seat group chairs, etc., which all highlight the young and sporty characteristics of the new MG 6, and the large-size driving computer screen, inch central control screen, integrated Zebra Zhixing version system, The new round air conditioning vents and metallic knobs highlight the technological beauty and sophistication of the new MG 6.

MG 6 high-speed rail version is equipped with 360° panoramic image system, air purification system, cruise control, lumbar support, ** channel storage box system and other configuration functions.

Photo by Zeng Caihong) @2019

Summary. Hello, I am your exclusive technician, attentive, careful, dedicated to answering your car questions, for you to find the corresponding problem solutions and solutions! If this tire pressure fault can be lit, there are the following ways to eliminate it: 1. First of all, give him all four tires, and then look for the vehicle information in the vehicle settings to see if there is a tire pressure reset, 2. Conduct a road test, that is, drive the car out for 10 kilometers, and he will eliminate it himself3 Use the diagnostic computer for special function tire pressure matching can be eliminated, and you can try these three methods.

Dear, this question is up to me, it takes a little time to type, please be patient, thank you!

Hello, I am your exclusive technician, attentive, careful, dedicated to answering your car questions, for you to find the corresponding solutions and solutions to the problems of the cherry blossoms! If this tire pressure fault can be lit, there are the following ways to eliminate it: 1. First of all, give him all the four collapsed tires, and then find the vehicle information in the vehicle to see if there is a tire pressure reset, 2. Conduct a road test, that is, drive the car out for 10 kilometers, and he will eliminate it himself.3 Use the diagnostic computer for special function tire pressure matching can be eliminated, and you can try these three methods.

Check why the light is still on when the tire pressure is normal.

If there is no tire pressure reset, if the tire pressure is not reset, the light will always be on Tire pressure reset.

How? Just follow the three methods I used above, or you can run a road run for a dozen or so kilometers, and he'll get rid of the tire pressure himself.