Ben 4 dual core CPU temperature is more than 90 degrees, and it will automatically shut down when pl

As you say, it's like a ventilation problem, but I suggest you:

1. Check the heat dissipation parts, especially the thermally conductive silicone.

2. Check the system to see if there are too many background programs in the system, such as Trojans or something.

3. Check the hardware settings: If it's overclocked, it's definitely hot.

4. After checking it and still not improving, I have to work heat dissipation. It is recommended to replace a good heatsink and fan.

CPU heatsink and fan are not easy to use... At 90 degrees, you can fry eggs! Hurry up and check it out, or you won't play with the computer, and it should be a frying pan!

It's not recommended that you turn it on again.,It's obvious that you're having a problem with the CPU fan.,P4Dual-core is originally high in heat.,If there's no good fan to dissipate heat for it.,It's going to turn off automatically.,Burn the CPU at worst.。 Hurry up and change the fan of the CPU.

It's time to change the power fan, you touch the back of the case with your hand, is it very hot If it's hot, quickly change the power supply.

Let's correct it first.,Ben 4 doesn't have a dual core.,Yours should be Ben D.

The heat of Ben D is very strong, more than 80 degrees is not unusual, if you don't want to change you and want the temperature to come down, buy a better radiator.

There is not enough silicone between the cooling fan!! There is a high possibility of a new setup!!

2.There are viruses in the system, and many viruses running on your computer will take up the CPU

3.There are too many software to run on the boot!

Is the CPU fan still spinning or is it the graphics card fan.

It is recommended to dust the CPU fan.

Usually the problem is 34°, but it will overheat, and there is the following possibility:

1. Check if the CPU fan clip is good. (If the clip is not good, it is still particular about falling down, you are bound to stand up as soon as you put on the cover, and the fan will fall off due to the influence of gravity, and it will be separated from the CPU, which is equivalent to not dissipating heat, but it will have the opposite effect and block the air duct).

2. See if the silicone is beaten too much (if it is counterproductive, hey Cha Lu Chun, it is enough to wipe a little properly).

3. If the fan is noisy and uneven, it means that the fan is dying, if you want to insist on using it, it is recommended to point oil to the fan movement, sometimes it can be seen immediately.

Hope it helps.

Install a master Lu to monitor the temperature, if it shows that the CPU stability is too high, just look at whether the CPU and the heat sink are in complete contact, if there is complete contact and a uniform silica gel vertical ridge, then change the CPU fan, replace this problem, it is estimated that the problem may be on the motherboard, after all, the software detection temperature is not accurate and there may be false alarms, heating and ruining the big part.