How to make fire for survival in the wild, is it feasible to drill wood for fire?

I just looked this up.

If you really find a way to drill wood to make a fire without burning a fire, it is feasible.

Here's how: First, find the right wood for drill boards, dry poplars, willows, etc. will be a good choice because of their softer texture. Then find a suitable branch to make a drill bit, which is relatively hard, and the conditions are not as harsh as the drill plate.

Then, drill the edge of the drill plate into a small inverted "V" shaped groove.

Finally, put a flammable velvet or dead leaf under the drill plate and drill vigorously with both hands until the fire is drilled.

Originally, I didn't understand what the V-shaped slot meant, but if I recommend it to you, you'll know what it's all about.

That's it, it's easy to understand!

In addition to drilling wood, you can also use flint and steel.

If you drill wood, the first thing to do is to find flammable fire-starters: such as dead grass, dry leaves, birch bark, pine needles, pine resin, fine branches, etc

Paper, cotton, etc.

The second is to pick up firewood: choose dry, undecayed trunks or branches for dry firewood. It is necessary to choose pine and oak as much as possible.

Hardwoods such as trees, oaks, birches, locust trees, mountain cherries, and apricots burn for a long time, have large fires, and have a lot of charcoal. No.

It is necessary to pick up firewood close to the ground, which is humid and not easy to burn, and has smoked a lot.

The next step is to clear a cleared area that is sheltered from the wind, flat, away from dry grass and firewood. Place the ignition in the middle, lightly place a thin pine branch or thin dry firewood on it, and then set up a larger and longer firewood, and then light the ignition material. The setting of the fire.

It can be designed into cone-shaped, star-shaped, "and" Ning shape, side-by-side shape, roof shape, pasture shape and so on. Also.

You can use stones to prop up dry firewood or under the rock wall, lean the dry firewood on the rock wall, place a fire starter underneath and light it.

Can. In general, dig a pit with a diameter of about 1 meter and a depth of about 30 cm in a sheltered place. If the ground is hard you can't.

You can also dig a pit and find some stones to form a circle, the size of the circle depends on the size of the fire. Then place the ignition on.

In the middle of the circle, after putting some dry firewood on it, light the person to light the dry firewood to form a bonfire. If the ignition is about to burn out, it will dry.

If the firewood has not yet been ignited, it should continue to add fire-inducing materials from the gaps in the dry firewood until the dry firewood is burned, and not again.

Re-set the firewood and light the fire.

There is no skill in drilling wood, only speed and endurance.

Generally, you will bring a few lighters to survive in the wild, and I personally think that it is more reliable to use a grinding wheel to light. There are also matches with moisture-proof matches, as well as a fire stick (magnesium block), which are not as convenient as lighters. It is also possible to drill wood for fire, and it requires a certain amount of skill.

Wilderness survival skills: drill wood for fire.

Drilling wood in the field to make fire is as follows:

1. Retain the fire method.

This method will only be used on the basis of fire, and it will evolve into the modern fire fold in the later period. The classic method of fire retention in the cave era, whether it is using drilled wood for fire or any other method, requires an appropriate medium to cooperate with the combustion of fire. When the surrounding environment is very humid, it is difficult for the general material to ignite.

2. Flint fire method.

The flint is topped with flammable velvet or charred cloth, and the blow burns. There is one thing to note here: the more angular the stone is against the flint, the better, when the edge of a hard stone is too smooth, you need to break it on the boulder, so that the jujube can show sharp edges.

Essential Tools for Survival in the Wild:

Outdoor knives, professional knives specially used in outdoor sports, can be roughly divided into portable multi-functional knives and jungle survival knives. A sturdy knife is an essential tool necessary for building shelter, preparing food, making fires, and countless other tasks.

Gas lighters, butane lighters have high combustion intensity, and gas lighters are lighters that use gas as the raw material for ignition, and they should always keep the fuselage with gas storage. Gas lighters are fueled with butane gas.

Ordinary disposable lighters are generally filled with butane. Use a lighter and some flammable materials to help you make a fire. Cotton balls coated in wax and a small bottle of Bacardi rum are both viable options.

The methods of fire in the field are drilling wood to make fire, convex lens to make fire, concave mirror to make fire, and battery to make fire.

1. Drilling wood for fire

The use of friction to generate heat is the most primitive and the easiest way to obtain raw materials. Here we first need to find sticks (branches), wood, hay and dry leaves in the wild, so that we can turn the sticks directly with our hands so that they rub against the contact ground to generate heat, so that the dry leaves and other flammable materials can catch fire. However, this method takes a long time to turn, and it is easy to have hand pain.

2. Convex lens ignition method

The convex lens is what we call a magnifying glass in our daily life, and using a magnifying glass to make fire is a well-known way in daily life. The convex lens is an optical element with a thick middle and a thin void on both sides, which has a converging effect on light. When sunlight hits a convex lens directly, the refracted light on the other side of it will focus at a point called the focal point, which is the highest temperature.

Prolonged exposure to the focal point will cause a very high temperature.

3. Concave mirror ignition method

The convex lens in the lens can be used to make fire, and the concave mirror in the mask can also play the same role. When sunlight parallel to the front cavity of the optical axis shines in, the concave mirror concentrates the light on the focal point in front of the mirror through reflection, and the temperature rises there.

4. Battery ignition method

In physics, we know that when a power supply is short-circuited, the current in the circuit becomes very large, and the resistance present in the circuit generates heat, and we can use this heat to make a fire. In fact, the principle is that electrical energy is converted into internal energy. We only need a battery, and then we can find an object that can conduct electricity as a wire to connect the positive and negative poles of the power supply, and we can generate heat.

There are many ways to survive in the wild to make fire, and the most classic and easiest to do is to drill wood to make fire. However, the process of drilling wood for fire is very difficult, because we need to find the right wood and have to be patient. Use two pieces of wood, one flat on the ground, and the other in your hand to hold the wood in your hand as a drill, and rub it against the flat wood on the ground to generate enough heat to make the wood burn.

01 Of course, in addition to drilling wood for fire, we can also use flint to make fire in the wild, and it is best to find two pebbles or other stones with smooth surfaces, and then find some hay. By igniting the hay with a spark from two stones striking each other, you can also get a source of fire.

02 Another method is also more common, if we are in the field and we have glasses with us, we can use the principle of convex lens. Use your glasses as a magnifying glass, and find some flammable hay or branches to get a source of fire by shining it with sunlight.

03 In addition, when we already have a fire source, we can use the hay around us to make a simple fire fold, so that we can ensure that we can use it anytime and anywhere when we need a fire source.

04 Finally, we can use nature to obtain a source of fire, for example, a source of fire that can be created by destroying trees with lightning. It can also be saved in the wild.

1. Lighter for fire.

The lighter stick is a highly effective flint made from a mixture of magnesium and other metals. As long as you bring a lighter stick, you can do almost any withered date situation without worrying about getting a fire.

2. Friction for fire.

The use of frictional heat to make a fire is one of the oldest methods of making a fire. Objects like the fire plough and the fire bow all make use of this principle.

3. A magnifying glass focuses on fire.

It's also a good idea to use a magnifying glass to focus light on fire. But a certain amount of patience is required. However, this method is affected by the weather. There has to be sunlight. And the more sunlight you have, the better. You can try to concentrate the light on the carbon cloth to see the effect!

4. Flint and carbon cloth.

Prepare some carbon cloth velvet in advance and put it in the survival box. Carbon cloth is a very flammable velvet that can be ignited by sparks from steel or gravel.

5. Batteries and thin wires.

The combination of battery and thin wire is an excellent device. When the positive and negative poles of the battery are connected with thin wires, the wires become hot and red, resulting in high temperatures. This temperature is enough to ignite the velvet.

In addition, the higher the battery voltage and current, the better it will be used. Generally, in the range of 3 12V, the higher the voltage, the better, and it is relatively safe.

Rattan for fire. Find a dry tree trunk, split it at one end, stretch the crack open, plug the tinder, use a rattan about two feet long, wear it behind the tinder, step on the trunk with both feet, and quickly twitch the rattan left and right to rub it and heat it and ignite the fire. In addition, two pieces of soft wood or bamboo can be rubbed against each other to make a fire, and the dry material at the bottom of the palm tree bark or coconut leaf can be used as a fire starter.

Bow drill for fire. Make a bow out of shoelaces, rope or leather with strong branches or pieces of bamboo, wrap a dry stick around the bow and use it to quickly spin on a small piece of hardwood. This will drill out black powder, and eventually, the powder will smoke and spark and ignite the fire.

It is best to choose wood chips and wood velvet for fire, as long as there are sparks, they can ignite quickly.

Because he who drilled wood for fire. The cost is relatively high. It takes a lot of physical strength.

The easiest way to make fire in the wild: bring a magnesium rod!

First, how do you make sure you can find wood that is absolutely dry? What if you're in the rainforest? Second, the physical energy consumed by drilling wood for fire is very large, and when you can get out of the fire, you are basically tired and lying down, but this is a big taboo for survival in the wild, and physical overdraft is equal to finding death, and third, drilling wood for fire requires enough patience and time, are you sure that when surviving in the wild, there will be no accidents around?

Because the success rate of drilling wood for fire is not high, and it is time-consuming and labor-intensive.

It's too strenuous, and there are a lot of wet wood to survive in the wild.

Drilling wood for fire is a waste of time and too much physical effort.

Because it is too laborious to drill wood for fire, you can use other methods if you can.

Because there are many better ways to do it, like with a magnifying glass or a telescope.

Survival in the wild requires physical strength, and saving physical strength is a good way.

Because this method is not efficient, it consumes physical strength.

Pee, you don't watch a lot of documentaries.

It's really difficult to light something with hay, so it's better to prepare some paper.