The system recognizes the drive, but it can t turn on 50

Landlord, you can try this.

Many antiviruses have a start-up antivirus function.

For example, Rising. Set up the antivirus software first, that is, turn on the boot antivirus (you had better upgrade the virus database to the latest version).

Plug in the hard drive when the computer is turned off, and then start the computer.

Don't assume that you have to plug it in when your computer is turned on.

It can already be loaded when the hardware is tested at boot (of course, the mobile hard disk must be connected to the computer).

Since you can't right-click the menu.

Press F8 after POST

Format in the command prompt.

Syntax: format drive letter:

Try the interface in the back, and the power supply may be insufficient.

I guess it's a virus. It's not like there is not enough power.

The hard drive has reached menopause, Amen! Hurry up and back up your data If you really can't take it to the data recovery center, but the fee is quite expensive, Amitabha!

Virus, direct antivirus.

Or set your file properties to display and see if the virus files you delete directly.

Summary. Dear, glad to answer for you. The hard disk in which this happens is largely caused by the presence of bad sectors.

It is more common to have a mobile hard drive such as a drop or a forced pull. If the hard drive doesn't have any important data. Consider doing a low-level formatting look.

Then proceed in Disk Management, partition formatting. If there is a warranty. Warranty Processing.

If there is data that needs to be recovered. Be sure not to repartition, format, or anything like that. In that case, the recovered data is incomplete.

Maintain the status quo. To a large extent, the original data can be completely restored with proper analysis and processing. Without the need for data recovery software to scan the recovery.

If you want to try the recovery yourself, refer to scanning the recovery with data recovery software, and remember not to write the found files to the hard drive where the problem occurred. Instead, you should restore the found data to a different hard drive first. Make sure that the partition is correct before processing the problematic partition.

Dear, glad to answer for you. The hard disk in which this happens is largely caused by the presence of bad sectors. It is more common to have a mobile hard drive such as a drop or a forced pull.

If the hard drive doesn't have any important data. Consider doing a low-selling tassel level formatting to take a look. Then Disk Management proceeds to the partition family bridge formatting.

If there is a warranty. Repair treatment in the middle of the year. If there is data that needs to be recovered.

Be sure not to repartition, format, or anything like that. In that case, the recovered data is incomplete. Maintain the status quo.

To a large extent, the original data can be completely restored with proper analysis and processing. Without the need for data recovery software to scan the recovery. If you want to try the recovery yourself, refer to scanning the recovery with data recovery software, and remember not to write the found files to the hard drive where the problem occurred.

Instead, you should restore the found data to a different hard drive first. Make sure that the partition is correct before processing the problematic partition.

Teacher, what's going on?

Dear,If the mobile hard disk can't be opened, it may be because the interface of the hard disk is damaged,This situation will be repaired,But it may also be because the driver in the computer is damaged,We only need to repair the driver through the software,If the hard disk is damaged,I have to repair the stool,The repair is actually very simple,We directly open the hard disk to clean up and then repair it。

Dear, how to repair the driver: 1. First, right-click on the desktop and click "Manage". 2. Click "Services & Applications" on the left side of the old scum.

3. Click "Service" in the drop-down to wait. 4. Find "wired autoconfig" and right-click and select "start". 5. In the pop-up interface, click Start and OK.

6. Find the "WLAN Autoconfig" sock and double-click to open it. 7. Finally, click Start and then confirm.