Can the gloss be brightened by waxing if the gloss is not enough after the car is refilled?

Hello, normal general car gas, in the future, the normal brightness is not bright enough, if the normal way of waxing is normal, it is not able to improve the brightness, the normal is mainly the varnish of spray paint.

There are two possible reasons for this: one is that the car wax is not right, and the other is the wrong way to wax.

How to choose the right car wax:

1. It is best to use glazing wax to protect the gloss and color of the car body.

2. It is best to use ordinary pearl or metallic paint series wax for ordinary vehicles.

3. In summer, it is advisable to use anti-ultraviolet car wax.

4. When the driving environment is poor, the casein wax with outstanding protective effect should be applied.

5. Black, red and green series of wax are used for dark paint.

6. Light-colored car paint is silver, white and pearl series car wax.

How to wax properly:

Waxing is best done when the body is cool, and it must be done after the body has been washed, and the waxing sequence is the same as that of the car wash, which is also carried out from the body to the bottom of the body. In addition, the direction of holding the sponge to push the wax is not the arc method in the traditional concept, but the position of 90 degrees relative to the direction of travel of the car. Pay attention to the delicate areas when waxing, these areas can be waxed with milky or liquid wax, or waxed with a spray brush.

As for the wheels, rims and other parts, try to use special wax. In order to make daily waxing easier and more efficient, consider using Fengjinba's small waxing machine P300 for waxing maintenance, which is easy to operate and has a good waxing effect.

Coating can be considered. Waxing holds for a short time.

Ordinary car care - waxing, polishing, glazing, although it can increase a certain brightness, but it will bring ***. Car wax itself is a soft substance that can be easily lost, which means that wax is largely ineffective when the paint surface needs protection the most. In addition, because any car wax contains silicone, long-term ultraviolet exposure will rust the car paint, leaving a little black spots, especially the abrasive particles in the car wax will form vortex hair scratches on the shiny paint surface, just after waxing, these scratches can be temporarily covered by wax, but the wax will be lost due to temperature changes and car washing, showing a paint surface full of scratches, so you have to continue waxing until polishing.

The damage to the transparent paint layer is even greater after polishing, generally after 3 times of polishing, the transparent paint layer will be removed, thereby accelerating the aging of the car!

In addition, polishing, glaze is easy to thin the car paint, because the glaze must first be polished, grinding, and then sealed at least twice with the glaze sealing machine, although it felt brighter at the time, but due to the strong cutting force of tools and rough wax, it is easy to form deep vortex scratches and destroy the car paint, the popular foreign paint coating products are loved by many car friends as soon as they enter China, because it represents the trend of the development of car care products, and adapts to the market demand for improving the quality of car care.

with pure eco-friendly materials"Mirror coating"In comparison, car wax and car glaze, which are not environmentally friendly and have a choking smell when used"Congenital defects"That is, the main components of car wax and car glaze are a kind of oxidized grease extracted from petroleum, and the surface of the paint will become dark and dark after a long time"Mirror coating"It can be shelved for more than two years.

The principle of coating is the same as that of image sealing, which will not cause any damage to the car paint, and adds a layer of bright, high-hardness protective film.

That's because waxing will oxidize the car paint, the color of the oxidized car paint will be darker and darker, and there will be small black pits on the paint surface!!

During the waxing process, the car paint needs to be polished, which is a damage to the car paint. So, new cars don't have to be waxed. The car has been driving for a long time and the paint surface is black, so you should consider waxing.

It needs to be simply polished before waxing, and if it is thrown frequently, it will definitely have a certain impact on the paint surface! If you wax up, you want to wear makeup, and if you wear makeup often and then remove it, it will definitely be ugly.

The coating is expensive and can be guaranteed for about a year.

In addition, it can also effectively increase the hardness of the paint surface, resist the generation of small scratches, form a protective layer on the paint surface, and prevent the damage of gum, asphalt and other stains to the paint surface, which generally lasts for more than one year.

If the car polishing wax wants to shine, it can be used in the following ways: 1. The direction of rotation of the polishing wheel is towards yourself, and you have gained enough speed. Gently place the polishing wax against the edge of the wheel and make sure to be below the horizontal plane of the rotating shaft until the surface is covered with wax;

2. Turn the wheels towards you and run at full speed. Use polishing wax against the rim of the wheel for a few seconds to make the wax adhere to the wheel. Hold the workpiece lightly against the wheel surface, and make sure that the workpiece is under the water eggplant residue plane of the wheel center shaft, otherwise the wheel may throw the workpiece out of the hand;

3. Use a clean piece of metal to gently lean on the surface of the wheel beam for a second to make wax. Repeat several times so that the wax evenly covers the surface. Once the surface is completely covered with wax, the polishing process can proceed. If necessary, it can be re-coated with polishing wax on the wheel;

4. The wheels used for coarse polishing, medium polishing and fine polishing should be separated, and they must be separated, otherwise the surface will be scratched by rough particles during the glazing process. When the workpiece enters the fine polishing process, do not have rough particles left in the wheel, otherwise scratches will occur. When polishing is completed, wipe the surface of the workpiece with a soft cloth stained with talcum powder to remove the wax, and if necessary, dewax the dusty workpiece.

Millions of car purchase subsidies.

Many people feel that the body is dull after buying a car, and expect to make the car glow by waxing, but in fact, the following precautions will damage the car paint if you don't pay attention to it:

Don't wax your new car casually. There is no need to rush to wax a new car within five months of buying it back, because premature waxing will remove the original wax on the surface of the new car, resulting in unnecessary waste.

Master the waxing frequency. Due to the different environments and parking places of the vehicles, the time interval of waxing should also be different. Generally, there is a garage parked and waxed every 3-4 months; For vehicles parked in the open air, it is best to wax every 2-3 months due to wind and rain.

It is best to wash the dirt and dust on the exterior of the car body with car wash water before waxing. Remember not to blindly use dish soap and soapy water, as sodium chloride will erode the body paint, wax film and rubber parts, causing the paint to lose its luster and the rubber parts to deteriorate. If there is no special car wash water, you can use clean water to wash the vehicle, wipe the car body dry and then wax.

The car should be waxed in a cool place to ensure that the body does not heat up. With the increase of temperature, the adhesion of the wax becomes poor, which will affect the quality of waxing.

When waxing, apply an appropriate amount of car wax to the sponge block, and apply it in a straight line on the car body, and do not pour the wax liquid on the car or do circle painting; A job should be completed continuously, and the coating should not be stopped; After the wax layer is evenly applied, polish it with a new towel, and the fast wax should be polished while applying.

After the body is waxed, some wax will remain in the gaps in the lights, license plates, doors and luggage compartments, etc., making the body look very unsightly. If the wax dirt in these areas is not wiped off in time, it can also cause rust. Therefore, it is necessary to completely remove the wax scale after waxing, so as to get a perfect waxing effect.

Do you take a look at the waxing of your car and pay attention to these conditions?