-
Set the laptop's NIC option IPv4 to automatically get the IP automatically if it doesn't work, you can try:
1.If your operating system is XP, there will be some networks that are not recognized, you can use the driver life to upgrade the driver of the Ethernet controller to the latest one. I've had this issue before, and it's not very clear as to why.
2.If you're using Vista, remove IPv6, and there's a power-saving option inside the network card, remove this as well. You can also try to upgrade the driver of the network card and use it to drive life. Not on the official website.
This is the problem that occurred when I used the 6530, and I solved it this way.
Finally, it's a problem with the system... Let's reinstall this.。。。
-
If the network is not recognized, it may be that the IP address you set is not on the same network segment as the IP address of the router, so you can simply change the IP address to automatically obtain it. Or you can directly use the dos command window on your desktop to enter ipconfig all to check the IP automatically obtained by your desktop, and then set the correct IP, gateway, and DNS with reference to the IP address range of the desktop. The principle of the network is the same, and it has nothing to do with where you buy your laptop, even if it is Japanese or American.
-
Maybe the driver is gone! The next one is fine!
-
Dear users, if there is a switch, be sure to see if there is a problem with the switch, and often change the LAN regional environment.
My problem is with the switch.
A friend's pants lift inspired me to say that it was very good that I solved this problem by doing so.
You can take a look, if there is any problem, you can add 48503735qq contact.
To use the Internet through ADSL, to put it simply, first configure the local connection, the local connection is connected, and then set the broadband connection to one.
Next, step by step.
Put the local connection noisy as an attribute out, there are two protocols in it, one IPv6, one IPv4, and put the hook in front of IPv6.
Remove it, and then define the IP address in IPv4, don't use automatic.
dns: At Start-Run-Enter cmd-ipconfig all, find the data and fill in, and the local connection is specified.
Establish a broadband connection, and then take a look at the properties, there are also the same protocols v6 and v4 in it, and don't use the v6 dry boy, v4 doesn't move, ok, you can go online. I hope mine can help you get back online.
-
Make sure your network cable is plugged into other computers to access the Internet normally, reinstall the network card driver, run 360 to repair the system, repair the network, if it still doesn't work, it is recommended to reinstall the system! Happy use.
-
Go to the after-sales service to see, you should be able to ask for a replacement.
-
First of all, there must be the presence of wireless networks.
Second, your Acer wireless device needs to be turned on.
Wireless device on: My computer right-click Properties Device Manager Network adapter Wireless right-click to turn on, and the shortcut keys on your keyboard should also be turned on.
Good luck.
-
The laptop system can be connected after it is just installed, but it cannot be connected to the ,.. after installing the 360 Guard for computer experienceThat is to say, first make a wireless connection with the router, this has nothing to do with the network, connect the router and then.
-
I can't connect even after the computer restarts.
-
Acer 4741G can't connect to the network, it can't be installed from the system, and the network card driver can't connect to the network from the installation! Every time I connect, 651 appears, the network is also on, and the signal light is also on, but the connection is not on the Internet!
-
1. Use a fixed IP address and fix the DNS address. The time interval between the 2 wireless routers and the laptop is too much wall. 1-2 on the wall. As shown in Figure 3? It doesn't work with wired.
-
Don't blame the computer for being a problem with the wireless router.
-
I have the same problem as you, have you solved it?
-
Acer China's official photograph Yuanshi network under the attack limb cavity pulse, address.
-
Is it asking how to turn on Bluetooth? fn+f3
First of all, you have to modify the registry, and if you don't change the BIOS, it will be a blue screen! >>>More
It's likely that you're too anxious to log in to QQ before the boot loader is completed, QQ has a bata version, the performance is very unstable, I have had a LZ situation before, only uninstall, reinstall the system so that you can purify the system, you don't want to install the system, you can use the 360 first aid kit to give first aid, and then use 360 boot start item management, prohibit the need to start, but the best thing is to restore the system, that can be completely solved. If there is still a problem, it may be a hardware problem, such as too much dust in the cooling fan (this needs to be disassembled and cleaned, it is best not to get it yourself, please ask for after-sales help) I hope LZ can solve the problem as soon as possible and surf the Internet happily
The landlord said very abstract Oh,You say the notebook is good or bad,10000 yuan is definitely better than 5000 yuan,In fact, it's really good or not, first of all, it depends on whether the book meets your requirements,Then look at how cost-effective it is,If both are suitable, you can pay to take it home。 I don't know what performance machine you want,But here is a model recommended to you,Netbook V200,It's cost-effective is not said,You can refer to it,V200The specific performance is as follows: >>>More
This question is not really a problem.
Because the ** in various places is not so much the same. >>>More
Have you tried changing the network cable?
Have you tried changing your computer? >>>More