How to install an air conditioner, how to install an air conditioner

During the installation of air conditioners.

Here are some basic steps to install an air conditioner:

Choosing an air conditioner: Choose the type and brand of air conditioner that is suitable for the room size and purpose.

Determine the installation location: Choose a location close to the power supply and drain to avoid direct sunlight and vibration.

Mounting bracket: Select the appropriate bracket according to the air conditioner model and wall material, chant the installation level and fix it.

Install the outdoor unit: According to the model and installation location of the air conditioner, select the appropriate outdoor unit installation location and fix it.

Install the VTH: Make a hole in the installation position of the VTH, pass through the wires and drains, and install the VTH on the bracket.

Connect the pipes and power supply: Connect the refrigeration pipes and power cords of the indoor unit and the outdoor unit, taking care not to bend or twist the pipes.

Drainage pipe: Connect the drainage pipe of the indoor unit to the drainage outlet to ensure that the drainage pipe is unblocked.

Test and commissioning: After the installation is completed, test and debug are carried out to ensure that the refrigeration macroridge and heating function of the air conditioner are normal.

The steps for installing the air conditioner are as follows: Wheel Quiet.

Determine the position of the pipe: according to the installation position and pipeline direction, use the saw blade to knock out the hole of the indoor unit and open it; If the direction of the outlet of the pipe is inconsistent with the pre-installed direction, it needs to be adjusted.

Docking copper pipe: The center line of the wax slag of the docking copper pipe is located on a line, and the hail draft nut is twisted by hand until it cannot be rotated, and then twisted with a wrench.

Inspect-Butt-Wrap the Drain: Check whether the root of the drain is loose, the drain and blow molded drain must be butted in place and wrapped more than twice with tape.

Bandaging pipeline: evenly bandage, and ensure that the water pipe cannot be twisted or wound during the bandaging process.

Install the wall mounting board: use a spirit level to measure, otherwise it may cause water leakage in the air conditioner, pay attention to safety when drilling.

Hanging the indoor unit: ensure that the buckles of the indoor unit are installed in place, and verify the stability after hanging.

I hope the above information is helpful to you, if you still have questions about home improvement need to consult, you can go to Luban to your home.

1.The first step in installing the air conditioner is to take over, and the takeover should pay attention to the applied force, if the strength is not enough, the gas will leak, and then affect the cooling effect of the air conditioner.

2.When emptying, the three-way valve needs to be closed, so that the compressor of the external unit can connect the fluorine and pipes of the internal unit to the opening hall of the external unit, and then close the three-way valve.

3.The installation of the wall panel needs to focus on the level, and the horizontal height of the drainage pipe of the inner machine should be equal to or only higher than the height through the center of the wall hole, otherwise it will cause indoor dripping.

4.After the air conditioner is installed, it needs to be commissioned, and the air conditioner can operate normally that the installation is successful.

Li Zaomeng concluded.

1.The first step in installing an air conditioner is to take over.

2.When emptying, the three-way valve needs to be closed.

3.The installation of wall panels needs to focus on the level.

4.After installing the air conditioner, it needs to be commissioned.