How to make the wireless network not limited by the speed of the host

I also have this problem today I consulted my college classmates Haha Just click on the right mouse and select My Computer Hardware Click Device Manager After that, select Network Adapter and find the network card. Disable and enable "Shutdown and re-enable after disabling" on the pop-up right-click menu, please give points and good luck (o).

Unless you control the main route, you can remove the speed limit yourself, so let's be honest.

PS: Buy yourself a wireless network card, who can limit you! Otherwise, they will coerce and lure your network administrators.

I'll admit I didn't quite understand what you said. Can you be more detailed? Is your computer hosting restricting your wireless network?

Hehe, now I understand. Think about it, you are in the unit and not at home. There will definitely be a limit to his routing configuration. As for cracking, this is a hardware setup, and then implemented on the software. Crack.. Don't think about it.

Unless you can go to the router settings page... If you can't do it... You can only do one network by yourself.

How much money did you pay to someone? Still so greedy. If you don't want to have any obstacles, it is recommended that you pull the line yourself.

Because your internet speed must go through your landlord's router, you can only start with the router and LAN broadcasts.

Method 1: Start with the router.

Since your network cable is connected to the landlord's Najuxiang router, you can open the router login interface by typing "or" in your browser, see what the brand and model of the router are, and then log in with the default password of the router, and change the IP address that limits the network speed after logging in successfully.

Method 2: Spoofing for LAN broadcasts.

You can use software such as P2P Terminator to limit the Internet speed of all room rushers to improve your Internet speed by grabbing the Internet speed, which is commonly known as "ARP spoofing". **After the software, run the software, go in to configure your own IP address, subnet mask, MAC address and gateway address, this information can be seen in the details of the network connection, after the configuration is completed, and then check the Changbo host you want to speed up and click "Start Acceleration".

2. Enter the correct username and password to enter the router management background.

3. We need to check the existing IP and the corresponding MAC address bar first. Click "DHCP Server" on the left, select "Client List", and write down the corresponding IP and MAC addresses displayed on the right.

5. Enter the correct corresponding MAC and IP address on the right, then select "Status" as "Effective", and then click the "Save" button to save.

6. Repeat the previous two steps until all IPs are added.

7. Click the "IP Bandwidth Control" link on the left, check the "Enable IP Bandwidth Control" checkbox on the right, and select the correct network speed below.

8. Fill in the IP and bandwidth size to be controlled in the following rules, and also set your own computer "Guarantee minimum bandwidth", and select "Enable" for all.

9. Click the "Save" button to save all the settings.

Serial number? Just know its MAC address, specify its MAC address to an IP and then limit the rate of this IP, and it's OK.