-
The TV can be properly exposed to moisture, which can improve the condition of the TV, but it cannot be exposed to the sun.
When the TV is damp or has not been used for a long time, you can take it to a sunny place to dry it properly before using it again, and it is appropriate for 1-2 hours.
Televisions should not be exposed to the sun for the following reasons:
1. The electronic components inside the TV should not be exposed to the sun.
2. Exposure to the sun will cause the plastic of the TV shell to age prematurely.
3. Exposure to sunlight will shorten the life of the phosphor screen or LCD screen (the main component of the TV).
-
1. Cut off the power supply.
If the TV is unstable because of moisture, then you have to turn off the TV, and cut the power supply of the TV, and then use a tool to disassemble the shell of the TV, but it should be noted that if you can't dismantle it, then don't do it, please help someone who understands to dismantle it, and only dismantle the simple shell, and the things that are too precise inside can't move it. At this time, you can let the TV go to a dry and ventilated place and let it air dry naturally. After air drying, you can install the TV shell, and then turn on the TV**.
2. Air dry with a hair dryer.
After the TV is damp, you can disassemble the shell of the TV and use the hot air from the hair dryer to air dry the inside of the TV, which will help the drying speed of the TV to speed up, but when blowing the inside of the TV, the seal of the hair dryer should not be too close to the inside of the TV, so as to prevent the high temperature brought by the hair dryer or the parts of the hair dryer from touching the parts in the TV.
How to deal with the dampness of the TV.
3. The TV tube socket is damp.
Sometimes after the TV is damp,Everyone will think that the image of the TV is damp,In fact, this is a wrong understanding,If the TV is normally damp,Then the picture tube is basically no problem,It may be that the tube socket in the TV is damp,If the tube socket is damp,Then you have to change the TV tube base,Or let the tube seat air dry。
4. Find professional maintenance personnel.
If the TV is seriously damp, at this time, it is necessary to ask professional maintenance personnel, open the shell, replace the high-voltage cap in the TV or the place that is easy to ignite, and when the TV image caused by the TV is damp, there are snowflakes and abnormal colors, you should find the manufacturer of the TV for inspection, do not find an amateur small maintenance worker, so as not to repair the TV.
-
Not good. The computer is rusty after too much sunburning. It is recommended that you take it to someone else for repair. Isn't there a warranty?
-
It doesn't work, it's better to turn on the TV and let the user use a hair dryer to deal with the damp parts.
-
Yes, but the monitor can't be exposed to sunlight for a long time, so it is recommended that you use a hair dryer to dry it!
-
It cannot be sunburned.
Because the electronic components cannot be exposed to the sun, the plastic of the TV shell will age prematurely, and on the other hand, it will also shorten the life of the screen.
If there is no other light source in the room, the brightness of the TV screen is in strong contrast with the contrast of the surrounding environment, and this height contrast will make it difficult to adapt to vision and cause eye fatigue.
Over time, it will induce various eye diseases that affect vision. Therefore, when watching TV, the lighting equipment in the room must be turned on again, and the brightness of other light sources should be at least as bright as the newspaper can be seen clearly.
Daily maintenance: If the TV is not used properly, it will affect the life of the TV.
Pay attention to the influence of geomagnetism. The phosphor screen of the large-screen color TV should be placed facing south or north, so that the direction of the earth's magnetic field is consistent with the direction of the electron beam in the picture tube, so as to prevent the geomagnetism from affecting the color purity.
Pay attention to ventilation and heat dissipation. When using a large-screen color TV, do not cover it with plastic sheeting, cloth covers, etc., and do not pad foam plastic at the bottom, so as not to affect the ventilation and heat dissipation of the color TV.
Pay attention to color and volume. The color, volume, and contrast of large-screen color TVs should be appropriate, so that not only the best effect is good, but also power saving, and it can also extend the life of the TV.
-
That is not good for the screen and affects the service life.
-
You can't see the high temperature, isn't the TV case marked with sun protection?
-
It is not recommended to leave the TV in direct sunlight as prolonged exposure to strong sunlight can negatively affect the TV.
This is because the ultraviolet and infrared cavities in sunlight can corrode the flickering lenses on the surface of the TV screen. Over time, these injuries can cause the screen to turn yellow, blurry, brittle, and more.
The strong sunlight change will also cause the temperature of the internal components of the TV to rise, and prolonged high temperatures may cause the circuit board to deform or shorten its life.
-
The brightness and color vibrancy of the TV screen are greatly affected by the light, and proper sunlight exposure can improve the brightness and color vibrancy of the TV screen. However, if the sunlight is too strong or lasts too long, it will have a negative impact on the TV screen and even damage the TV. So, although the TV set can bask in the sun under the right circumstances, it is important to pay attention to the mastery of time and intensity to avoid unnecessary losses.
-
It is best not to expose the TV to the sun of the rock, because the TV has a variety of electronic products inside, and some electronic products are afraid of high temperatures, and electronic components may be injured under high temperature conditions. Wu Gao, so try not to be exposed to the sun for a long time.
-
In winter, the sun TV can bask in the sun. It can be properly sunned,But not exposed,When the TV has not been used for a long time,When you use it again, you can first take it to a sunny place to dry properly,1-2 hours appropriate。 The reason why the TV can not be exposed to the sun is that the electronic components inside the TV can not be exposed, the exposure will make the plastic of the TV shell prematurely age, and the exposure will shorten the life of the phosphor screen or LCD screen (the main component of the TV).
How to maintain your TV in winterThe weather is cold in winter,Household heaters increase,If you let the TV close to these heat sources or even directly face the heat source,It is easy to cause the temperature difference between the two sides of the TV to be too high,Qin Xian At this time, the current and voltage will be unbalanced,And the higher the temperature,The shorter the life of the LCD screen。 Therefore, do not place the TV near a heat source.
In addition to being afraid of heat, LCD TVs are afraid of moisture, and the electronic devices inside LCD TVs have high requirements for humidity, and when the humidity is too high, some components will not work, and even sometimes the inside of the TV will condense. When the ambient humidity is large, the LCD TV screen can drive away the water vapor through its own heating after being energized, so when encountering rainy weather, it is best to use the TV for half an hour every day, if you do not use it for a long time, it is best to seal the TV with a plastic bag.
In 1906, the Scottish young Baird set up a humble laboratory with the intention of making a television set. After more than ten years of hard work, in 1925 he finally built the world's most primitive television camera and receiver from waste materials such as old radio equipment, old sugar boxes, bicycle lamp lenses and old wires. In the trial, images are displayed on a phosphor screen. >>>More
Now Chinese TVs are all 4:3 signals, LCD TVs are basically 16:9 (non-19; 9), LCD TV can **4: >>>More
The TV with wifi function is usually a network TV, so it can be connected to the wifi Internet or ** network TV program; Here's how: >>>More
The fault is caused by the leakage of the buttons on the panel, but it is difficult to say that it is the button, it is best to replace all the buttons. Because**TV buttons are mostly voltage matrix type,Each button will be separated from the array of different voltages,When the key has a contact resistance value or a leakage resistance value,There will be a messy voltage in the matrix,It will function"Disordered",The machine will operate automatically,It's good to replace all the buttons。 It doesn't take much money to wish you good luck.
It does not affect, the TV is used for national security, and the network is used for telecommunications. >>>More